推挽變換器 的英文怎麼說

中文拼音 [tuīwǎnbiànhuànqì]
推挽變換器 英文
push pull converter
  • 推 : 動詞1 （向外用力使物體移動） push; shove 2 （磨或碾） turn a mill or grindstone; grind 3 （剪或削...
  • 挽 : 動1 （拉） pull; draw 2 （向上卷） roll up 3 （牽引） pull; draw 4 （哀悼死者） lament sb s death...
  • 換 : 動詞1. （給人東西同時從他那裡取得別的東西） exchange; barter; trade 2. （變換; 更換） change 3. （兌換） exchange; cash
  • 器 : 名詞1. （器具） implement; utensil; ware 2. （器官） organ 3. （度量; 才能） capacity; talent 4. （姓氏） a surname
  1. Then novel circuit structure of bi - directional voltage mode ( based on forward converter ) inverters with high frequency link, are proposed, which is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filter ; the circuit topologies family of this bi - directional voltage mode inverters with high frequency link include six circuit topologies, such as push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controlled bi - directional voltage mode inverters with high frequency link is introduced

    本文首先論述了dc / ac逆變技術的應用前景及發展現狀。基於正激forward變換器的雙向電壓源型高頻環節逆變器電路結構，由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成;雙向電壓源高頻環節逆變器電路拓撲族，包括推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式六種電路。
  2. This paper introduces the fundamental and characteristic of the fuel cell, analyzes the necessity and detail scheme of adding assistant energy sources to the fuel cell power generation system. considering for the special demand of the fuel cell power generation system, this paper gives out a push pull forward converter ( ppfc ) with passive and lossless dual cdd snubber circuit

    本文首先闡述了燃料電池的基本原理和性能特點，分析了在燃料電池發電系統中引入輔助能源系統的必要性及具體的配置方案，然後針對燃料電池發電系統對dc / dc變換器設計的特殊要求，提出了一種加雙cdd無源無損緩沖電路的推挽正激變換器（ pushpullforwardconverter ， ppfc ） 。
  3. A new soft - switching push - pull three - level converter

    一種新型軟開關推挽三電平直流變換器
  4. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  5. The analysis of ppf ’ s operation principle is introduced in detail in this paper. further more, the effect on the circuit operation is also analysed, which caused by clamping capacitance and different transformer leakage inductance value

    本文首先深入研究了推挽正激變換器的工作原理，分析了穩態條件下的工作模態，同時分析了箝位電容與變壓器原邊漏感的大小對于工作模態的影響。
  6. With the best modulation strategy which was found on condition that it must have largest energy transfer ratio, smallest current ripple of the inductor, and realizing zvs of each switches, the converter overcomes the drawbacks presented by the conventional zvs fb converter, such as high voltage stress of each switches, large current ripple of the inductor, and severe parasitic ringing on the rectifier diodes, so it can get higher efficiency, faster respond speed, and wider application area. the operation principle of the proposed converter is analyzed and verified by a 3kw, 50khz experimental prototype. experiments and research results show that the scheme of the tl topology derivation is reasonable, adjusted modulation strategy makes some other severe problems in conventional topologies easy to solve or makes the converter more competitive

    研究結果表明，本文提出的三電平拓撲變換方案合理，針對各種三電平拓撲尋找到的控制策略可以解決變換器存在的某些問題或使變換器表現出更突出的優勢：例如針對單管直流變換器三電平拓撲的控制策略可以減小電感的設計值，針對推挽直流變換器三電平拓撲的控制策略可以實現開關管的軟開關、解決變壓器偏磁問題等，針對全橋直流變換器三電平拓撲的控制策略可以減小電感的設計值、實現開關管的軟開關等。
  7. Comparing with usual push - pull converter, the bias - magnetic can be retrained due to the clamping capacitance. but bias - magnetic can not be avoided

    推挽正激變換器相比普通的推挽式變換器，由於箝位電容的存在，偏磁可以被抑制，但並不能完全消除。
  8. The push - pull tl converter can be deduced by using the basic tl topology derivation and by special derivation only used in this topology, in which, the voltage stress of each switches is input voltage

    應用三電平拓撲的基本變換方法，經過對該拓撲結構的特殊變換，得到了推挽三電平直流變換器的拓撲，其開關管的電壓應力為輸入電壓，與傳統推挽直流變換器相比，電壓應力降低了一半。
  9. These methods all can be used to solve the magnetic aberration hi the conventional push - pull converter

    這兩種方式均可以解決傳統推挽直流變換器存在的偏磁問題。
  10. In this dissertation, a novel bidirectional dc / dc converter ' s topology was designed, witch used in vehicle power supply systems. the converter is composed of fundamental bidirectional switch cell, using phase - shifted full - bridge zvs pwm dc / dc converter in buck circuit and using push - pull boost converter in boost circuit

    文中從雙向dc dc變換基本單元入手，針對某大型車載電源系統設計了一種新型雙向dc dc變換器拓撲電路，降壓變換採用移相全橋式zvs ? pwm功率變換，升壓變換採用推挽式dc dcboost功率變換。
  11. The circuit topologies family of voltage mode ac - ac mode ac / ac converters with high frequency link include eight circuit topologies, such as single forward mode, interleaved - forward mode, push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. the circuit topologies family of current mode ac - ac mode ac / ac converters with high frequency link include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controll is introduced

    電壓源交?交型高頻環節ac ac變換器電路拓撲族，包括單正激式、並聯交錯正激式、推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式八種電路；電流源交?交型高頻環節ac ac變換器電路拓撲族，包括單四象限功率開關式、推挽式、半橋式、全橋式四種電路。
  12. Then novel circuit structure and circuit topologies family of current source ac / ac converters with high frequency ac link, based on flyback converter, are proposed. the circuit structure which can transfer one unregulated sinusoidal voltage with high thd into another regulated constant frequency sinusoidal voltage with low thd, is constituted of input cycloconverter, high frequency storage transformer, output cycloconverter, input and output filter. the circuit topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits

    本文提出了基於反激flyback變換器的電流源高頻交流環節ac ac變換器電路結構及其拓撲族，該電路結構由輸入周波變換器、高頻儲能式變壓器、輸出周波變換器以及輸入、輸出濾波器構成，能夠將一種不穩定劣質的正弦交流電變換成另一種同頻率穩定的優質正弦交流電壓；該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式等四種電路。
  13. Push - pull current mode hfl inverter also is composed of four power switches. the simulation and experiment of a 500va experimental prototype indicates that this circuit has the advantages of less components, simple topology, the ability of four quadrant operation and high efficiency. the inverter does not need the symmetry of the components " parameters and can be applied to dc to ac conversion with single low input voltage source

    推挽雙向電流源高頻鏈逆變電路也是由四個功率管組成， 500va的原理樣機的模擬和實驗研究結果表明，該電路元器件少、電路拓撲簡單、能夠四象限可靠運行、變換效率高，並不要求器件參數的完全對稱，適合於輸入電壓較低的場合。
分享友人
分享到 Line

分享到臉書