幀控制 的英文怎麼說

中文拼音 [zhèngkòngzhì]
幀控制 英文
frame control
  • 幀 : 量詞（幅, 用於字畫）
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. Frc : frame rate control

    幀比率控制
  2. Later the couple nodes can implement the control frame transmission or data transmission. this kind of data transmission protocol based on slot precontract basically fulfills the networking and data transmission function

    同步呼叫協議主要用於完成點到點鏈路建立和業務通道的協商任務，協商完畢即可在後續的時間內在業務通道上完成控制幀或數據幀的傳輸。
  3. It is composed of three mian protocols : call synchronization protocol, control frame transmission protocol based on arq mechanism and data transmisstion protocol based on slot precontract mechanism. one scan channel table is shared in the hfmanet. the nodes in the same dwell group work in the same scan channel, and the nodes in the different dwell group work in the different scan channel

    該協議的網路拓撲結構採用分散式分群結構，協議不同於傳統的短波點到點及需要中心節點轉發的組網方式，而是初步實現了短波電臺之間多跳組網功能，其協議內容主要包括同步呼叫協議、基於arq的控制幀傳輸協議和基於虛電路及時隙預約方式的數據幀傳輸協議。
  4. The subject has mainly finished designing and debugging software and hardware of a / d decode module, fpga video processing module, video data frame deposit module, base clock produce module, d / a encode module, i2c bus control module, etc. a / d decode module gathers analog tv signals and realize video decode ; fpga video processing module deals with the data after decoding and produces systematic logic control signal ; video data frame deposit module offers the buffering area to a large n umber of high - speed video data ; base clock produce module through input basic video signal offers system accurate relevant synchronous signal ; under control of video processing module d / a decode module convert digital video data into compound tv signal which can be shown in tv directly ; i2c bus control module is used to initialize the chip of system by simulating i * c bus timing

    本課題主要完成了a d解碼模塊、 fpga視頻處理模塊、視頻數據幀存模塊、基準時鐘產生模塊、 d a編碼模塊、 i ~ 2c總線控制模塊等部分軟、硬體設計及調試。其中a d解碼模塊採集模擬電視信號實現視頻解碼； fpga視頻處理模塊對解碼后的數據進行去噪處理的同時還負責系統的邏輯控制；視頻數據幀存模塊為大量高速的視頻數據提供緩沖區；基準時鐘產生模塊通過輸入基準視頻信號為系統提供精確的相關同步信號； d a編碼模塊在視頻處理模塊的控制下把數字視頻數據轉換成復合電視信號供顯示用： i ~ 2c總線控制模塊模擬i ~ 2c總線時序實現對系統中編、解碼晶元的初始化。
  5. Mainly discuss the choice of gateway hardware platform, specifically introduced the programming of the gateway, the operate of can controller, the design of can data send and receive programming, network programming and the multi - task programming with emphasis

    軟體設計介紹了交叉開發環境keiluvision2ide的設置和調試手段，給出了對can控制器的操作、 can數據幀處理程序設計、網路編程，其中重點討論了嵌入式多任務程序的設計。
  6. Further investigated and analyzed composition structure and flow data that dsa ' s formation of image is systematic at first in this paper, carried on intact summing up to the data in the system, having given out the plan of design of high speed and large capacity data channel of digital formation of image system of x - ray ; deeper discussion of control way on sdram, give solution that many pieces of sdram works togetherses of realizing heavy capacity, designing of heavy capacity deposit board realize storing at a high speed to vision data by frame on the basis of this ; through further investigations of interface of pci bus, optimize back end state machine design and urge procedure making with lower, giving intact pci interface scheme that realize high speed dma data transmission and satisfy request of video transmitting ; further investigate the figure systematic design method of programmable logic devices, due to the difficult point of drifting about of enabled signal in fifo in common use and setting up and keeping of output signal, method has been proposed of improving stability of system making use of signal utilizing the phase locking ring in fpga to offer a lot of clocks to move thus realize coordinating the data between every module of system to transmit at a high speed by making use of fifo

    本文首先對數字減影血管造影（ dsa ）成像系統的組成結構和數據流向進行了深入研究和分析，並對系統中的數據流向進行了完整的歸納和總結，給出了x線數字成像系統中的高速大容量數據通道的設計方案；在對sdram的控制方式做了深入探討后，給出了實現大容量多條sdram共同工作的解決方案，在此基礎上設計了大容量幀存板實現對圖象數據進行高速存儲；通過對pci總線介面的深入研究，優化後端狀態機設計和低層驅動程序開發，給出了完整的pci介面方案實現高速dma數據傳輸，完全可以滿足視頻傳輸要求；深入研究了基於大規模可編程器件的數字系統設計方法，針對通用fifo使能信號漂移、輸出數據難于建立和保持等設計難點，提出了利用fpga中的鎖相環提供多個時鐘相移的信號來提高系統穩定性的解決方案，從而實現利用fifo來協調系統各模塊之間的數據高速傳輸。
  7. A new bit rate control strategy with both global pre - allocation and local segmentation ( glas ) for low bit rate application is proposed. first, it allots bit date to every frame in advance according to possessive rate of buffer, and then distribute different quantization parameters according conctete detail. by means of this method, buffer is controlled more particularly. and the quality of decoded image is improved, the traditional video image coding method, that is to say, the intraframe coding based on dct and the interframe prediction coding based on motion compensation, is not suitable for low bit rate compression and aside from this, the encoder is too complicated

