故障單位 的英文怎麼說

中文拼音 [gùzhàngdānwèi]
故障單位 英文
trouble unit
  • 故 : Ⅰ名詞1 （事故） event; incident; happening; accident 2 （原因） cause; reason 3 （朋友; 友情） fr...
  • 障 : Ⅰ動詞（阻隔; 遮擋） block; hinder; obstruct Ⅱ名詞（遮擋物） barrier; block; obstacle
  • 位 : Ⅰ名詞1 （所在或所佔的地方） place; location 2 （職位; 地位） position; post; status 3 （特指皇帝...
  • 故障 : hitch; breakdown; stoppage; fault; faulting; accident; blunder; bug; conk; failure; impairment; i...
  1. To maintain the solvency with necessary insurance company, safeguard insurance company is dovish manage, insurance code is decided, insurance company is right each dangerous unit, the responsibility that the place of limits of the biggest loss that creates possibly to insurance accident namely assumes, must not more than actually capital gold adds the 10 of accumulation fund summation ; exceeded share, ought to deal with reinsurance

    為了維持保險公司必要的償付能力，保障保險公司穩健經營，保險法規定，保險公司對每一危險單位，即對一次保險事故可能造成的最大損失范圍所承擔的責任，不得超過其實有資本金加公積金總和的10 ；超過的部分，應當辦理再保險。
  2. Secondly, introducing the image analyzing technology with reference to the disadvantages of the traditional ferr - graph analysis technology, and with the combination of characteristic parameter optimizing filtration so as to raise a description method of debris micro - morphologic character. thirdly, with the application of mode recognition method, completing the process of debris auto - recognition based on the collected information of the debris configuration characteristics ; and conducting the diagnosis on the aero - engine wear faults according to the theory of particle tribology. fourthly, introducing information fusion technology to solve the problem that a single method can not collect enough fault premonitory information to conduct the wear fault diagnosis, hence to conduct the research and exploration in the field of comprehensive diagnosis on the aero - engine ' s multi - fault premonitory information

    本文的研究工作主要包括以下五個部分：首先，介紹航空發動機常見的磨損故障類型，研究磨損故障的失效機理，分析磨粒的產生機理、分類以及形態特徵：其次，針對傳統鐵譜分析技術的缺點，引入圖像分析技術，再結合特徵參數優化篩選，形成基於圖像的磨粒顯微形態學特徵描述方法：然後，基於提取到的磨粒形態特徵信息，應用模式識別方法完成磨粒自動識別，並根據顆粒摩擦學的基本原理進行航空發動機磨損故障的診斷與定位：再后，鑒于單一方法不能提取足夠的故障徵兆信息進行磨損故障診斷，本文引入信息融合技術，開展航空發動機多故障徵兆信息綜合診斷方法的研究與探索；最後，基於航空發動機滑油光譜分析與鐵譜分析數據，應用時序模型、灰色模型以及組合模型進行磨損故障的預測方法研究。
  3. Line - to - ground fault location maintains unresolved to power distribution networks for a long time

    而配電網的單相接地故障定位長期以來是難以解決的課題。
  4. An automatic fault location method is proposed based on ftu after the circuit analysis of single line - to - ground fault in distribution networks

    通過對配電網發生單相接地故障后饋線的電壓、電流變化規律的分析，論文提出了基於饋線現場監控終端ftu的故障點智能定位方法。
  5. Based on the main fault - character analysis of single line - to - ground fault in non - grounded distribution networks, the location algorithms by injecting current are proposed for diagnosing and locating faults

    基於對配電網發生單相接地故障后的故障主要特徵的分析，論文應用加信診斷方法，提出了相應的接地故障定位演算法。
  6. Accident averted after faulty electrical switch fixed

