散熱器系統 的英文怎麼說

中文拼音 [sǎntǒng]
散熱器系統 英文
radiator system
  • : 散動詞1. (由聚集而分離) break up; disperse 2. (散布) distribute; disseminate; give out 3. (排除) dispel; let out
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • : 系動詞(打結; 扣) tie; fasten; do up; button up
  • : Ⅰ名詞1 (事物間連續的關系) interconnected system 2 (衣服等的筒狀部分) any tube shaped part of ...
  • 散熱器 : radiator; radiation; cooler; heat sink
  • 散熱 : heat radiation; radiating; thermolysis; abstract heat; heat dissipation; cooling散熱風門 throttle...
  • 系統 : 1. (按一定關系組成的同類事物) system 2. (有條理的;有系統的) systematic
  1. This paper combines a liquid self - circulating radiator and flat heat pipe radiator, utilizes thermosiphon and self - circulating refrigeration principle, designs and produces a new form of heat pipe radiator

    本文結合液體自循環冷卻和扁平,利用虹吸管原理以及液體自循環冷卻原理,設計並製造出一種新型的裝置。
  2. According to the demand of the concept design of china spallation neutron source ( csns ), the target station, i. e. the target, the reflector and the moderator have been simulated and optimized using monte carlo simulation software, nmtc / jam and mcnp4a, firstly. the neutron flux escaping from the target and the moderator and the heat deposition in the target, the reflector and the moderator are calculated. these results provided essential data as a basis of the spallation neutron source design

    本論文結合當前中國裂中子源( chinaspallationneutronsource , csns )工程概念設計的迫切需要,選擇國際上廣泛使用的基於蒙特?卡羅方法,用於模擬粒子輸運過程的程序mcnp4a和nmtc jam作為研究工具,首次對csns靶站進行了全面的模擬與優化,內容包括靶、反射體與慢化的中子通量分佈以及量沉積,同時計算了靶的溫度場與應力場分佈。
  3. Multi - burner gas - fired overhead tube heater systems for non - domestic use - part 4 : system h, safety

    非家用多燃燒的燃氣式頂置管加.第4部分: h的安全性
  4. Multi - burner gas - fired overhead tube heater systems for non - domestic use - part 2 : system e, safety

    非家用多燃燒的燃氣式頂置管加.第2部分: e的安全性
  5. Multi - burner gas - fired overhead tube heater systems for non - domestic use - part 3 : system f, safety

    非家用多燃燒的燃氣式頂置管加.第3部分: f的安全性
  6. Multi - burner gas - fired overhead radiant tube heater systems for non - domestic use - part 4 : system h, safety

    非家用多燃燒的燃氣的頂置管式加.第4部分: h的安全性
  7. Multi - burner gas - fired overhead radiant tube heater systems for non - domestic use - part 1 : system d, safety

    非家用多燃燒的燃氣的頂置管式加.第1部分: d的安全性
  8. The condensed water separated from the air - conditioning system of an airplane is sprayed in the cold side of the radiator, and the heat transfer and the state change of water in the process of its spraying to the ram air are analyzed

    摘要將飛機空調中水分離分離出的游離水噴到的冷邊,並對水噴到沖壓空氣中的狀態變化過程和傳過程進行分析和計算。
  9. It possesses not only the self - learning ability and adaptability, but also the function of self - adjusting factors. based on fuzzy set, neural network theory, the fuzzy control model and fuzzy neural network control model of multi variable system are presented. based on the automatic core - welding line of shop floor control system in yangzhou radiator plant computer integrated manufacturing system ( ys - cims / sfcs ), the fuzzy logic theory was applied to the controlling device and established the main heating room fuzzy temperature controller and finally was put into practical use

    本文採用了基於神經網路技術的智能pid控制策略,設計了一類具有自學習和自調整比例因子功能的神經元網路自適應pid控制的結構及演算法;為解決結構不確定性的復雜多變量的控制,基於模糊集及模糊、神經網路理論,建立了多變量的模糊控制模型及模糊神經網路控制模型;針對揚州水箱廠計算機集成製造車間管理與控制( ys - cims sfcs )中的實際工程問題,設計和開發了芯子烘焊自動線主烘腔溫度模糊控制,解決了生產中長期存在的老大難問題,提高了產品質量,降低了單產能耗。
  10. Thirdly, radiator performance test - bed thermal system control modeling and rule self - organizing fuzzy control simulation were studied. the water supply temperature, radiator inlet temperature, test room temperature based on water temperature regulation, air supply average temperature and test room temperature based on air temperature regulation total five controlled processes transfer function were set. finally, rule self - organizing fuzzy control simulation for two

