指形濾器 的英文怎麼說

中文拼音 [zhǐxíng]
指形濾器 英文
finger strainer
  • : 指構詞成分。
  • : 動詞(除去液體雜質) filter; strain
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  1. The metal nanoparticles that form in hot critical layer are drawn from reaction area and arrives designated installation via the centrifugal selection grades ware under the transport of inertia gas current, then metal nanoparticles are collect via filter completion

    氣流將在熱臨界層中四川大學博士學位論文成的金屬懸浮顆粒從反應區中提取出來,經過離心分級的篩選,在惰性氣流的輸運下抵達定裝置,通過完成對金屬納米顆粒的收集。
  2. In this paper, the main research works are as follows : 1 ) survey and analysis previous work in auv navigation and summarize : as the cumulate error, the dead - reckoning and inertial navigation systems ca n ' t be used without other modified system ; the acoustic navigation system is used only in small range, and is very expensive. 2 ) two important approaches in geophysical navigation techniques are summarized, one is terrain contour based navigation, this approach is investigated keystone today ; the other is image based navigation, due to no perfect image sensors and image seabed map, this approach has seldom been practised. 3 ) two important terrain contour based navigation algorithms has been applied to auv, one is match algorithm - based terrain contour match ( tercom ) ; the other is kalman filter - based sandia inertia terrain - aided navigation ( sitan )

    主要研究內容包括:一、總結分析了當前水下導航的常用方法和不足之處,出基於航位推算的導航方法,存在著最大的問題就是導航誤差的積累問題,如果沒有修正系統,這種方法很難滿足使用要求;其次出基於聲學的導航方法,造價昂貴,導航范圍有限,難以滿足自主水下航行大范圍導航的需求;二、總結了當前水下地輔助導航的主要技術路線,一是基於地高程的匹配方法,這是當前研究的重點;二是基於地圖像的匹配方法,由於缺乏良好的圖像傳感,和可用的海底圖像地圖,目前這種方法還有待研究發展;三、將兩種地高程匹配的常用方法應用到自主水下航行上:以相關演算法為前提的地輪廓匹配( tercom )方法和以卡爾曼波為基礎的桑迪亞慣性地輔助導航( sitan )方法,前者演算法簡單可靠,但是導航精度不高,後者雖然精度比較高,但存在著演算法較為復雜、有可能發散和出現奇異值等問題。
  3. The increasing of single channel capacities and evolution of optical networks topology, from simple point - to - point to intelligent optical networks, call for strict demands to optical filters. in this paper, the crucial technologies of optical filters such as interleaver, optical digital filter, fused biconical taper all - wave coupler as well as polarization - pump combiner have been studied experimentally and theoretically, which include : 1. a new process, cascaded fbt ( fused biconical taper ) with precise control as well as strict interference arm length difference, is proposed for the first time to our knowledge

    單通道速率不斷提高以及網路拓撲由單一的點對點傳輸向可上下載的環網和可動態選擇波長路由的智能型格光網路演進,對光的常規性能標、時域特性和動態可調諧特性提出了更加苛刻的要求,鑒於此,本論文全面研究了全光纖熔錐型奇偶交錯波技術、數字光波技術、基於g - t全通的奇偶交錯波技術以及熔錐型全波耦合和偏振泵浦合波
  4. Secondly : i choose a non - linear filter named hybrid filter which combines linear and nonlinear filters is proposed for print gray image, it performs better than average fil ters and median filters on noise reduction. while retaining edges of an image. i suggest a modified version and fast implementation of this filter improve its performance. because of its reduced computation complexity, this filter excels in real - time tasks

    因為噪聲時常包含非線性問題,針對這種情況,既要抑制噪聲,又要保護圖像邊緣,本文採用一從度紋圖像上噪處理研究種基於線性,非線性的混合演算法,該演算法比均值,中值加權,格,具有更好的抑制噪聲的能力,不但較好的保持圖像地邊緣,而且能反映圖像的幾何結構和細節特性。
  5. The emphasis of the thesis is base - band signal shaping and programmable interpolation algorithm. we introduce the basic theory of base - band signal shaping, and the effect of the digitizing of the ideal raised cosine rollof signal g ( t ) is attentioned. the shaping filter parameters are determined based on the system specifications, and the simulation results are given

