排煙測試 的英文怎麼說

中文拼音 [bèiyāncèshì]
排煙測試 英文
smoke test
  • 排 : 排構詞成分。
  • 煙 : Ⅰ名詞1 （物質燃燒時產生的氣體） smoke 2 （像煙的東西） mist; vapour 3 （煙草） tobacco 4 （紙煙、...
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 排煙 : eject smoke; discharge smoke排煙道 smokejack; discharge flue; 排煙器 smoke ejector; 排煙裝置 fume extractor
  • 測試 : test; testing; checkout; measurement
  1. Analysis of experimental data indicates that there exist several following problems during the whole operation : first, the emission is serious and the density of hc and co smoke is very high at on and off period. second, there is oil dripping from the dripping vitta as a result of the fault of ignition system and combustion structure. the last, there might be accidents of disabled ignition resulted from the improper operation at the beginning

    通過對樣機的試驗分析和研究表明，汽車空氣燃油加熱器在整個工作過程中，其排放存在以下三個問題：一、開機和關機兩個階段的排放問題嚴重，廢氣中hc和co的濃度值及煙度測量值都很高；二、因點火系統和燃燒結構的缺陷而導致開機后一段時間內有油滴從滴油管滴落；三、在點火過程中，會出現因操作不當而點火失效的現象。
  2. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  3. Relative accuracy test evaluation for flue gas continuous emission monitoring systems

    煙氣連續排放監測系統相對準確度的測試評估
  4. Laboratory methods of testing fans used to exhaust smoke in smoke management systems

    煙塵管理系統中排氣扇測試的實驗室方法
  5. Measuring engine transient process data in ca1258p1k2l11t1 truck in accelerated mode, recording and analyzing the data, then analysis the test error. 4. building model and simulating two typical running mode ? fixed 6th gear acceleration with initial vehicle speed 40km / h and gear change acceleration starting with 2nd gear, comparing calculated result with test result, revising transient process simulation model and analyzing error between calculation

    本文基於ca1258p1k2l11t1載重卡車對ca6df2 - 26發動機的瞬變工況進行試驗和模擬計算，結果表明: 1 ） gt - power軟體可以很好的模擬、分析、預測發動機瞬變過程，模擬計算的結果與試驗結果很接近，試驗證明，預測分析指出的改進方向是正確的; 2 ）加裝電動增壓器可以降低整車使用油耗，改善低速煙度排放，縮短加速時間，改善整車的加速響應; 3 ） gt - power軟體預測分析配合發動機和整車試驗是分析、解決發動機瞬變過程的有力工具。
  6. In order to solve the problems effectively, under the auspices of 863 plan in china, the synthesis diagnosis has been carried by means of measuring and numerical imitating the combustion chamber of refining column, and some conclusions is such as : ( 1 ) through measuring the temperature and combustion in the burning chamber of the refining column, the result shows the temperature difference on the same level is more than that in height direction, and there is a few of co in bottom of burning chamber. ( 2 ) in order to ensure normal work of flue system in lead column in the course of zinc refining, theoretic calculation and measure about the flow resistance of exhaust gas are carried through. the results of study reveal that drawing out force of chimney is inadequate, which is mainly caused by illogicality of flue construction

    在研究過程中，採取了現場實測和數值模擬手段對韶關冶煉廠鋅精餾鉛塔燃燒室及排煙系統進行了綜合診斷，具體結果包括如下： （ 1 ）完成鋅精餾鉛塔燃燒室內溫度測試以及燃燒狀況的測試，結果發現：鉛塔燃燒室內水平方向的煙氣溫度並非均勻，而且其溫差比上下方向的溫差更大，以及鉛塔燃燒室尾部存在co未燃燼問題； （ 2 ）為了保證鉛塔煙氣系統的正常工作，對煙道系統的阻力進行了理論計算及測試分析，結果發現：鋅精餾鉛塔煙氣系統中煙囪抽力不夠，這主要是煙道結構不合理所造成的。
  7. Agricultural tractors - test procedures - part 13 : measurement of exhaust smoke

    農業拖拉機試驗規程第13部分：排氣煙度測量
  8. Reciprocating internal combustion engines - exhaust emission measurement - test cycles and test procedures for field measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions

