拉伸試棒 的英文怎麼說
中文拼音 [lāshēnshìbàng]
拉伸試棒
英文
tensile test bar-
Cylindrical helical springs made from round wire and bar - guide to methods of specifying, tolerances and testing - extension springs
用圓形線材和棒材制的圓柱形螺旋彈簧.規格公差和測試指南.拉伸彈簧Plastics - injection moulding of test specimens of thermoplastic materials - small tensile bars
塑料.熱塑材料試樣噴射鑄造.第2部分:小拉伸棒料For fatigue life cycles test, when the reaction film resides at the area near the surface of specimen readily to initiate crack, and the fatigue life cycles were greatly deteriorated
在拉伸性質方面,試棒在相同應變速率下,試棒中反應膜面積率越多對試棒的拉伸強度及延伸率的影響越嚴重。In this paper, 130mm diameter hot - rolled bars ( 3 transus temperature is 798 c ) were used in experiments. the superplastic property of ti - 1023 alloy was studied systematically by the experiments of tensile and compression. the preparation method of fine - crystalline structure and the processing parameters of superplastic forging are optimized
本文以130mm熱軋棒材為原材料,通過超塑性拉伸和超塑性壓縮試驗,對ti - 1023合金的超塑性進行系統研究,研究坯料細晶組織制備方法,優化超塑成形工藝參數,為高筋薄腹板復雜形狀ti - 1023合金鍛件超塑性等溫模鍛工藝的制定提供試驗依據。Plastics. injection moulding of test specimens of thermoplastic materials. part 2 : small tensile bars
塑料.熱塑材料試樣的注模.第2部分:小拉伸棒Plastics - injection moulding of test specimens of thermoplastic materials - part 2 : small tensile bars
塑料.熱塑性塑料試樣的注射模塑件.第2部分:小拉伸棒Plastics - injection moulding of test specimens of thermoplastic materials - part 2 : small tensile bars iso 294 - 2 : 1996 amd. 1 : 2004 ; german version en iso 294 - 2 : 1998 a1 : 2005
塑料.熱塑性材料試樣的注模塑法.第2部分:小拉伸棒分享友人