恆壓充電 的英文怎麼說

中文拼音 [héngyāchōngdiàn]
恆壓充電 英文
constant potential charge
  • 恆 : Ⅰ形容詞1 （永久; 持久） permanent; lasting 2 （平常; 經常） usual; common; constant Ⅱ名詞1 （恆心...
  • 壓 : 壓構詞成分。
  • 充 : Ⅰ形容詞（滿; 充足） sufficient; full; ample Ⅱ動詞1 （裝滿; 塞住） fill; charge; stuff 2 （擔任; ...
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  1. The technology of high power constant current charging, high voltage heavy current discharging switch, high speed and high voltage pulse generator, precision synchronization delay, auto control and so on are concretely introduced in this paper

    具體研究了大功率恆流充電技術、高壓大電流放電開關、高速高壓脈沖發生器、高精度延時同步技術及系統自動控制技術。
  2. Study on high voltage and constant current charging power supply based on soft switching

    基於軟開關的高壓恆流充電電源的研究
  3. The li - ion or li - polymer battery ic use cc / cv charging mode which includes the 3 charging stages : the trickle charging, large constant current charging and constant voltage charging

    本文設計的鋰電池充電器晶元採用了恆流恆壓的充電方法，並在此基礎上將充電過程分為三個階段:預充電、恆流充電和恆壓充電。
  4. After which, the battery will be charged by large constant current to allow the fast charging. finally, the constant voltage charging is adopted to guarantee the battery was charged to its full capacity. under the condition that the temperature has raised to a certain threshold at the constant current charging stage, the over temperature circuit is performing and it provides a compensation current which switches the system to constant temperature charging mode with the intention of protecting the ic

    即在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆定壓充電，確保電池充滿;在恆流充電階段，當晶元溫度上升到一定程度時，晶元過熱保護電路開始工作，該電路以提供充電補償電流的形式使充電進入恆溫充電模式，對晶元進行保護。
  5. The effects of the fabrication conditions on the crystal structure, grain size, micromorphology and electrochemical performance of these materials have been studied in depth. the reaction mechanism of the low - heating solid - state reaction method has also been investigated. in addition, a novel electrochemical method ( rpg method ) based on the concept of " ratio of potentio - galvano - charge capacity " has been for the first time developed to determine the diffusion coefficient of lithium - ion within insertion - host materials on the basis of the spherical diffusion model

    本論文較系統地考察了低熱固相反應法合成鋰離子電池正極材料的可行性問題，研究了工藝條件對材料的晶體結構、晶粒尺寸、微觀形貌及電化學性能等的影響，探討了低熱固相反應的機理，並通過引進「恆壓-恆流充電容量比」的概念，給出了一種測定鋰離子嵌入脫出固相擴散系數的新方法。
  6. The technology of alternating - current - boosting by way of constant current is successfully used to charge capacitors with 25 kilojoules of energy in only eight seconds. rail - gap switch with performances of long life and highly steady state are designed. and the high voltage pulse generator, which can produce low - excursion and fast - rise pulses, are designed by using double trigger circuit and hydro - thyristor as switch

    在大功率恆流充電技術上，成功的應用了交流調壓式恆流技術，可以在8s內讓電容器儲存25kj的能量;設計出了長壽命、高穩定的軌道開關;採用氫閘流管做開關，使用雙觸發電路，研製出了低抖動、快前沿的高壓脈沖發生器（點火機） ;採用單片機和pld ，研製出了精度為10ns的延時同步機。
  7. Constrained to technologies, the lead - acid battery mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current, etc. the charging current of these methods cannot match efficiently the acceptance curve of the lead - acid battery proposed by j. a. mas. as a result, some of these methods have a low time efficiency and incompleteness charging. and some of them lead to overcharge and gas - generation, which will result in low - efficiency, time - consuming and prone - to - damage of the charging operation

    鉛酸蓄電池由於受到技術條件的限制，其充電主要採用恆壓、恆壓限流、恆流等常規充電模式，這些方法的充電電流未能有效的遵從馬斯所提出的可接受充電電流曲線，因而有的充電方法時間效率低、充電不完全;有的則存在著過充電和析氣等現象，並導致充電過程的低效，耗時和易損。
  8. The charging of lead - acid battery, the most widely accepted secondary battery, constrained to technological limitation, mainly adopted traditional charging methods such as constant voltage, constant voltage with current limitation, constant current and etc. those methods may not follow the internal physical and chemical laws within the battery, leading to serious overcharge and gas - generation, and resulting in low - efficiency, time - consumming and prone - to - damage of the charging operation

    二次電池中被最廣泛接受的鉛酸蓄電池由於技術條件的限制，其充電主要採用恆壓、恆壓限流、恆流等常規模式，這些充電方法未能遵從電池內部的物理化學規律，大多存在著嚴重的過充電和析氣等現象，並導致充電過程的低效，耗時和易損。
  9. This miner ' s headlamp has charge control mode with constant voltage. it can offer the travel charge equipment and always can charge through the miner ' s hat

