床溫度 的英文怎麼說

中文拼音 [chuángwēndù]
床溫度 英文
bed temperature
  • 床 : i 名1 （供人睡覺的傢具） bed; couch 2 （像床的器具、地面） something shaped like a bed Ⅱ量詞（用...
  • 溫 : Ⅰ形容詞（不冷不熱） warm; lukewarm; hot; gentle; mild Ⅱ名詞1 （溫度） temperature 2 （瘟） acute ...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 溫度 : [物理學] temperature
  1. Clinical thermometers, mercury - in - glass, with maximum device

    帶有最大儀表的含汞玻璃臨床溫度計
  2. Clinical thermometers - part 1 : metallic liquid - in - glass thermometers with maximum device

    臨床用體溫計.第1部分:最大設計的金屬玻璃管液體溫度計
  3. Both the metallogenic pressure and temperature are relatively lower, and the genetic classification of the ore deposit is epithermal deposit

    成礦的溫度和壓力都比較低，礦床的成因類型為淺成低溫熱液礦床。
  4. Hotel kunlun s guestrooms and suites feature the following amenities and services : high - speed broadband internet access international domestic direct dial fold - out make - up shaving mirror coffee tea - making facilities electronic safe mini bar satellite cable television voice mail bathrobe slippers hairdryer wake - up calls room service bed - side control panel in - room temperature controls shoeshine service

    昆侖客房和套間提供下列物品及服務：高速寬頻上網國內外直播電話折疊式化裝鏡電子保險箱小酒吧有線衛星電視語音信箱浴衣拖鞋吹風機叫醒服務房間送餐服務床頭控制面板溫度調節擦鞋服務
  5. Through researching the rhythmic change regularity of ore texture and structure, mineral composition and content, rare element " s change feature and the exploding temperature of mineral inclusion, combining the theory of magmatic ore - forming, the forming process of panzhihua vanadic titano - magnetite deposit could be divided into four periods : rock - forming period, main ore - forming period, hydrothermal period and surficial processing period

    通過對礦石組構、礦物成分及含量、稀土元素變化特徵、礦物包裹體爆裂溫度的韻律式變化規律的研究，結合巖漿成礦理論，將攀枝花釩鈦磁鐵礦礦床的形成過程劃分為四個期：成巖期、主成礦期、熱液期、表生期。
  6. Undertaking isotopic geochronological study on ar - ar, adopted the fast - neutron activation dating technique to test 40ar - 39ar age of quartz from au - bering quartz veinlet ore in the deposit, and well - defined plateau age of 210. 59 ma ?. 92 ma, the lowest apparent age of 208. 07 ma ?. 22 ma, and isochron age of 207. 14 ma ? 1. 92 ma

    通過流體包裹體顯微測溫學研究，表明金礦床的均一溫度成礦早階段為270 320 ，成礦主階段為170 250 ，成礦晚階段為110 250 ，呈逐漸降低的趨勢，低溫成礦作用明顯。
  7. Time - dependence of the mathematical model is taken into account, and time - dependent form of pens is deduced. 5. numerical analysis of heat and mass transfer in the adsorbent bed is presented, transient distribution of pressure, temperature, velocity and adsorption in it is obtained

    對吸附床的傳熱傳質規律進行了數值分析，獲得了吸附床內部的瞬時溫度壓力、吸附質速度、吸附率分佈，並通過實驗數據驗證了數學模型。
  8. The experimental results showed that the bed temperature and the adhe - sive concentration and especially the fluidizing gas velocity had great influence on the granule ' s strength

    結果表明，在本實驗范圍內，流化氣速對顆粒強度的影響顯著，床層溫度、粘結劑濃度對顆粒強度也有較大的影響，而且均是非單調的。
  9. The application of dcs to control system for circulating fluidized bed boiler, including the drum water level control, steam temperature control, hearth negative pressure control, fuel control and circulating fluidized bed temperature is introduced

    摘要介紹了集散控制系統在循環流化床鍋爐控制系統中的具體應用，包括汽包水位控制、蒸汽溫度控制、爐膛負壓控制、燃料控制和爐床溫度控制。
  10. With gelatin liquor as adhesive and wheat meal as granulation material, the effects on spray granule ' s strength of fluidizing gas velocity, bed temperature, nozzle air pressure and adhesive concentration were studied experimentally in a batch conical fluidized bed spray particle generator

    本文在一間歇錐形流化床噴霧造粒器中，以食用小麥澱粉為原料，以明膠的水溶液為粘結劑，實驗研究了流化氣速、床層溫度、噴嘴霧化空氣壓力、粘結劑濃度對噴霧造粒顆粒強度的影響。
  11. The results of the experimental tests show that nh4cl and k2hpo4, kh2po4 are the most available nutrents to our isolates when they are degrading oils. the most suitable experinment condition is : temperature being 30 c, initial ph being 7 - 8, the shaking rate of the culture flasks is 180 r / min, the concentration of nacl is 1 %. the biodegradation results have shown that our 6 isolates have the effective degradation capability to crude oil ; within 6 days the transforing rate of oil by each single strain is more than 60 %

