抑制柵 的英文怎麼說

中文拼音 [zhìzhà]
抑制柵 英文
cathode grid
  • : Ⅰ動詞(向下按; 壓制) restrain; repress; curb Ⅱ連詞[書面語]1 (表示抉擇) or 2 (表示轉折) but3 ...
  • : Ⅰ動詞1 (製造) make; manufacture 2 (擬訂; 規定) draw up; establish 3 (用強力約束; 限定; 管束...
  • : 柵名詞(柵欄) railings; paling; palisade; bars
  • 抑制 : 1 (控制) restrain; control; check; hold up; curb; stop; repress; bridle; choke; prehension; sup...
  1. Toxicity assessment of soil contaminated by heavy metals using algae growth inhibition test

    應用斜生藻生長實驗對重金屬污染土壤的毒性進行診斷
  2. Based on the hydrodynamic energy transport model, the influence of variation of negative junction depth caused by concave depth on the characteristics of deep - sub - micron pmosfet has been studied. the results are explained by the interior physical mechanism and compared with that caused by the source / drain depth. research results indicate that with the increase of negative junction depth ( due to the increase of groove depth ), the threshold voltage increases, the sub - threshold characteristics and the drain current driving capability degrade, and the hot carrier immunity becomes better in deep - sub - micron pmosfet. the short - channel - effect suppression and hot - carrier - effect immunity are better, while the degradation of drain current driving ability is smaller than those with the increase of depth of negative junction caused by source / drain junction shallow. so the variation of concave depth is of great advantage to improve the characteristics of grooved - gate mosfet

    基於能量輸運模型對由凹槽深度改變引起的負結深的變化對深亞微米槽pmosfet性能的影響進行了分析,對所得結果從器件內部物理機上進行了討論,最後與由漏源結深變化導致的負結深的改變對器件特性的影響進行了對比.研究結果表明隨著負結深(凹槽深度)的增大,槽器件的閾值電壓升高,亞閾斜率退化,漏極驅動能力減弱,器件短溝道效應的更為有效,抗熱載流子性能的提高較大,且器件的漏極驅動能力的退化要比改變結深小.因此,改變槽深加大負結深更有利於器件性能的提高
  3. On the one hand, the design uses low voltage cascode op framework to improve its gain ; on the other hand, it applies self - bias and cascode structure to the whole sensing circuit. by using the improved method, we have successfully obtained low power consumption, low offset, high linear and high psrr ptat current generator under low power supply

    在電路設計上一方面改進運放結構,採用低壓共源共結構以提高其增益,另一方面整體傳感電路採用自偏置結構和共源共電流鏡結構,在低電源電壓下成功設計了低功耗、低失調、高線性度和高電源電壓比的ptat電流產生電路。
  4. Then we deduce the couple - mode equations that describe the mode coupling behaviors in this kind of gratings. based on this, we study the photosensitive inner cladding ' s influence on the core - mode - core - mode coupling and the core - mode - cladding - mode coupling in this kind of grating. a fiber bragg grating was experimentally fabricated with this kind of photosensitive fiber

    然後以第二章給出的耦合模理論為基礎,結合用帶光敏內包層的包層模光纖的結構特性,推導出用這種光纖製作的光纖布拉格光的耦合系數和耦合模方程。
  5. ( 3 ) the bragg - shift phenomenon of transmission holographic grating is investigated in theory and experiment. as a result, the bragg - shift phenomenon will be restrained when the intensity ratio of initial writing beams is one

    對透射體全息光在讀出過程中的布拉格漂移現象進行了理論和實驗分析,得出在本實驗條件下,當寫入光強比為1 1時可以很好地布拉格漂移現象的發生。
  6. The side mode suppression ratio about 39db is realized. 5. a tunable cladding - pumped yb3 + - doped fiber laser system is reported

    55 m可調諧光纖光外腔半導體激光器,得到調諧范圍為7nm 、邊模比達39db的激光輸出。
  7. 2. the input stages of the ccii and the operational amplifier in transimpedance implifier are realized with folded cascode amplifier to reach high cmrr, large open loop gain and low offset

