振蕩傳感器 的英文怎麼說

中文拼音 [zhèndàngzhuàngǎnqì]
振蕩傳感器 英文
osciducer
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 傳 : 傳名詞1 （解釋經文的著作） commentaries on classics 2 （傳記） biography 3 （敘述歷史故事的作品）...
  • 感 : Ⅰ動詞1 （覺得） feel; sense 2 （懷有謝意） be grateful; be obliged; appreciate 3 （感動） move; t...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Delay line oscillator is composed of broadband amprifer adjustable attenuator and saw sensor device. after output signal of delay line oscillator is smoothed, it mixes with 109mhz local oscillation signal. its differential frequency signal is smoothed by low - pass filter trimmed by shaping circuit and processed by digital processing circuit

    延遲線振蕩器由寬帶放大器、可調衰減器和聲表面波質量傳感器件構成。延遲線振蕩器輸出信號經濾波后與109mhz的本機晶體振蕩器輸出信號相混頻，通過低通濾波取其差頻，並經整形後由數字信號處理電路處理。
  2. Because the larger the event, the larger the number of oscillations of the transducer before they decay below the trigger level.

    因為事件越大，傳感器在它衰減到低於觸發器電平之前的振蕩次數越多。
  3. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  4. Recent years, the using of piezoelectric sensors becomes a focus in novel biosensors research. the basic principle is that the characters of its oscillation are highly responded with the changes of the surface mass adsorption, or the physic characters in the reaction system including density, viscosity, conductivity and so on. a piezoelectric biosensor with a nanogram sensitivity could be constructed through a reasonable biological processing and structure designing to the piezoelectric quartz crystal

    近年來，壓電傳感器檢測技術逐漸成為生物分析中的研究熱點，其基本原理是利用石英晶體振蕩特性對石英晶體表面質量負載（質量效應）和反應體系物理性狀如密度、粘度、電導率（非質量效應）等的改變具有高度敏感的特性，通過對石英晶體進行適當的生物學處理和結構設計，構建出具有具有ng級檢測能力的生物傳感器。
  5. This paper aims at designing a relaxation oscillator which is used in the readout circuits for silicon capacitive accelerometers with cmos process

    採用cmos工藝設計出應用在微硅電容加速度傳感器單片測試電路中的弛張振蕩器即是本文的主要研究目的。
  6. On the aspect of errors analysis of hrg, a brief introduction of the close - loop detection theory of hrg is present first. later the expressions of close - loop detection errors are deduced in theory. the impact of stimulating signals, turning speed, outside appended oscillation, the location & area of electrodes, and the current loss in capacitor is considered, and the primary analysis of error compensation is given

    在半球諧振陀螺誤差分析方面，本文從半球諧振陀螺的閉環檢測原理出發，對半球諧振陀螺閉環檢測誤差進行了分析和推導，考慮了激勵信號、轉動速率、外界附加振蕩、電極位置及極板面積和電容傳感器等因素造成的陀螺誤差並對誤差補償進行初步分析。
  7. Finally, this paper brings forward to the betterment means for making sensor probe. the circuit of signal procession module are introduced. it expounds the important parts, for example, design of oscillatory, design of demodulation circuit, design of signal filter circuit

    介紹了研製的傳感器信號處理模塊電路，對電路中的重要部分如：高穩振蕩源的設計、檢波電路設計、濾波電路設計等都有詳細說明。
  8. Technology of fine processing was firstly used to make the lsaw biosensor with dual delay linear style. then we developed the dual channels resonance circuit and used the labview software to record and analyze phase / frequency automatically. so the detection system of lsaw biosensor was constructed by combing all these components with network analyzer and computer

    方法: 1 .利用精細微加工方法制備雙延遲線型漏聲表面波傳感器，並自行開發研製自激式振蕩電路， labview相位、頻率記錄分析軟體，將它們與網路分析儀、頻譜分析儀及計算機聯用以構建lsaw生物傳感器檢測系統。
  9. 5. an optimized piezoelectric quartz crystal sensor array has been designed and assembled by using five individual vibration electrical circuits

    採用5個單獨的振蕩電路，設計並組裝了一種具有優化電路的壓電傳感器陣列裝置。
  10. At present, there are various methods of moving vehicle detector and identification. the system we designed for traffic information makes use of the principle of electromagnetic induction and radio frequency identification the moving vehicle detector, which is based on inductive circular loop, detects the information of vehicle according to the inductive signal. the basic information including speed and go through time can be detected to analyze oscillator frequency

    目前現行的車輛檢測與識別系統的種類繁多，本系統基於電磁感應理論和射頻識別技術，採用環形線圈作為數據採集傳感器，通過對振蕩器的頻率計數測量到車輛的通過、速度等基本信息，同時啟動射頻識別系統，使讀寫器與安裝在車輛上的非接觸ic卡進行無線通訊獲取通過車輛的類型和所屬用戶等數據，並將有關數據通過rs232串口送至上位機。
  11. The task in the open loop system is to get lpg injection duty ratio in pre - set two dimension map according to practical engine operation condition, while the task in the closed - loop system is to calculate lpg injection duty ratio by the approaching increment method or the proportion and integral ( pi ) controller according to the signal of the oxygen sensor. to eliminate the oscillation phenomena of the signal of the oxygen sensor in low - speed condition, this paper develops the stable increment method

    開環階段根據實時工況參數對事先制取的噴氣占空比map圖執行取值操作；閉環階段根據氧傳感器反饋信號通過增量逼近法或pi環節計算輸出適合即時工況的噴氣占空比值；為解決低速振蕩現象，本文運用固定增量法，對系統進行低速振蕩微調。
  12. The nonlinear simulations and dynamic simulating tests show that h pss is insensitive to the changes of operating conditions and perturbations, it can restrain oscillations under a wider range of operating conditions than the conventional pss. the robustness of h pss is very good. yang lin ( power system and its automation ) directed by prof

    為了與傳統電力系統穩定器進行比較，對單機無窮大系統進行了非線性模擬和動模實驗，結果表明： h pss對運行狀態的變化以及外界干擾不敏感，能夠在較大的運行范圍內有效地抑制振蕩，顯示了很好的魯棒性。
  13. Based on the analysis of autonomous underwater vehicle ( auv ) sensor failure, diagnosis methods corresponding to three kinds of sensor failure are presented, that is, through that no sensor output for a long time to diagnose the fault of sensor signal gathered keeping unchanged, linear smoothing to solve the vibration of sensor signal, wavelet transform to inspect the broken sensor signal

    摘要在分析水下機器人傳感器故障形式的基礎上，對傳感器可能出現的三種故障形式分別給出了相應的診斷方法，即通過傳感器長時間採集不到數據來診斷傳感器信息保持不變的故障，線性平滑濾波解決傳感器輸出振蕩，小波變換檢測傳感器信息的突變。
分享友人
分享到 Line

分享到臉書