斜平面 的英文怎麼說

中文拼音 [xiépíngmiàn]
斜平面 英文
tapered plane
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 平 : Ⅰ形容詞1 （沒有高低凹凸 不頃斜） flat; level; even; smooth 2 （高度相同; 不相上下） on the same l...
  • 面 : Ⅰ名詞1 （頭的前部; 臉） face 2 （物體的表面） surface; top 3 （外露的一層或正面） outside; the ri...
  1. The corbel ' s dimension should be ascertained as the manipulative condition of diagonal section. the amount of longitudinal reinforcement be ascertained on the basis of the flexure model, is obtained according to static for balance condition, the calculative expression of the load is obtained. and in terms of the design method in ultimate state the maximum load

    我國規范對于牛腿的設計規定，牛腿尺寸的確定以斜截面抗裂作為控制條件，縱筋用量的確定以彎壓破壞模型為基礎，根據靜力平衡條件得到承載力的計算公式，按照極限狀態設計方法計算得到，箍筋用量則按照構造要求確定。
  2. The le - an oil field is located on the southern slope of dong - ying sag. there are two sets of ek basalt in its western block. depending on the drilling, the logging and the seismic date, tha ek basalt has the characteristics of high resistancs, the low sound wave defferance and faradic conductance, the smooth curve of self potential

    樂安油田位於東營窪陷南斜坡上，其西區發育了兩套孔店組玄武巖，根據鉆井、測井、地震資料，孔店組玄武巖具有電阻率高、聲波時差值和感應電導率值低、自然電位曲線平直的特點，地震波呈板狀強反射；沉積期該區有有二次火山活動，玄武巖平面分佈比較穩定，噴發方式為「裂隙式噴溢」 ，火山口分別位於草12和草31井附近。
  3. As one kind of key equipment in piping work of large - scale turbo - generator set in power plant, the machine is especially applicable to various welding bevels, flat end and angle of outer & inner diameter of ascending pipe, elbow pipe, bend, flange and etc., which greatly meets demands in pipe processing of construction site and manufacturers

    本機床是電站大型汽輪發電機組的管道施工的關鍵設備，對直管、彎管、彎頭、法蘭等管體的各種型式焊接坡口，端平面，內外徑過緩斜度及直口，能滿足施工現場和製造廠家對各種管件的加工要求。
  4. In order to considering the affections of the adjacent zone out of the girdler section, the internal - forces of two end surface which were obtained by the horizontal shaft system analysis are exerted on each model respectively. moreover, the weight, cable force and prestressing forces including girder longitudinal, diaphragm transverse and inclined web vertical directions are considered

    考慮到梁段以外附近區域的作用，在其兩端面上施加了由平面桿系結構分析所得的端面內力，另外，索力和預加力（梁縱向、橫隔梁橫向、斜腹板豎向）也施加在相應的位置，分析了箱形主梁在自重、索力和預應力作用下的空間應力效應。
  5. Strike is the trace of the intersection of an obliquely inclined plane with a horizontal reference plane.

    走向是傾斜平面與水平參考成交線的跡線。
  6. Assembling of hand - petal intravenous needles for single use must satisfy with the certain rule : the angle of main plane intravenous needles and hand - petal plane should range from 80 ~ 100

    一次性輸液針的手瓣裝配時，其針尖主斜面的對稱面的垂直面與手瓣所在平面的夾角不能超出10的誤差范圍。
  7. Stage projection ; oblique projection on plane screens, drawings and nomograms for use in practice

    舞臺放映.平面屏幕上的傾斜放映.實際應用的圖形和列
  8. A two - dimensional plain strain finite element model of infinite plate is developed to investigate the ultrasonic wave propagation and scattering on three kinds of cracks : parallel to the surface, 450 oblique angle to the surface, and quarter - circle

    摘要建立了無限長板的具有吸收邊界的二維平面應變有限元模型，在研究了脈沖超聲波在無限長板中傳播的基礎上，對板中平行於表面的裂紋、與表面成45的斜裂紋和四分之一圓周弧形裂紋三種情況的脈沖超聲波散射進行了重點研究。
  9. Three kinds of chemical reaction model are used to describe the chemical processes of downstream of detonation waves. the conditions that planar standing oblique detonation waves may occur and the factors that may affect them are discussed detailedly. the polar curves of oblique detonation waves and " standing window " are computed under different conditions

    建立了平面駐定斜爆轟波特性分析的數學模型，採用三種化學反應模型來描述爆轟波后的化學反應過程，詳細分析了平面斜爆轟波的駐定條件及其影響因素，計算了不同條件下斜爆轟波的極曲線和「駐定窗口」 。
  10. Parameter analysis for out - plane global stability of space lattice tilted column frame

    斜腿剛架平面外整體穩定性參數分析
  11. During the course of the manufacture for packaging 2000 pixel hgcdte irfpa wafer, some crucial techniques are solved, such as the design of the button stem structures with inclined dragging wires applied in cryogenic platform, the optimization of long linear irfpa detector ' s signal wires layouts, the implement of a fanout board having thin film gold metalization for defining the required electrical conductors and a method of hermetically sealed vacuum enclosure of large dimension windows, etc

