摩擦和磨損 的英文怎麼說

中文拼音 [mócāhémósǔn]
摩擦和磨損 英文
friction and wear
  • 摩 : 摩構詞成分。
  • 擦 : 動詞1 （摩擦） rub 2 （用布、 手巾等摩擦使干凈; 揩拭; 抹） wipe; scrub; clean 3 （塗抹; 搽） spre...
  • 和 : 和動詞（在粉狀物中加液體攪拌或揉弄使有黏性） mix （powder） with water, etc. : 和點兒灰泥 prepare some plaster
  • 磨 : 磨動詞1 （摩擦） rub; wear 2 （研磨） grind; mull; polish 3 （折磨） grind down; wear down [out]:...
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 摩擦 : 1 （互相接觸的兩物體作來回相對運動） rub; chafe 2 [物理學] （相互接觸的兩物體在接觸面上發生阻礙相...
  • 磨損 : wear and tear; abrasive wear; abrase; abrade; detrition; wear; scuff; wear out; fray; battering; ...
  1. Testing coated fabrics - method 16 - methods for determination of colour fastness to wet and dry rubbing and determination of resistance to printwear

    塗覆織物試驗.方法16 .濕摩擦和干摩擦色牢度及印花耐磨損性測定方法
  2. Thus it improves the lubricating performance of friction pairs. 2 ) under heavy load and high - temperature conditions, the nanometer cao particles between two friction surfaces are flattened and form a sliding system

    （ 2 ）在重載和高溫條件下，兩摩擦表面間的納米氧化鈣顆粒被壓平，形成一滑動系，降低了摩擦和磨損。
  3. 05. 02 calibration and operation of the alpha model lfw - 1 friction and wear testing machine, method for

    型lfw - 1摩擦和磨損試驗機的校準和操作方法
  4. Under the condition of distilled water working as lubricant, the weight percentage of cu or cuo powder in composites has less influence on tribological properties of composites

    在水潤滑條件下， cu粉或cuo的填料含量對復合材料摩擦和磨損性能影響很小。
  5. In the study of the wear resistance, friction coefficient and wearing quantity were mainly investigated, and their changing tendency in a tribological process was made clear through experiments

    在研究表面耐磨性時，本文主要考慮了磨損過程中摩擦系數和磨損量的變化。
  6. Extreme pressure ( ep ) additive ? chemical compound imparting extreme pressure characteristics to a lubricant with the objecfive of reducing wear under conditions where rubbing or sliding accompanies high contact pressures ， as in heavily loaded gears ， particulars of the hypoid type

    極壓（ ep ）添加劑在伴隨著高接觸壓力的摩擦和滑動的情況下（如：在重載齒輪，特別是準雙曲面型齒輪中） ，能夠賦予潤滑油抗極壓性能，以達到減輕磨損目的的化合物。
  7. Extreme pressure ( ep ) additive _ chemical compound imparting imparting extreme pressure characteristics to a lubricant with the objective of reducing wear under conditions where rubbing or sliding accompanies high contact pressures, as in heavily loaded gears, particulars of the hypoid type

    極壓（ ep ）添加劑在伴隨著高接觸壓力的摩擦和滑動的情況下（如：在重載齒輪，特別是準雙曲面型齒輪中） ，能夠賦予潤滑油抗極壓性能，以達到減輕磨損目的的化合物。
  8. Guideline for reporting friction and wear test results of manufactured carbon and graphite bearing and seal materials

    人造碳和石墨軸承與密封材料的摩擦力和磨損結果報告指南
  9. Wear particle ' s automatic recognition and analysis is one of the most important but difficult key problem in the realization of automatic machine wear monitoring and intelligent diagnosis system

    機器設備摩擦副磨屑微粒（磨粒）是判斷運行中摩擦副磨損狀態的主要依據，而磨粒的定量分析描述與自動識別，長期以來一直是設備磨損狀態監測與故障診斷信息流程中最為復雜和亟待解決的關鍵問題。
  10. Drilling time will be lasted and lateral force on casing exerted by drill pipe will increase in case of drilling deep well, ultradeep well, high inclined hole, extended reach well and horizontal well, therefore, friction and wear between casing and drill pipe became a severe problem