    本研究分離出的6株菌，初步鑒定結果為： sy1為微桿菌屬、 sy2為諾卡氏菌屬、 sy3和sy5為假單胞菌屬、 sy4和sy6為芽孢桿菌屬；實驗結果表明， 6菌株的最佳氮源為氯化銨（ nh _ 4cl ） ，最佳磷源為磷酸氫二鉀和磷酸二氫鉀的混合物，最適生長條件為：溫度為30 ，初始ph值為7 8 ，搖床轉速為180r min ，鹽（ nacl ）濃度為1 ；通過降解實驗得出6株菌對原油都有較強的降解能力，單一菌株在5天後的原油降解率都高於60 ， 6株菌對原油的生物降解反應符合一級反應動力學特徵。
  12. The diagenetic state of a deposit might also be connected with the underground temperatures.

    一個礦床的成巖狀態也可能和地下溫度有關。
  13. Coal is heated to successively higher temperatures in fluidized beds.

    煤在流化床中逐層加熱到更高的溫度。
  14. The charac teristics of homogenization temperature and salinity data also reports that this high - salinity inclusions were not generated by aqueous fluid immiscibility or boiling in ore - forming processes, but generated directly from a water - saturated crystallizing magmatic melt and that the main mechanism of ore deposition is the mixing of magmatic fluid and underwater not boiling of hydrothermal solution

    均一溫度和鹽度特徵還表明，高鹽度包裹體不是由熱水溶液的不混溶作用或沸騰作用形成的，而是由巖漿熔體直接分離的鹵水形成的；沸騰作用對礦質沉澱的作用不大，而流體的混合作用是銀山礦床礦質沉澱的主要機制。
  15. The performance of catalyst beds was experimentally studied. the influence on decomposition was investigated with changing the mass flux through the cross of the catalyst bed and the initial temperature of the catalyst bed. the experimental results were compared with those of the numerical simulation

    對過氧化氫催化床的催化性能進行了試驗研究，分析了催化床床載、催化床初始溫度對過氧化氫催化分解的影響，與一維情況下的數值模擬結果進行了對比。
  16. The errors of mechanism which include errors of manufacturing components, assembling and controlling and the errors caused by temperature growth and elastic deformation of forced components affect directly the processing precision of virtual - axis machine tools

    機構的誤差直接影響虛擬軸機床的加工精度，機構誤差包括構件製造誤差、裝配誤差、控制誤差和由溫度變化和彈性變形引起的誤差等。
  17. The optimal condition of fermenation was 30 " c, 48hours, and the vibration frequency was 115 rpm. 20g / l of lys concentrtion was obtained under this condition

    在500ml的三角瓶裝液量為30ml于往復式搖床上振蕩培養，頻率為115rpm ，振幅78mm ，溫度30 ，培養時間48 。
  18. In this paper, high heat penetration into a moving particulate bed is described mathematically with a comprehensive heat and mass transfer model. the distribution of gas velocity and pressure, the temperature field of gas and solid in the moving particulate bed are examined for different conditions. the results show that thermal penetration into the moving packed - bed particles by fluid flow in porous media is high only in the position near the gas entrance. the thermal penetration thickness tends to increase with the fluid flow velocity and decrease with the particle moving velocity. in the region of thermal penetration, the porosity of solid bed has significant effect on gas field and pressure loss. it is feasible to reduce the gas pressure loss by a larger width / height packed bed in design and operation. the correspondence between thermal infection depth and particle bed height would be helpful to keep high oapacity of reactor and reduce the cost of operation

    針對移動顆粒床中物料層內的高溫氣體滲流傳熱現象，考慮滲流與傳熱的相互作用，採用局部非熱平衡假設建立了多孔介質滲流傳熱物理數學模型並進行了數值計算.研究了不同情況下床內填充多孔介質中的流速、氣固溫度和床層壓力損失.計算結果表明，高溫熱氣對移動床顆粒料層的熱滲透主要發生在滲流入口端區域，增大入口滲流速度以及減小床層物料下移速度將導致物料溫度沿床高慢速下降，熱滲透深度擴大，熱滲透作用區域內的物料溫度水平提高.在熱滲透作用區域，孔隙率對流場和壓力損失有很大的影響.研究結果對于移動顆粒床反應器的設計與運行具有一定的參考作用
  19. Comparing to the traditional production technology, the new methanol synthesis process has many advantages which are as follows, high conversion of synthesis - gas per pass, high methanol concentration at reactor exit, isothermal temperature in slurry bed, easy temperature control, simple heat exchanging, excellent technology economy characters and so on. so it becomes a new technology for methanol production that has great industry application

    與傳統生產工藝相比，三相淤漿床甲醇合成工藝具有單程轉化率高，出口甲醇質量分數高；床層等溫，反應條件優良；溫度易於控制，換熱簡單；生產的技術經濟指標優良等特點，因此成為一種應用前景非常廣闊的新興甲醇生產新技術1 。
  20. Because of this rapid attainment of equilibrium it is not practical to measure the temperature difference between gas and solid at the bed exit.

    由於達到平衡很快，故測定床層出口處的氣體和固體溫度差是不實際的。
分享友人
分享到 Line

分享到臉書