寬頻帶匹配 的英文怎麼說

中文拼音 [kuānbīndàipīpèi]
寬頻帶匹配 英文
broad-band matching
  • 頻 : Ⅰ形容詞（次數多） frequent Ⅱ副詞（屢次） frequently; repeatedly Ⅲ名詞1 [物理學] （物體每秒鐘振動...
  • 匹 : Ⅰ動詞（比得上; 相當; 相配） be equal to; be a match for Ⅱ形容詞（單獨） lone Ⅲ量詞1. （用於馬、騾等） 2. （用於整卷的綢或布）
  • 配 : Ⅰ動詞1 （兩性結合） join in marriage 2 （使動物交配） mate （animals） 3 （按適當的標準或比例加以...
  • 寬頻 : bisdn
  • 匹配 : 1. [書面語] （婚姻配合） mate; marry 2. [電學] matching
  1. Section ii describes the design approach and implementation of speech module on mcf5249 coldfire core. the speech codec optimizes g. 729a codes and added voice activity detection of g. 729b to save bandwidth ; the implementation of acoustic echo cancellation uses nlms algorithm and it can reduce echo though designing adaptive fir filter and speech detector ; the dtmf and cpt generate signal using two second order digital sinusoidal oscillators and detect signal by picking up the frequency information. but only get the frequency information is not enough in cpt detector, this thesis introduces a method

    其中對語音編解碼器的設計採用優化g . 729a代碼達到設計要求，並在此基礎上加入g . 729b的靜音檢測模塊，以進一步降低網路傳輸帶寬;對回聲消除器的設計採用nlms演算法，通過設計自適應fir濾波器和語音檢測器達到回聲消除目的;對雙音多頻設計，信號發生端採用構造靜態參數表並通過二階正弦振蕩器產生信號，信號檢測端提取頻率信息以檢測信號;對呼叫進程音設計，除了類似雙音多頻的信號發生及頻率檢測設計外，還需要檢測信號持續時間，作者設計了一種基於匹配狀態表的方法以檢測信號持續時間。
  2. The spot responder system which is the necessary part of ctcs is analyzed in the dissertation and three key technologies of the channel in the responder system are researched. firstly, a new kind of rectangular plate magnetic inductive loop antenna is designed to transmit the power frequency. researching the near field inter - inductive characters, the relationship among the inductive efficiency, the perimeter and the conductor width of the antenna is found out

    本文在對ctcs中的點式應答器系統原理及組成進行分析和消化的基礎上，對系統中通道的幾個關鍵技術進行了詳盡的研究，主要分為三個方面: 1 ，提出並研製了新型的片式環形磁感應天線，並對傳輸能量載波的天線的近場互感特性進行了分析，得到互感效率隨天線的周長大小以及導帶寬度的變化規律，並通過計算機模擬和試驗對天線的近場波瓣圖進行了研究;通過分析寬帶匹配技術中的實頻法理論，設計了信號載波天線的寬帶匹配網路。
  3. Theoretically several solutions are derived in the final scheme such as broadband matching technology which included negative - feedback technology, traveling wave technology and balance technology. in addition, the design will be optimized by eda software and the final test result indicates that our design is successful. the principle of microwave amplifier is introduced at first in this paper, especially its main parameters index sign, then the material performance and the influence of parasic parameter and model setting of the gaas phemt is discussed

    文中首先介紹寬頻帶放大器的主要參數指標，接著介紹了gaasfet的材料特性，以及phemt管芯寄生參數對實際放大器設計的影響，然後討論gaasphemt的大、小信號模型的建立與分類;結合gaasphemt模型和s埠參數分析了寬頻帶匹配技術的原理;最後論述本課題中各個放大器實現的具體方案，以及在放大器實現過程中應該注意的問題，給出了實際寬帶放大器的測試結果，並將軟體模擬結果與實測曲線進行對比。
  4. According to the radar - absorbing model, the performance of rams of various absorber - volume - percentage with various frequency and the radar obsorbing performance of which in various thickness is predicted. according to the radar - absorbing model, the prerequisites of microwave electromagnetic parameters and the border curves for a single - layer homogeneous absorbing coating backed by a perfectly conducting plate to produce zero specular reflection are obtained by the steffensen speedup approach to solve the complex transcendental equation

    以吸波模型為依據，用計算機求解了單層均勻各向同性吸波材料的阻抗匹配條件，通過數值模擬得到了吸波材料阻抗匹配時電磁參數邊界曲線的數值模擬等式和阻抗不匹配時寬帶吸波材料電磁參數的合理搭配規則和頻散特性。
  5. A 1 / 10 - scale model quasi - fractal rcl - loaded monopole antenna was fabricated and measured, which has a bandwidth ratio of about 10 : 1, with vswr less than 3. 0, calculated system gain greater than - 9. 4db and the efficiency above 14 %

    加入寬帶匹配網路后，對其10 : 1的縮比模型天線進行了測試，在全頻率段內駐波系數小於3 ，理論增益大於- 9 . 4db ，效率大於14 % 。
  6. When tested with two saw filters whose center frequencies are 155mhz and 163mhz respectively, the ic completed the summing function of input signals, while the 5db bandwidth expands by about 10mhz. and the variation of the matched impedance caused by the ic is small enough to be ignored