    該礦燈燈頭內設置採用恆流恆壓充電模式的充電控制器，可配旅充，也可通過配接充電適配器直接裝在各類礦用帽燈充電架上充電。
  10. The study bases on the four operating conditions of which the longnan network will be implemented in the year of 2005 and 2010. first, this paper calculates the power flow distribution that including the line charging reactive power and input of the low - voltage shunt reactor in chengxian s / s. assumed that the bus voltage of tianshui s / s and bikou power plant to be constant, the study count the voltage level of the 330kv and 220kv bus - bar when the 330 / 220kv transformer in standard tap changer position. in order to set control rules

    本文基於隴南電網在規劃發展水平年2005年及2010年的四種可能的運行方式下及潮流條件，計算出了計入線路充電無功及投入成縣變低壓並聯電抗器后的潮流分佈，在設定甘肅大網側及碧口電廠側母線電壓恆定條件下，計算了330kv及220kv主變在有載調壓標準分接頭變比下的330kv及220kv母線電壓水平。
  11. Based on the experiment of nimh battery, investigations on characteristics of discharging and charging of nimh battery, and analysis of influencing factor of nimh battery, an approach of ah ? coe ? ocu has been carried out to estimate an accurate surplus energy and state of charge of nimh batteries, and consider the compensation of the temperature, aging and self - discharging etc. after theoretic analysis has been completed, simulations are given to determine parameters of batteries for changan hev

    本文在蓄電池試驗的基礎上，分析和研究ni - mh蓄電池充放電特性及其影響因素，建立了電池內阻、電動勢模型，提出了安時?能量守恆?開路電壓演算法（ ah ? coe ? ocu法）預測蓄電池的剩餘能量和荷電狀態計算方法，並進行溫度、循環使用壽命、自放電等補償，從而建立了蓄電池的充放電模型。
  12. The trickle charging uses small current at the initial of charging cycle to fix and protect the over - discharged battery ; after which, the battery will be charged by large constant current to allow the fast charging ; finally, the constant voltage charging is adopted to guarantee that the battery is charged to its full capacity

    在充電初期採用較小的電流對電池進行預處理，對出現過放電的電池進行修復和保護;然後採用較大的恆定電流對電池充電，實現快速充電的目的;最後採用恆壓充電，確保電池充滿。
  13. A simple constant voltage and constant current charger has been improved, the state of float charger has been added to the charger in order to guarantee the full charge of battery safely, with high charge speed. experiment results and detailed designs of power circuit and control circuit of the charger are presented

    本論文對一種簡單實用的恆壓恆流充電器進行了改進，在恆壓恆流充電的基礎上加入了浮充狀態，從而保證了蓄電池的滿充；同時對充電器的功率電路和控制電路進行了詳細的設計，並且給出了實驗結果。
  14. The hspice simulation results indicate that the charging current is up to 2a and the precision of termination voltage is very high with the error only around 10 - 3. the efficiency is approximate 68 % when the ic is powered by fix voltage source and up to 95 % when the ic is powered by current limited source

    Hspice模擬結果表明，該晶元恆流模式下最大充電電流為2a ;對充電終止電壓的控制精度高達10 - 3 ;當採用恆壓作為電源時，充電效率為68 %左右;當採用具有電流限制功能的電源時，充電效率可達到95 % 。
  15. Kv 0. 7 a high voltage variable frequency constant current capacitor charging power supply

    高壓變頻恆流充電電源35
  16. In chapter 3, according to the requirements of high voltage power supply used for charging capacitors with constant current, the series resonant converter ( src ) was chosen as the main circuit frame. the dynamic process of src was discussed by using mathematical analyses and numeric simulation to study the operational characteristics, the effects of parameters of resonant circuit on them and the relationship between switching frequency and out put power, which provided the bases of designing the power supply

    第三章中根據高壓電容恆流充電電源的運行特點，選擇了串聯負載諧振變換器作為主電路結構形式，並對其動態過程進行了數學分析及數值模擬，討論了該電路的運行特點、諧振迴路參數對運行特性的影響以及開關工作頻率與功率輸出的關系，為電源的設計提供了依據。
  17. Following the operational principle of the li - ion battery fast - charging and the existing charging approaches, the trickle pre - charge mode and constant temperature charging mode are added based on the cc / cv mode, i. e. pre - charge the battery using trickle current at the initial of charging cycle to fix and protect the over - discharged battery

    並在此基礎上設計了一款針對單節鋰電池的dc / dc充電器晶元。在對鋰電池快速充電原理和目前各種充電方法研究的基礎上，本文以恆流恆壓充電法為基礎，增加了小電流預處理和恆溫充電模式。
  18. Constant voltage charge

    恆壓充電
  19. Intellect charge : the battery charger is using slice of flower to control charge that has constant current, constant voltage to charge, short current protection, turn lamps function and prevent to flow backward function

    智能充電:充電器採用晶元控制充電，具有恆流，恆壓充電，過充保護，短路保護，轉燈功能，防倒灌保護功能。
  20. At last, a high voltage power supply used for charging capacitors with constant current has been designed and completed. the operational characteristics of this power supply were proved by experiments to be fully agreed with the designing targets

    最後，完成了一臺高壓大功率恆流充電電源的設計與製造，實驗結果表明該電源的性能完全達到預期指標。
分享友人
分享到 Line

分享到臉書