振蕩模推頻 的英文怎麼說

中文拼音 [zhèndàngtuībīn]
振蕩模推頻 英文
mode pushing
  • : 動詞1. (搖動; 揮動) shake; flap; wield 2. (奮起) brace up; rise with force and spirit
  • : Ⅰ動詞1 (搖動; 擺動) swing; sway; wave 2 (無事走來走去; 閑逛) loaf; wander; roam; loiter; go a...
  • : 模名詞1. (模子) mould; pattern; matrix 2. (姓氏) a surname
  • : 動詞1 (向外用力使物體移動) push; shove 2 (磨或碾) turn a mill or grindstone; grind 3 (剪或削...
  • : Ⅰ形容詞(次數多) frequent Ⅱ副詞(屢次) frequently; repeatedly Ⅲ名詞1 [物理學] (物體每秒鐘振動...
  1. According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

    本文首先介紹了ld泵浦nd : yag激光器的發展狀況、主要特性及其應用,從四能級速率方程出發,導了ld泵浦nd : yag激光器的閾值、輸出功率和斜效率的表達式,並簡述了激光器的工作原理、結構型式和倍方法;其次,以空間相關的速率方程為基礎,提出了ld端面泵浦nd : yag激光器的設計方法,給出了一定泵浦耦合方式下,尺寸、最佳輸出耦合率、泵浦光尺寸、泵浦光焦斑位置等參數的選取依據,以此為依據,設計了自聚焦透鏡耦合小功率ld泵浦nd : yag激光器和透鏡組耦合高功率ld泵浦nd : yag激光器,對激光器的輸出功率和功率穩定性等特性進行了實驗研究;再次,在帶尾纖輸出的高功率ld泵浦nd : yag激光腔內插入一隻空液晶盒,觀察到了激光器以單縱運轉;最後,根據泵浦光焦斑端面位置對激光輸出功率的影響規律,提出了ld端面泵浦nd : yag激光位移傳感新方法,並進行了理論和實驗研究,研究結果表明:當激光晶體內泵浦光平均光斑半徑遠小於西安理工大學碩士學位論文光束腰半徑時,激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律,測量范圍和靈敏度依賴于泵浦功率,隨著泵浦功率的增加,測量范圍擴大,靈敏度提高,當端面泵浦功率為7 . 24w (最大輸出功率為1 . 926w )時,激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。
  2. ( 1 ) through simulations on jtl with different parameter conditions, the new phenomenon of annihilation and passing through of voltage pulses are founded, and the conditions are obtained at the same time ; ( 2 ) the jtl ring oscillator is utilized in studying the repulsion effect of pulses on jtl, thus the bounded influence is eliminated, and precision results can obtained

    ( 2 )首次將jtl環器結構應用到jtl某些傳輸特性的分析上來,消除了端界的影響,使分析更為精確;如對斥效應的擬就獲得了良好的效果。斥效應的研究使我們認識到rsfq的工作率在某種程度上要受其效應的制約。
  3. Firstly, the oscillator theory was researched as the base of the design of oscillator - type aia in this paper. the derivation of oscillation condition and stability condition were given ; at the same time, the cavity modeling theory of microstrip antenna was studied, which gave the relation between the size of microstrip antenna and the resonate frequency and that between the size and impedance of microstrip antenna

    首先,針對本文所討論的型有源集成天線,作為理論基礎,進行了器理論的研究,導出有源集成天線的條件和穩定條件;同時利用空腔理論,給出了天線尺寸與諧率和輸入阻抗的關系。
  4. The equivalent cavity model is used to deduce the threshold condition of the ecld, and the expression of the threshold carrier density n ( v ) when ecld is tuned to oscillate at different frequencies has been obtained. using the expression of n ( v ) and the carrier dependent refractive index, the simple basic equation describing the bistable characteristics has been derived after choosing an appropriate reference frequency nf

    通過建立等效腔型來導外腔半導體激光器的閾值條件,得到ecld在不同率v所需的閾值載流子密度n ( v )表達式,利用該表達式及相關的折射率表達式,在選擇合適的參考載流子密度n _ f后,導出了一個描述雙穩所需的基本方程。
分享友人