    往復式內燃機.排放測量.壓燃式發動機瞬態工況時排氣煙度現場測量用試驗周期和試驗方法
  9. Reciprocating internal combustion engines - exhaust emission measurement - part 9 : test cycles and test procedures for test - bed measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions

    往復式內燃機.廢氣排放測量.第9部分:瞬時條件下工作的壓縮點燃裝置的廢氣煙霧排放的試驗床測量的試驗循環和試驗過程
  10. Reciprocating internal combustion engines - exhaust emission measurement - part 10 : test cycles and test procedures for field measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions

    往復式內燃機.廢氣排放測量.第10部分:壓力點火燃式發動機在瞬時工作狀態下排放的燃氣煙霧現場測量的試驗周期和試驗程序
  11. Reciprocating internal combustion engines - exhaust emission measurement - part 9 : test cycles and test procedures for test bed measurement of exhaust gas smoke emissions from compression ignition engines operating under transient conditions

    往復式內燃機.廢氣排放的測量.第9部分:瞬間條件下工作的壓縮點火發動機廢氣煙霧排放的試驗床測量的試驗周期和試驗程序
  12. This model correctly judges the slagging tendency of a kind of coal - water slurry. measurements are taken of the temperature field, flame emissivity, superheater tube wall temperature, exhaust gas temperature and composition

    本文介紹了燃油鍋爐改燒水煤漿后爐內傳熱及其污染物的排放測試結果，包括溫度場、火焰黑度、過熱器管壁溫度、排煙溫度、排煙成分。
  13. Calibrated chronometers are also used to check the duration of dark smoke emission from chimneys by the environmental protection department and in testing construction materials by the housing department.

    此外，環境保護署及房屋署都需要準確計時器，分別用來驗查煙囪排放黑煙的時間及測試建築物料等。
  14. Reciprocating internal combustion engines - exhaust emission measurement - test cycles and test procedures for test - bed measurement of exhaust gas smoke emissions from compression ignition engines operating under transi ent conditions

    往復式內燃機.排放測量.壓燃式發動機瞬態工況排氣煙度試驗臺測量用試驗周期和試驗方法
  15. Health and safety in welding and allied processes - laboratory method for sampling fume and gases generated by arc welding - part 1 : determination of emission rate and sampling for analysis of particulate fume

    焊接和相關工藝的衛生與安全.電弧焊產生的煙塵和氣體取樣的試驗室方法.第1部分:顆粒煙塵排放率的測定和顆粒煙塵分析用取樣
  16. Variety rule and influence factor of smooth operation, satisfactory performances and smoke are analyzed on the test result that the optimum emulsified diesel oil compared diesel oil through rig test and smoke test. burning the optimum emulsified diesel oil compared diesel oil, satisfactory performances of fuel are improved 21. 3 %, smoke reduced43. 48 %

    以燃用最佳配比乳化油與標準輕柴油的發動機臺架性能和煙度檢測對比試驗結果，分析了發動機燃用該種乳化油的動力性、經濟性和排放性的變化規律及其影響因素。
  17. Health and safety in welding and allied processes - laboratory method for sampling fume and gases generated by arc welding - part 2 : determination of emission rates of gases, except ozone

    焊接和相關工藝中的衛生和安全.電弧焊產生的煙塵和氣體取樣的試驗室方法.第2部分:除臭氧外的氣體排放率測定
  18. Despite the rb2 ' s much - publicised cooling problems in pre - season testing, the rb2 sports just a few additional venting gills underneath the venting chimneys ( red arrows and magnified area )

    Rb2在季前測試時眾所周知有冷卻上的問題，工程師在煙囪式排氣口之下增加了額外的鰓狀排氣口（紅色箭頭處和放大的區域） 。
  19. Abstract : in this paper we analyzed the co and nox emission from water heaters and the pollution to kitchen environment by using the test data in kitchen environment and the concentration of harmful gas in flue gas discharged from water heaters working in different conditions

    文摘:利用燃氣快速熱水器在不同使用工況下，煙氣中有害氣體含量及廚房環境測試數據，分析了熱水器排放及其對廚房環境的污染情況。
分享友人
分享到 Line

分享到臉書