    在深井、超深井、大斜度井、大位移井及水平井中，鉆井時間延長、鉆柱作用在套管上的側向力增高，因此套管和鉆柱的摩擦與磨損問題越來越突出。
  11. Pairing up with steel and at the condition of dry friction, the pure uhmwpe has an increasing friction coefficient and wear value with the increase of sliding velocity, and so does its composites. the uhmwpe - base composite reinforced by cu powder which makes up 15 % of the composite by weight and the uhmwpe - base composites reinforced by cuo powder which makes up 10 % - 15 % of the composites by weight are more capable of enduring higher sliding velocity than the pure uhmwpe

    在與鋼配副、干摩擦條件下，隨滑動速度的增大， uhmwpe及其復合材料的摩擦系數和磨損量都增大，質量分數為15的cu粉填充uhmwpe復合材料和質量分數為10 15的cuo填充uhmwpe復合材料承受高速的能力強于純uhmwpe 。
  12. Summarizing and discussing the usual wear fault and wear kinds of the general mechanical equipment. engines of self - propelled gun are the main discussed targets, the component of the friction pairs and wear fault rules of which are analyzed. building the belter base for carrying out wear state monitoring further

    總結和討論了一般機械設備常見的磨損故障和磨損類型，並以自行火炮的發動機為重點研究對象，分析其主要摩擦副的材料組成和磨損失效規律，為進一步實施磨損狀態監測奠下良好的基礎，討論了自行火炮潤滑油變質原因和機理。
  13. Wear particles generated from the friction couples are important information carrier of wear condition, which directly reflect wear degree and wear mode

    在潤滑系統中，磨粒是磨損狀態的重要信息載體，可以反映機械設備摩擦副磨損的程度和形式。
  14. It has the properties of no friction, no fray, dispense with lubricate, lasting life, all extrude excellence above which ca n ' t be seen in traditional roll bearing and sliding bearing

    其具有無摩擦、無磨損、無需潤滑以及壽命長等一系列傳統的滾動軸承和滑動軸承所無法比擬的優點。
  15. Test method for measuring friction and wear properties of ep lubricating oils using the srv test machine

    用srv試驗機測量ep潤滑油摩擦和磨損特性的試驗方法
  16. Active magnetic bearing ( amb ) is one of typical electronic & mechanical products and a new type of high performance bearing piece. it has the properties of no friction, no fray, dispense with lubricate, lasting life, all extrude excellence above which ca n ' t be seen in traditional roll bearing and sliding bearing

    主動磁軸承是典型的機電一體化產品，是一種新型的高性能支承部件，其具有無摩擦、無磨損、無需潤滑以及壽命長等一系列傳統的滾動軸承和滑動軸承所無法比擬的突出優點。
  17. Plain bearings. terms, definitions and classification. part 2 : friction and wear

    普通關節軸承.術語定義和分類.第2部分:摩擦和磨損
  18. Plain bearings - testing of friction and wear of precision engineering bearings in the slpg - tester

    滑動軸承. slpg試驗機精密工程軸承的摩擦和磨損測試
  19. Applying magnetic levitation technology, the stage is suspended on the trail of inverse " f ", thus the wear and tear is eliminated, linear motor non - contact drive makes precise position of stage

    利用磁懸浮技術將工作臺懸浮在倒f導軌上，消除了導軌的摩擦和磨損；直線電機無接觸驅動實現了工作臺的精密定位。
  20. Amb has a number of outstanding characteristics, such as no friction, no wear, no pollution and long service life, is beyond of rolling and film element bearing

    主動磁軸承具有無摩擦，無磨損，無需潤滑以及壽命長等一系列傳統的滾動軸承和滑動軸承無法比擬的突出優點。
分享友人
分享到 Line

分享到臉書