    在對中心頻率分別為155mhz和163mhz的聲表面波濾波器進行加權控制的測試中，該電路實現了信號的疊加功能，輸出信號的5db帶寬展寬約10mhz ，且電路引起阻抗匹配的變化小。
  7. This subject aim at designing a linear power amplifer whose output power is 40w for 225 - 450mhz band. but it seems not easy to finish the task because of this power amplifier own unique requirements including high output power, broad working frequency band, high linearity, and flat gain. due to the complexity involved, theoretically several soltuions are derived in the final scheme such as broadband matching technology, power - retreat, power synthesize, automatic power control and negative feedback. in addition, the design will be optimized by eda software and the final test result indicates that our design is successful

    本課題的目標是研製一個輸出功率為40w的225 450mhz的線性功率放大器。由於該功放要求輸出功率大，工作頻帶寬，帶內增益波動小，線性度高，所以其終合設計難度大。鑒于這個原因，在理論設計上筆者採用了寬帶匹配、功率合成、功率回退、負反饋、自動功率控制等技術；在實踐中精心設計電路，並且配合eda軟體模擬，最終達到所要求的指標。
  8. The vertical delay stacked source obtains optimum matching with wall rock by controlling the charge mode and the excitation velocity, and maximum utilizes its energy. thus the seismic signal with the high frequency abundance and frequency bandwidth wide be obtained

    垂直延遲迭加震源通過控制裝藥方式和控制炸藥速度來達到與圍巖的最佳匹配，最大限度的利用其激發的能量，激發出高頻成份豐富、頻帶寬、高頻能量高的地震信號。
  9. Broad band matching circuit

    寬頻帶匹配電路
  10. This paper studies the design methods and techniques of the broadband lna. using negative feedback techniques and lossy match method, a broadband lna acceptable for sdr is presented. the measured results showed that over 30mhz ~ 3000mhz, the lna achieved a maximum noise figure of 2. 0db, a power gain of 22db with gain flatness of less than 2. 0db

    本文最後對寬帶低噪聲放大器的設計方法進行了詳細探討，並運用負反饋技術和有損匹配的方法，研製了一種適合軟體無線電應用的寬帶低噪聲放大器，經測試，在30 3000mhz頻率范圍內，噪聲系數nf 2 . 0db ，增益g = 22db 2 . 0db 。
  11. However, in hf band, the band of the antennas is narrow, and the input impedance of monopole antenna with limited height undergoes rapid variation with frequency

    但是，在hf頻段，有限高無加載單極子天線帶寬相對較窄，輸入阻抗隨頻率劇烈變化，難于和50的同軸饋線匹配。
  12. Broadband source location method is investigated by using signal - phase - matching principle, and simulations and experiments are carried out to show the validity of the method ; two high resolution algorithms of broadband signals are proposed, which are the dft interpolation algorithm and the frequency invariant beam space algorithm. the proposed algorithms have no requirement for prior information of source locations, so the results of doa estimation can be unbiased ; a method of temporal - spatial averaging, which can improve the performance of doa estimation for uniform linear arrays, is given. this method can be applied in the most narrowband or broadband eigen - structure based high resolution algorithms

    提出了利用信號相位匹配法的寬帶信號方位估計方法並從模擬和實驗兩方面對其進行了驗證；提出了基於dft插值的和基於頻率不變響應波束域的兩種寬帶信號高分辨方位估計演算法，這兩種方法在進行方位估計時均不需要進行方位預估，從而避免了因角度預估可能帶來的估計偏差；最後提出了一種提高均勻線列陣方位估計性能的時空平均法，該方法可適用於多數窄帶或寬帶的特徵結構類高分辨方位估計演算法中。
  13. Its main characteristics include the following parts : ( 1 ) the trait of matching of network, as it manages the information of peers by grouping according to their location in the internet ; ( 2 ) easy to implement, as it distributes the video data according to the need of peers, and does not have to maintain a complex global structure ; ( 3 ) robust and resilient, as it can adapt the complex and dynamic environment of network very well ; ( 4 ) good expansibility, as it has better performance with the increase of users ; ( 5 ) high utilizing of bandwidth, as it can control the peers according to the change of bandwidth of them and make good use of their bandwidth ; ( 6 ) low delay of peer to peer, as it considers the delay among peers sufficiently besides the bandwidth, and makes the delay of peer to peer is low

    該視頻流媒體網路模型在網路帶寬效率、延遲和可靠性之間做出了很好的平衡，它的主要特點有: （ 1 ）網路匹配特性，使用終端用戶的網路位置信息來對節點進行分組管理，對節點間的鄰近度進行優化; （ 2 ）易於實現，根據數據的流向來分發視頻流媒體數據，不需要維護復雜的數據結構; （ 3 ）適應性強，能很好的適應復雜變化的網路環境; （ 4 ）擴展性好，加入視頻流媒體網路中的用戶越多，性能越好; （ 5 ）帶寬利用率高，及時對每個節點的帶寬變化情況進行控制，充分利用空閑帶寬; （ 6 ）端對端延遲小，通過在帶寬和延遲之間達到平衡使得端對端延遲減小。
分享友人
分享到 Line

分享到臉書