    2 .為了提高儀表放大器的電源比,並得到大的開環增益,相對低的失調等性能,電流傳輸器的輸入級和跨阻放大器中運算放大器輸入級均採用折疊共源共放大器。
  8. It proves that adding up fiber and modified asphalt in the common asphalt mixture can decrease the brittle point temperature and strength the ability of resisting cracking. fiber - reinforced asphalt concrete and glass fiber grid which has been set between the road base and overlay can delaying reflection cracking effectively

    試驗證明,在普通瀝青混合料中加入聚酯纖維以及使用改性瀝青可脆化點溫度降低,增強低溫抗裂性,加入goodroad聚酯纖維和在基層與面層之間鋪設玻纖格可有效反射裂縫,值得推廣。
  9. The effects of goodroad enhanced asphalt mixture and glass fiber grid for resisting reflection cracking are proved by full - scale test, the resisting mechanism is analyzed, too

    通過反射裂縫足尺試驗來評價goodroad增強瀝青混合料和玻璃纖維土工格反射裂縫的效果,對機理做了分析。
  10. Test method for evaluating inhibitory effects of ink grids on membrane filters

    膜過濾器上油墨格作用的評價方法
  11. In succession, the theory of chirped - pulse amplifier system is given in detail, firstly, studying from designing experimental light road and optical components to theoretical analysis, we par ' tly finished the system by ourselves. about ultr a - shoft pulse with a pulse - width of 9. 8f s and output power of 650mw and band - width of about l 20nm is output from oscillator source, secondiy, the stretching capacity of single grating four - pass stretcher is measured using abcd matrix combining collins function, and the effect of relativ e parameters to the streching ratio is also simulated. thirdly, a new type of disjunctional frequency moduiating function is provided according to the gain - narrowing and gain - saturation which are appeared in the co urse of amplification, under modulating the two effects are both controlled on some e xtent, fourthiy, the effect of ase that is often ignored by people is analyzed and the resolving methods are also given

    從光路、光學元件的自行設計到理論分析計算,初步建立了一臺實驗系統;採用abcd矩陣法結合collins公式計算了四通式單光展寬器的展寬量,並模擬了相關參數對展寬比的影響,對實驗具有指導意義;評價了再生放大器和多通放大器的優缺點,對放大過程中通常忽略的放大自發輻射現象( ase )進行了分析,並提出了相應的解決方法;針對放大過程中出現的增益窄化和增益飽和現象,對輸入種子脈沖提出了一種新的分段頻率調函數,實現了對增益窄化效應和增益飽和效應的共同;提出了系統的材料(包括放大介質和光路中的普通介質)正是融合高階色散的來源。
  12. Introduced a new way for dispersion compensation in transmission using uniform fiber bragg gratings. at the last, the analysis of fiber grating production with a phase mask was carried out. based on diffraction and interference theories, we access the near - field optical intensity distributions produced by a periodic mask and draw the important conclusion that we must put the mask near the fiber as we can in the experiment

    最後論文討論了光纖光的製作,分析了掩膜板后干涉光場的分佈,指出了掩膜板製作應該盡量實現零級,且在系統調試中,光纖要盡量靠近掩膜板放置這一重要結論,在此基礎上利用現有實驗設備製作出了光纖光,研究了不同曝光條件對光製作的影響,並利用實驗分析了光的溫度穩定性。
  13. In chapter 3, fiber bragg grating fabricated with cladding mode suppression fiber is studied

    第三章研究用包層模光纖製作的光纖布拉格光
  14. Therefore, fiber gratings have numerous applications in almost all the realms of optical fiber, especially in wavelength - division multiplexing ( wdm ) all - optical networks. this dissertation presents a detailed study of the following three types of fiber gratings : fiber bragg grating fabricated with cladding mode suppression fiber, linearly chirped moir fiber grating, and long - period fiber grating with rectangular index modulation

    本文以目前在wdm全光網中有良好應用前景的三種類型的光纖光(用包層模光纖製作的光纖布拉格光、線性啁啾moir光纖光、矩形折射率調型長周期光纖光)的理論和設計為研究內容。
  15. As a result, a theoretical model of fiber grating external cavity semiconductor lasers including the reflectivity distribution of fiber grating has been presented in this paper. based on the model, the laser characteristics such as the threshold current, mode suppression ratio etc. have been specified

    利用該模型對光纖光外腔半導體激光器的閾值電流、模式比等進行了研究,得到了一些新的結論,並對此結論作出了合理的解釋。
  16. Cathode grid lens

    抑制柵透鏡
分享友人