    在用於封裝2000元碲鎘汞焦平面晶元的分置式微型杜瓦研製中，詳細闡明了一種焦平面晶元其裝載面為斜拉式支撐結構的設計，實現了探測器外引功能線的布線優化及其輸出引線工藝改進，並提出了一種大尺寸高氣密光學窗口的焊接方法等關鍵技術。
  12. All of the hydraulic structures are arranged in the right bank and four underground seepage tunnels are arranged parallel in horizon, and the axle wires intersect with syncline axis almost perpendicularity, and with rock formation obtusely. complex underground tunnels are formed under such formidable conditions, and each of seepage tunnels crosses nuclear of syncline and comes up against interlaminar sharing disturbed belt at different footage

    四條引水發電隧洞在平面上平行布置，軸線方向與本區構造線方向近於垂直，與巖層走向大角度相交，構成一復雜地下洞室群，並在不同洞段通過沙金壩向斜核部，且遭遇多條層間剪切錯動帶。
  13. The curves of the consolidation settlement in soft clay base of flood land are gained, which compare the effect of sand drain. the settlement - time curves in different period are also gained, which increase the height of embankment to 8m, based on the test data of hang - yong highway. furthermore, the consolidation settlement characters of these entity engineering are analyzed, and, the variation rules of the rate of grade and degree of the curves in different period in the whole section, the maximal settlement and the liner regression relations between the rate of grade and degree are calculated

    本文利用大變形固結有限元分析程序（ lscfea ）中的小變形平面固結分析單元（ sse2 ） ，結合實體工程項目進行了地基固結沉降的有限元計算，分別得出河灘相軟土地基在考慮砂井和未考慮砂井作用下的固結沉降曲線及杭甬高速公路試驗段在高堆載情況下的固結沉降曲線；並對以上曲線特徵進行了分析，得出各時間段曲線斜率、角度在整個斷面的變化規律，以及沉降最大值與斜率、角度變化之間的線性回歸關系。
  14. On the base of fully utilizing the available data about tectonic maps and structural elements, the present paper has made synthesized research that used the ways of stratigraphic sequence edge unconformity analysis and stratigraphic thickness correlation analysis, and combined seismic - data interpretation, review of paleo - structure and ancient landform and research of tectonic evolution and petroleum system, and combined region and location, plane and profile and time and spatial. by the synthesis analysis on tectonic evolution of hetian paleo - uplift in tarim basin, the results indicate that : ( 1 ) hetian paleo - uplift is a sedimental and erosional paleo - uplift. the formation and evolution of the hetian paleo - uplift experienced three stages, that is, the uplifting and eroding stage of the caledonian period, the depositional stage of the hercynian period and the destroying stage of the himalayan period, and evolved from paleo - lift to inclining strap at last

    本文採用地質和地球物理相結合的研究思路，運用多種技術手段和方法；在充分利用已有構造圖資料和構造要素資料的基礎上，運用地層層序邊界不整合分析法、地層厚度對比分析法，結合地震資料的精細解釋、古構造和古地貌的恢復、構造演化史研究、含油氣系統的研究，和區域和局部、平面和剖面、時間和空間的結合研究，對塔里木盆地和田古隆起構造演化及油氣關系進行了綜合分析，認為： （ 1 ）和田古隆起為一沉積?剝蝕性古隆起；形成於志留-泥盆紀；其構造演化可分為三個階段，即加里東期的抬升剝蝕階段、海西期的沉積階段和喜山期的破壞階段，最終由古隆起演變為一斜坡帶。
  15. The method is used to study the singularity distributions for different orientations of the mobile in a oblique plane. by parallel translation of the oblique plane, the singularity distributions are derived in three - dimensional space

    用這種方法分析了各種歐拉角（ ）姿態下在一斜平面上的奇異分佈情況，通過斜平面的平行移動，可以得到機構在三維空間中的奇異分佈。
  16. Sloping leading logo mould

    斜平面導向採用胎活絡模
  17. The singularity loci and distribution characteristics of 3 - 6 stewart manipulator for a given orientation of the mobile are studied in a oblique plane and in three - dimensional space

    研究了在姿態一定時，在某一斜平面上和三維空間中的奇異分佈規律。
  18. The principal initial hole factors influencing primary section trajectory, such as sidetracking position ( formation factors ), primary deviating angle and primary azimuth of the sidetracking position are analysed by spatial plane - tilted method

    文章運用空間斜平面法分析了對側?水平井起始段有重要影響的主要初始井眼條件，包括側?點（地層因素） 、側?點初始井斜角、側?點初始方位角等對起始段軌跡的影響。
  19. The characteristic of combined heat and mass transfer by natural convection has been the focus of researches for a long time. numerical analysis is conducted for combined heat transfer and mass transfer by natural convection on inclined surface. effects of the inclination angle and the ratio of buoyancies due to heat diffusion and mass diffusion on fluid flow and heat and mass transfer characteristics have been investigated for pr = 0. 7 and sc = 0. 05 - 5. 0

    本文採用數值計算方法研究了傾斜平面上的傳熱傳質復合自然對流，求解了動量、能量及質量的完整方程，考察了熱質擴散共存時傾斜平面上的流動和傳熱特性，著重分析了熱浮力及物質擴散浮力之比b和傾斜角度對流體流動和傳熱傳質特性的影響。
  20. And each plane can create two look - - up tables to ca1ibrate the system. because the standard has some characteristics, it can ca1ibrate its three optical subsystems in para1lel mode, so the process can be implementing in a high speed

    在對每一個傾斜平面進行測量以後，根據測量結果可以獲得兩個坐標校準查找表，這兩個坐標查找表可以將ccd像面坐標（ 2d ）映射到世界坐標（ 3d ） 。
分享友人
分享到 Line

分享到臉書