    通過試驗,辨識了實驗臺中供水溫度、進水溫度、基於調節的測試室溫度、送風平均溫度及基於送風調節的測試室溫度共5個被控過程的傳遞函數,並對基於調節和基於送風調節的測試室溫度響應過程進行了規則自組織模糊控制模擬。
  11. On the above basis, the controlling methods suitable to all types of indoor heating systems for outdoor heating hydraulic system are discussed, and a guide principle of the designing for indoor heating system and outdoor heating hydraulic system is provided

    著重研究了室內採暖在安裝恆溫閥后,其運行工況下性能參數的變化,在此基礎上,研究了與各種室內採暖相適應的室外供管網水變水量運行策略,闡述了與我國住宅建築採暖計量收費所適應的室內採暖和室外供管網水的設計原則。
  12. The optimized heat exchangers module was verified to be good based on wind tunnel test and road test

    改進方案的風洞實驗和實車路試結果表明,各量達到設計指標,各工作正常。
  13. Thermal design, realization, production and sales of cooling systems for electronics components ( cold plates, heat pipes, heat pipes systems and subsystems ) from thermal simulation and prototyping to pre series and large series

    設計、製作、生產和銷售電子(包括冷板、管和) ,實現從模擬、樣品試制到產品前期批量和大批量的生產。
  14. The thesis designs a hardware - in - the - loop - simulation system, including a virtual radiator and a pseudo radiator, as a betterment of the ground experimental system of thermal management so as to make it available for dynamic thermal simulation

    本文利用半物理模擬的方法設計並建造了空間站輻射環境及輻射模擬,完善了空間站管理地面實驗使之能夠進行空間站的動態模擬實驗。
  15. Plastic piping systems for warm water floor heating systems and radiator connecting - polyethylene of raised temperature resistance

    地板水供連接用塑料管道.高耐溫
  16. On the basis of the analysis of fundamental principle of thermoelectric refrigeration, the steady state mathematical model of the thermoelectric system was founded. according to the model, the theoretical analysis and calculation are made on various working conditions, and analyzed theoretically the effects on thermoelectric system which caused by hot and cold temperature difference, the device ’ s effective system figure of merit, the properties of the heat changers, which established theoretical basic for the opening up and design of the thermoelectric system and its performance test

    在分析電製冷基本原理的基礎上,建立了電裝置的穩態數學模型,並依據該模型對電裝置進行了不同的工作狀態下的力分析計算,並就電裝置的冷端溫差、電堆片的優值數、性能與泵裝置性能的影響進行了理論分析,為電裝置的開發設計和現有電裝置的性能測試建立計算理論基礎。
  17. To resolve the causes of loader overheat problem, experimental investigation on a loader cooling system was carried out based on a self developed vehicle thermal management system test bench

    摘要為解決工程機械中常出現的過問題,對某型號裝載機在不同工況下各性能,在自行開發的整車測試平臺上進行實驗研究。
  18. The main products include condensers, evaporators, radiators, heaters, oil - coolers, air - cooler, crf cooling modules, automobile hvac assembly, a c control panel assembly and automatic auto a c control system, widely applicable to mini vans, sedans, mpv, trucks and buses

    目前主要產品有:汽車空調hvaca c控制面板總成冷凝總成蒸發總成總成加總成自動汽車空調控制總成等。
  19. Chaoli adopts 5s, jit to realize lean manufacturing and set up perfect production control system and organization system. we import top - ranking manufacturing and testing equipments from japan, south korea, us such as evaporator with inner fin production line, condenser production line, hvac production line, heater production line, bus a c production line, automatic a c controller, so that the production capacity is 600, 000 units per year along with sub - assemblies and parts

    超力高科從日本韓國美國等國家引進世界一流的生產設備和在線檢測設備與製造技術,擁有帶內翅片蒸發芯體總成生產線冷凝芯體總成生產線hvac總成生產線芯體生產線客車空調生產線自動空調控制生產線,形成年產60萬套汽車空調的生產能力,可為用戶提供各種汽車空調分總成零部件。
  20. Hydraulic station tank reservoir 100 liters with extra fan cooler. motor 2 kw. update your old lathe, 8 valves entry distributor g 6

    分離式液壓中心控制,自帶,儲油罐容量為100公斤.馬達2千瓦.可以此對你的原有老機升級,做到多管道油
分享友人