擰接機 的英文怎麼說
中文拼音 [nǐngjiējī]
擰接機
英文
screw-on machine-
In the joint of lg pex - a pipe, male xocket is pressed to a convex on the inserting part and the fastening ring will contract to fasten up the heating pipe by the fastening of outer nut, and there is also a convex on the ring to offer close coupling by mechanical re - press effect to prevent water from leaking in case of heat expansion
在lg地熱管中的連接部位不僅閥門管套插入部分的凸起部位被機械作用壓密,而且隨著外部螺母被擰緊,使緊固環收縮,從而帶緊熱炕暖氣管,另外由於存在凸起部位,可通過機械作用進行再次壓密,因此可防止由於熱膨脹而引起漏水。Connect copper pipes, lines and water pipes with indoor parts. connectors should be tightened to prevent leakage
將銅管、連接線、水管與室內機連接好,銅管接頭必須擰緊,不能有泄漏現象,排水管不能有漏水現象。The preparing work before test run : first organize test run guide group consisted of supply party, demand party and installation party to check the installed qualified equipment ( machine, electricity, liquid, gas ) in an all - round way to see that circuit, water - way, gas - way and oil - way are switched on ; that all fastener, bolts and nuts are tight ; that all lubricating points and cooling points are put in position
試運轉前的準備工作:首先應組織有關(供方、需方、安裝)等單位參加的試車領導小組,對已安裝合格的設備(機、電、液、氣)進行全面的檢查,電路、水路、氣路、油路是否接通,所有設備的緊固件、螺栓、螺母等是否擰緊,各潤滑點和冷卻點是否到位。
分享友人