    首先從降低鄰近碼間干擾原則出發,討論了基帶成的基本原理與升餘弦滾降的時頻特性,重點分析將理想的滾降波g ( t )數字化后對頻譜的影響,並且根據系統標,確定了各項參數,給出了具體的設計舉例和模擬結果。
  6. Through theoretic reckoning and simulating analyzing, several control strategies for shunt apf were compared and chose ip - iq arithmetic of the instantaneous reactive power theory control strategy as the right scheme to produce the instructing current. based on it, some new control arithmetic was subjoined to suppress the resonance in system and balance the dc side capacitor voltage. two topologies of main circuit were compared and chose the three - phase voltage - source converter with a split - capacitor as its main circuit structure

    通過理論計算和模擬分析,比較了並聯型apf的幾種控制策略的優點和缺點,從中選擇瞬時無功理論控制策略i _ p - i _ q計算方式為令電流產生的演算法,並在此基礎上增加了抑制系統諧振和平衡直流側電容電壓的控制;比較了並聯型apf主電路的兩種常見式,從中選擇了三相電壓型變流的主電路式;算出適合該apf的直流側電容和出線電感的參數;設計出能有效消除apf產生的高次諧波的高通
  7. We encoded and optimized the filter to design the algorithm for filter. computer simulation of complete simulation has demonstrated that the new filtering technique can significantly not only reduce the width relative deviation and the area relative deviation of the image, but also improve the resolution and the focal depth. it provides directive basis for the development of the experiment and the practicability of the technology

    計算機模擬結果表明,通過在非瞳孔面的適當分數傅立葉變換面上加入優化設計的位相型,可有效減小光刻圖的線寬偏差和面積偏差,提高成像系統的解析度和焦深,為分數域波改善光刻圖質量實驗的開展和這一解析度增強技術走向實用化提供了導依據。
  8. In the latter part, we discuss some classical algorithms of conventional amti and stap and present a new method to combine space conventional beamformer with the maximum improve factor amti filter. then we present a concrete method of putting dpca into aerial phased array ' s amti, simulation result proves the validity

    在自適應動目標示部分,討論了常規amti處理和空時聯合自適應處理的各種演算法,提出一種將空域常規波束成與最大改善因子amti相結合的處理方法並進行了模擬驗證。
  9. This paper gives a detailed account of the waveform, matched - filter, fuzzy function, resolution in speed, resolution in range and the capacity of anti - interference of the chirp signal. it deals with several methods to produce chirp signal and the advantages and disadvantages of these methods. it describes the working principle and performance of dds, analyses the phase errors initiated by the phase truncation and proposes a new scheme to solve the error

    本文詳細介紹了以下幾個方面:線性調頻信號的波、匹配、模糊函數、速度分辨力、距離分辨力及抗干擾能力;產生線性調頻信號的幾種方法並簡要分析了各種方法的優缺點; dds的工作原理、性能標,分析了相位截斷產生的相位誤差,並提出解決這種誤差的新方案;設計了一個產生線性調頻信號的具體電路。
  10. Two type microwave bandpass filters are applied to meet different bandwidth requirements. the filters of the 2 % relative bandwidth is realized by ^ / 4 coupled waveguide filters, whereas the ones of 1 % relative bandwidth utilizes e - plane septum mounted in the wavefuides. very compact diplexers are achieved by different configurations individually

    根據不同的設計標,作者提出了兩種雙工模型:波導分支雙工和準平面e面波導雙工;並且選用不同的式來實現通道:用4耦合波導設計出相對帶寬為2的窄帶,而相對帶寬僅為1的極窄帶是採用過正面來實現的。
  11. We decide to use seven - sections coupled - line filter after comparing the various filter circuits, and complete the quantitative analysis and optimization design by ads, hfss etc. ( 2 ) three - stages fet low noise amplifier according to the lna ’ s design theory and guide line, we decide to use ne3210s01 fet and choose the form of three - stages, thus we can achieve high stability, low noise and high gain

    通過對各種帶通電路方案進行比較,確定採用七階平行耦合微帶,並利用ads , hfss等工具進行了定量的理論分析和優化設計。 (二)三級聯低噪聲放大根據微波lna設計原理及標要求,我們選用ne3210s01系列低噪聲管,並採用三級放大的式,以期獲得高穩定性,低噪聲,高增益。
分享友人