振蕩器電源 的英文怎麼說

中文拼音 [zhèndàngqìdiànyuán]
振蕩器電源 英文
oscillator supply
  • 振 : 動詞1. （搖動; 揮動） shake; flap; wield 2. （奮起） brace up; rise with force and spirit
  • 蕩 : Ⅰ動詞1 （搖動; 擺動） swing; sway; wave 2 （無事走來走去; 閑逛） loaf; wander; roam; loiter; go a...
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 源 : 名詞1. （水流起頭的地方） source （of a river）; fountainhead 2. （來源） source; cause 3. （姓氏） a surname
  • 電源 : source; current source; electric source; power pack; power supply; power source; source of power ...
  1. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  2. The backward - wave oscillator ( bwo ) is one of the promising devices that can produce high - power microwaves and is intensively investigated because of its merits such as compact structure, high efficiency and good stability

    相對論返波振蕩器是有發展前途的高功率微波源之一，具有電磁結構緊湊、效率高和運行穩定等特點，在國際上受到廣泛重視。
  3. The system exhibits fast response for the load current disturbance and the system always operates at discontinuous conduction current mode so that no slope compensation is required and high efficiency will be achieved when driving 4 leds. the design and analysis of sub - block circuits are provide in the thesis where band gap reference, oscillator, current sensing and over current protection, led load current

    本文完成了各個單元電路的分析與設計，著重分析了帶隙基準源、振蕩器、采樣和過流保護、負載led電流控制和開負載保護五個子電路，對其餘子電路也作了簡要分析。
  4. During the circuit design, the author analyzed the basic principle of the direct current motor, pwm control, h - bridge power driver, and two control techniques of h - bridge power drive circuit, designed its general structure, so the feasibility of the design is confirmed. then, reference, oscillator, power dmos gate drive circuit ( charge pump, bootstrap ), and dead time generation circuit are designed and analyzed in the sub - circuits. a current - controlled oscillator is presented in this thesis

    在電路設計中，作者介紹了直流電機的工作原理和數學模型、脈寬調制（ pwm ）控制原理、 h橋電路基本原理和h橋功率驅動電路的兩種控制模式，設計了驅動電路的總體結構，給出了電路的功能模塊，確定了設計的可行性，然後在子電路模塊中，重點分析設計了基準源電路、振蕩器電路、高端功率管柵驅動電路（電荷泵及自舉電路） 、低端功率管柵驅動電路和死區時間產生電路。
  5. The thesis discussed a parameter extraction program for the mosfet level1 model. in the analysis and design of circuit, at first, the thesis described the system function of the new dc - dc switching converter. then several sub - circuits of converter ic such as oscillator, over - temperature shutdown circuit, auto - restart counter circuit and control circuit were completely discussed

    在電路設計中，本文首先分析了開關電源電路的基本拓撲結構和psm調制模式，接著對開關電源變換器進行了系統的原理分析並設計了總體框圖，然後詳細設計了振蕩器電路，熱保護電路，自動重啟計數器電路和主控門邏輯等子電路並進行了功能模擬。
  6. The precise clock source is crystal oscillator made of 74hc04 ; the mute circuit can conceal the error and solve the problem of noise ; the antenna switching circuit in the receiver is to select one antenna from two which receives signal better. it can improve the quality of the receiving audio signal, restrain the noise effectively and promote the system performance

    高精度的時鐘源是由74hc04構成的晶體振蕩器;靜音電路將出錯的音頻信號進行差錯掩蓋，很好地解決了噪聲問題;接收機採用兩副天線切換工作，提高了音頻信號接收質量，有效地抑制干擾，提升了系統的性能。
  7. The concept of " timing " in the article is not the clock in our ordinary living, but syntheses which is made up of some frequency source in the signal generator ( such as cs atom frequency standard, rb clock & high accuracy quartz crystal oscillator ) which produces the primary frequency, the matching input interface and the matching output interface and controlling circuit etc. for example, bits is a kind of timing equipment, which is used to control the timing of some functions

    本文論及的「時鐘」概念不是指日常生活中使用的鐘表，而是由產生基準頻率的信號發生器（如銫原子頻率標準、銣鐘及高精度石英晶體振蕩器等）中的某種頻率源以及相配套的輸入、輸出介面和控制電路等組成的一整套具有特定同步定時功能的綜合體。如bits就是一種時鐘設備，它提供用在通信系統中控制某些功能的定時的時間基準設備，時鐘提供的信號稱為基準信號、定時信號或同步信號。
  8. Single frequency source is usually used as local oscillator in communication system and radar system, also as a reference clock in digital circuits, so it is a extensive - applied technique

    固定頻率源可以在在通訊系統和雷達系統中作為本機振蕩器，也可以作為數字電路的基準時鐘信號，因此得到了廣泛的應用。
  9. Using current controlled conveyors, the designs of active components, function circuits, filters and oscillators have been systematically presented in this paper. the circuits are not only easy to integrated, but also adaptable