    即時解決單位電掣故障，免生意外
  7. It includes four criterions of locating fault point ? “ transient zero sequence current amplitude law ”, “ stable base wave zero sequence current phase law ”, “ stable seventh harmonic zero sequence current phase law ” and “ s injection law ”. pointing out how the law locate the fault point to minimal fault section by applying these criterions gradually. the law will not only make up the blemishes existing in current methods for single - phase fault location in small current grounding system, but also locate the fault point to minimal fault isolating unit on fault line

    該方法通過將所包含的四個定位判據- 「暫態零序電流幅值法」 、 「穩態基波零序電流方向法」 、 「穩態7次諧波零序電流方向法」和「 s信號注入法」 -進行有選擇地遞進使用，不僅有效彌補了目前已有小電流接地系統單相接地故障選線的缺陷，更將故障定位在故障線路最小故障區段。
  8. The others is fire faul prevenion scheme of double diminuive computer plus disk mp which is a magnetic tape set in the network for back up, in order to preveni data losing because of mainfraxne systcm is wrong, which ensures data safe

    其它各供電單位採用雙小型機加磁盤陣列的容錯方案，為保證數據的安全，在網路上設置一臺磁帶庫作為數據備份，防止主機系統故障引起的數據丟失。
  9. It includes : dynamic show of technics flow, real time data acquirement and show, history data save and print, fault alarm, etc. the plc control system mainly accomplishes the wastewater technics flow control, harmonizes the logical relationship among local intelligent control instruments and transmits the state of each local equipment to the industrial computer simultaneously, the plc control station receives the control commands from the industrial computer ; the local intelligent units take charge of the correlated parameters measure, disposal and control, and it will transmit the related parameters to the computer, etc. in this thesis, introduced municipal wastewater treatment technics, the integrated application program development of computer, the design method of plc control station, the communication between plc control system and computer, and the network of wastewater treatment with profibus - dp was also discussed

    上位計算機主要實現遠程監測和管理功能，具體包括:工藝流程動態顯示、實時數據獲得及顯示、歷史數據存儲與列印、故障報警等功能plc控制系統主要完成工藝流程式控制制以及協調現場各智能儀表之間的邏輯關系，將現場各設備的運行狀態通過通訊網路傳輸到上位計算機，並接收上位計算機的控制指令;現場各智能儀表單元負責各相關參數的監測和處理、控制，並將有關參數送往上位監控計算機進行處理、保存等。本文以莎車污水處理項目為例，介紹了城市污水處理工藝、上位監控計算機的綜合應用程序開發、城市污水處理自動控制系統plc控制站的設計和採用profibus系列中廣泛應用於現場設備的profibus - dp總線。
  10. In the next place, an improved algorithm of grounding fault location for tree - type distribution system which is based on new fault function and criterion measure, is proposed in order to complete fault branch ide ntification, fault location and fault value. a lot of the simulation of fault diagnosis and location by computer demonstrate that the algorithm is effective

    其次論文基於輻射狀饋線的任一分支線路發生接地故障，通過分析與推導，建構了配電線路單相短路點定位的故障定位函數和相應的故障判據，利用樹網單端信息完成故障分支識別、故障定位和過渡電阻定值。
  11. Since it is immune to load change, immune to the value of grounded resistance change and its parameters can be easily measured, the fault location algorithm can be widely applied to the power distribution networks

    基於此論文還編制了單相接地故障定位的計算機通用程序。該測距演算法不受負載參數變化的影響，不受接地過渡電阻值大小的影響。
  12. In recent years, it has been attracted considerable attention for a mass of researchers on networks in world, and become the hot research area of computer networks, in particular, has been widely used in network fault - location, performance measurement and count expense etc. based on careful analysis on related theory, technique and application of the topology discovery in world, the author first proposes a new physical topology discovery algorithm ( ptda ) for single subnet, next introduces the new algorithm into multi - subnet case, as a result, puts forward a new ptda for multiple subnets