    它首先在總體上根據緩存器的佔有率給每幀預分配比特數，然後再根據具體細節給予不同的量化參數。使緩存器得到了更細致的控制，解碼圖像的質量有所改善。針對傳統的視頻圖像編碼方法，即幀內基於dct的編碼加幀間基於運動補償的預測編碼存在不適于低比特率壓縮，編碼器復雜等不足，討論了基於3 - ddct的xyz視頻圖像壓縮編碼方法，提出了3 - ddct系數的三維「 z 」形掃描方案，大大提高了編碼效率。
  8. Consequently, the author presents the basic principle of ofdm, and the process how to utilize the certain technology based on fft & ifft to realize the ofdm system

    描述了802 . 11協議介質訪問控制層和物理層的操作及幀結構。接著，作者論述了ofdm的基本原理，以及如何用基於fft和ifft的技術實現ofdm系統。
  9. Capture content with frame - accurate control

    使用幀精確控制來捕獲內容。
  10. In packet based wireless video communications, when best band distribution, not only source distortion should be considered, but also channel distortion caused by channel errors. the existing macroblock - layer rate control schemes calculates quantization parameters of all macroblocks ( mb ) in a frame in a raster scan order, and then encodes the mbs in the same order. actually, the quantization distortion is heavily dependent upon the coding order of mbs

    在基於包的無線視頻傳輸中，最佳帶寬分配時，不僅要考慮信源編碼失真，也要考慮由於通道差錯引起的通道失真；已有的宏塊層碼率控制演算法以矩陣掃描的順序計算一幀中所有宏塊的量化參數，事實上量化失真與宏塊的編碼順序有很大關系，改變宏塊的編碼順序，使復雜的宏塊分配到更多的比特數，顯然能大大提高編碼效率。
  11. It eliminates the need for agent blocks to have specific knowledge of ram array behind it. it takes care of protocols and latencies in an effort to simplify memory access by the agent blocks. agent blocks " see " a single linear frame buffer, all paging and bank swapping is handled by the and is transparent to the agent blocks

    在嵌入式系統晶元中高速存儲器介面控制電路是系統必不可少的重要組成部分，由於有了存儲器介面的存在，使得系統內部客戶模塊不必專門了解存儲器本身的復雜特性，而只需關心傳輸協議和一些定義的遲滯參數，在客戶看來存儲器僅僅是一個線性的幀緩沖器，所有的換頁、區段切換都交由介面電路來處理，從而大大簡化了客戶對存儲器操作的復雜度。
  12. The system is consist of the main data processing board which is based onthe fpga device and fast ethernet phyceiver rtl8201l and a - law pcm data encoder and decorder chip msm7702 - 3, and the dial - up and display board which is based on mcu. the main board would carry out the core task of data processing, such as voice data packing and unpacking, the ethernet frame processing, protocol processing, call processing, etc. the dial - up and display board would carry out the task of display the ip address which is input by consumer and status of network during talk period from the main board, and so on. in the paper the system of lan ip telephone and the tcp / ip protocol is introduced firstly, then the fpga device is stated. after that the fpga - based hardware scheme is introduced in detail in chapter four

    系統以altera公司的acex1k系列的fpga和快速以太網控制器rtl8201l和語音編解碼晶元msm7702 - 3為核心構建了數據處理主板和以單片機為控制器的撥號顯示子板組成。數據處理主板的核心任務，包括語音數據處理、以太網幀處理、協議處理、呼叫處理等。撥號顯示子板則完成通話前的顯示用戶所撥過的ip地址，通話期間網路狀態的顯示等等。
  13. Frames can be reordered in the animation palette by clicking on the frame you want to move and dragging it to the desired location

    位於動畫控制面板內的幀可以被重新排序。你可以點擊指定幀並將其移動到你所希望的位置。
  14. [ if ! supportlists ] - - > 6. < ! - - [ endif ] - - > frames can be reordered in the animation palette by clicking on the frame you want to move and dragging it to the desired location

    位於動畫控制面板內的幀可以被重新排序。你可以點擊指定幀並將其移動到你所希望的位置。
  15. Then, techniques of train - bus and control area net which are being widely used are recommended emphasizing the can bus and its performances and criterion. the functions of message filter and frame format of can are described in detailed

    介紹了幾種應用廣泛的列車總線和控制局域網總線技術，重點介紹了can總線的發展狀況，講述了can總線的性能和規范，詳細介紹了報文濾波的功能， can的幀的格式等。
  16. The main work of the base - band process part of the receiver is demodulation and decoding, the link control part does the framing and forwarding

    接收機的基帶處理部分主要是解調和譯碼，鏈路控制部分組幀和轉發。
  17. A simple splitter bar demo that shows how to use frame controls to implement vertical and horizontal splitter bars

    這是一個簡單的分割條演示程序，展示了如何使用幀控制項來實現垂直和水平的分割條。
  18. Suppose we want to embed a tool bar and a status bar in a child frame

    假設我們需要在子幀控制項中嵌入一個工具條和一個狀態條。
  19. Creating a view on a child frame is a basic action when programming in mfc, but what happens when you want your view to be attached to a popup dialog

    在對話框的一個子幀控制項中創建一個視圖是mfc編程的一個基本操作，但如果在一個彈出窗口中增加增加視圖？
  20. Creating a view in dialog ( an easy way ). - creating a view on a child frame is a basic action when programming in mfc, but what happens when you want your view to be attached to a popup dialog

    在對話框的一個子幀控制項中創建一個視圖是mfc編程的一個基本操作，但如果在一個彈出窗口中增加增加視圖？
分享友人
分享到 Line

分享到臉書