    本文系統歸納和提出了以電流控制傳送器為積木部件設計有源器件、運算器件、濾波器和振蕩器的方法，所設計的電路不但易於集成，而且具有輸出可調的特性。
  10. In the thesis, some of the most important functional modules of the smart power control ics are researched and designed, including voltage reference, voltage regulator, under voltage lockout, oscillator and zero - voltage comparator. their topologies, schematics and layouts are introduced and developed

    本畢業設計研究和提出了構成智能電源控制晶元的主要功能模塊，完成了其中若干模塊ip核的電路與版圖設計? ?包括基準電壓源，電壓調節器，欠壓鎖定比較器，振蕩器，電壓過零比較器等。
  11. The current source plays an important part in the performance of the oscillator. with the help of the voltage reference, we design a constant current source which does not vary with the temperature 、 the voltage source and the process

    由於充放電電流對弛張振蕩器的性能有很大的影響，因此本文把基準電壓源結合在一起設計出一個受溫度、電源電壓、工藝條件影響很小的基準電流參考源。
  12. In this paper, we introduce the methods to test the tiny capacitors and analyse the principle of relaxation oscillator used in the readout circuits for silicon capacitive accelerometers. to form a complete relaxation oscillator, we design the current source 、 the switch 、 the control logic and the comparator

    本文介紹了微小電容的各種測試方法，分析了採用弛張振蕩器進行測試的原理，並設計出了構成弛張振蕩器所需的電流源、電流開關、控制邏輯以及比較器。
  13. In this circuit, reference current sources are used to charge and discharge capacitors. this oscillator ’ s output is very ideal through control circuit under 5. 7v reference voltage, and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted. and the changes of temperature and voltage affect stabilize of the frequency little

    此電路利用系統內部基準源產生的電流信號來對電容進行充放電，然後經過控制電路作用后，產生的輸出振蕩波形的上升時間和下降時間非常小，更接近理想矩形波形;通過調節基準源電流信號或者電容值大小，可調節振蕩波形的頻率和占空比，同時溫度和電壓的變化對振蕩器輸出波形頻率穩定度的影響很小。
  14. Applying the criterion of the work state of operational amplifier, the stable operating condition of voltage - controlled voltage source filter 2 is proved in detail and the condition that the filter can be used as the sinusoidal oscillator is given

    摘要利用運放工作狀態的判據，系統地證明? 4種二階壓控電壓源型濾濾器穩定工作的條件，同時給出了用作正弦波振蕩器的條件。
  15. On the basis of physical concept, applying mathematical method, the condition that the problem can be transformed from the voltage - controlled voltage source lpf of two orders to the sinusoidal oscillator is proved and the calculation formula of oscillatory frequency is presented

    摘要以物理概念為基礎，利用數學手段證明?二階壓控電壓源lpf轉化為正弦波振蕩器的條件，同時給出了振蕩頻率的計算式。
  16. With consideration of parameters trade - offs involved in the circuits, the vco ’ s topology is designed

    考慮壓控振蕩器設計指標的相互約束條件，盡可能減小相位噪聲的來源，設計電路的拓撲結構。
  17. And then, based on the above theories, the circuit design and simulation means have been concretely applied in the internal modules of voltage reference, bias circuit, oscillator, error amplifier and drive circuit of the chip and so on. the relevant design indexes are successfully achieved. at last, the whole circuit simulation and layout design are completed

    在此理論基礎上對該電源晶元內部的各個模塊，如電壓基準源、偏置電路、振蕩器、誤差放大電路和驅動電路等模塊進行了具體的電路設計和分析模擬，且達到了相應地設計指標，最後，完成了整體電路模擬和版圖設計。
  18. In the thesis, some of the most important functional modules of the pwm power control ics are designed and simulated, including error amplifier, voltage reference, voltage regulator, comparator, and oscillator. the topologies, schematics and layouts of some circuits are introduced and developed

    本畢業設計研究和提出了構成pwm電源控制晶元的主要功能模塊，設計了其中主要模塊ip核的多種結構電路並進行了模擬，完成了部分電路的版圖設計? ?包括誤差放大器，基準電壓源，電壓調節器，比較器，振蕩器等。
  19. Based on the whole chip function requirements, sub - block design and simulation were completed, including bandgap voltage reference, oscillator, slope compensation, current sensing, control and drive logic

    在子電路的設計上，作者主要介紹了帶隙基準電壓源、振蕩器、斜坡補償、電流感應、控制和驅動邏輯。
  20. A typical calculator chip from rcl semiconductor inc, c9821, is referenced and developed. the chip of the calculator consists of several function units such as rc oscillator, power management module, microprogrammed control unit ( mcu ), register group, lcd driver and keyboard interface

    在硬體方面，在完成計算器的功能模塊劃分的基礎上，對包括rc振蕩器、電源模塊、 lcd顯示驅動模塊、鍵盤介面、寄存器組、微程序控制器在內的各個功能模塊的系統結構和電路原理進行了分析，掌握了它們的設計方法。
分享友人
分享到 Line

分享到臉書