    拓撲發現廣泛應用於網路故障定位、性能測試和計費管理等方面。本文在深入分析國內外拓撲發現相關理論、技術和應用的基礎上，提出了單子網物理拓撲發現演算法，將單子網物理拓撲發現演算法擴展到多子網中，並提出多子網物理拓撲發現演算法。在研究單子網和多子網物理拓撲發現演算法的基礎上，提出了基於生成樹協議的物理拓撲發現演算法。
  13. Algorithm of making matrix unit for distribution networks fault location based on ftu

    的配網故障定位矩陣單元化演算法
  14. By analyzing the refraction 、 reflection process of fault transient current traveling wave of high voltage and characteristics of refraction 、 reflection coefficient systematically, a new fault location method of single ended traveling wave is presented. it can not only identify the reflection wave for fault location efficiently, but also not be affected by the structure and length of line. fault earthed resistance 、 fault type 、 system impedance and can locate fault in adjacent areas accurately

    論文深入地分析了高壓線路故障暫態電流行波的波折、反射過程以及折、反射系數的特點，提出了新的單端行波故障測距方法，它不僅能夠有效地識別出測距所用的反射波，而且幾乎不受線路結構、長短、故障接地電阻、故障類型、系統阻抗的影響，在近區仍可以準確地進行測距；同時模擬阻波器的特徵，設計了低通數字濾波器，對通過了低通數字濾波器的暫態故障電流行波再次進行小波分析，並利用本文提出的單端行波故障測距方法進行故障定位，結論是所提出的測距方法在實際應用中仍是有效的。
  15. It is troublesome when it comes to a single phase fault happened on a non - direct - ground system, a host of scholars have dwelt on it. actually, most of these works are based on steady conditions

    長久以來，小電流接地系統單相接地的故障選線和故障定位問題一直沒能很好的解決；很多學者做了大量的工作，但是，這些工作很多都是基於單相接地時穩態電容電流的分析的結果。
  16. Based on the analysis of the transient and stable features of fault information on line in single carrier power supply with ineffective grounding neutral, this paper puts forward a new method for fault location in small current power system called " gradual identifying law "

    本文針對這一問題，在深入研究了中性點非有效接地單端供電系統發生單相接地故障后線路上的各處故障信息的暫態特性和穩態特性的基礎上，提出了一種新的小電流接地系統單相接地故障定位方法- 「遞進信息法」 。
  17. This device which is designed on the basis of " gradual identifying law " has such characteristics as accurately locating the fault point, being simple to operate and having a good adaptability

    根據「遞進信息法」設計出的小電流饋線接地故障定位裝置，具有定段準確、操作簡單和適應性強的特點。
  18. Fault location is an importrant function in distribuiton automation. in the thesis, the transferred information from feeder terminal unit is computed with load ’ s trapezoid fuzzy figure. the fault location is affirmed by the result of computation using the trapezoid fuzzy math theory. the atp and matlab softwares are used to simulate the 10kv lines in urmuqi distribution network. and the results shows the reliability and accuration of the method in the thesis

    線路故障定位是配電自動化的一項重要功能，文中提出利用線路始端電壓、電流和線路ftu （饋線終端單元， feederterminalunit ）的上傳信息，結合配電變壓器負荷的梯形模糊數模型，運用模糊數學理論通過電流計算來進行故障定位的新方法。
  19. In this paper, the important point is the study about the application of wavelet analysis in single phase grounding fault location of small current grounding power systems, wavelet transform is used as a novel tool of signal analysis to obtain useful fault transient components, a new criterion of fault line selection is constructed based on the time and frequency localization character of wavelet transform

    本論文主要研究了小波分析在小電流接地系統單相接地故障定位中的應用，利用小波變換這一新興的信號分析工具，提取故障時的暫態電量信息，構造出了基於小波變換模極大值奇異性檢測原理的新型選線判據。
  20. The research result of this paper shows that association rules are of higher level than single rules. and they can be very helpful for people to do fault diagnosis and trend prediction

    本文的研究結果表明，關聯規則比簡單規則具有更高的抽象層次，能夠幫助有效的進行故障定位和趨勢預測。
分享友人
分享到 Line

分享到臉書