斜線滑下 的英文怎麼說

中文拼音 [xiéxiàngǔxià]
斜線滑下 英文
downhill traversing
  • 斜 : 形容詞（跟平面或直線既不平行也不垂直的） oblique; slanting; skew; bevel; diagonal; askew; inclined; tilted
  • 線 : 名詞1 （用絲、棉、金屬等製成的細長的東西） thread; string; wire 2 [數學] （一個點任意移動所構成的...
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 下 : 下動詞1. （用在動詞后,表示由高處到低處） 2. （用在動詞后, 表示有空間, 能容納） 3. （用在動詞后, 表示動作的完成或結果）
  • 斜線 : bias （pl. biases）; slant; oblique line
  • 滑下 : slipping; sliding; glide; gliding
  1. 2 % 22 % and 29 % respectively less than using other three knives at cutting speed of 500mm / min when the moisture contents of rootstalks was 48. 2 %. the cutting forces were tested at four different parts of rootstalk that were the middle part along a radius, the tip part along a radius, the middle part along axis and the stalk part along a radius, and the force at the middle along a radius is the largest and increase 32 % 45 % 111 %, respectively more than at the other three parts. the force increase 37 % to cut the rootstalks from the areas one crop a year more than that from two crops a year

    試驗結果表明，根茬含水率愈高，剪切力愈小，根茬含水率與剪切力近似為二次曲線關系；刀片剪切速度愈快，剪切力愈小；凸曲線、斜線、凹曲線和直線四種不同的刀刃曲線對整株根茬剪切力依此由小到大，凸曲線和斜線剪切時有一定程度的滑切作用，所以剪切力相比較小，當根茬含水率為48 . 2 ，剪切速度500mm min時，與其他三種曲線相比凸曲線型刀刃的剪切力依次分別減少了7 . 2 、 22和29 ；對根茬中部、梢部和根部的剪切力，在相同試驗條件下，徑向中部最大，比梢部，軸向根部和根部莖稈所需剪切力分別增加32 、 45和111 ；當含水率為48 . 2 ，刀片的剪切速度為500mm min時，一年一熟玉米根茬比一年兩熟的玉米根茬剪切力增大37 。
  2. Accordring to basic concept and assumes essentially on the basic of sweden method of slices, be living below the maximum equilibrium state, the function expression about stability safety homogeneous slop is deduced, and the slope surface is consist of two lines and an arc, afterwards according to analysis theory of minimal value ruling on the basic of the maximum, genetic algorithm is applied to slove the dangerousest slide situation and radius and corresponding safely factor

    根據瑞典圓弧法的基本概念和基本假定，在極限平衡狀態下，推導了兩直線段均質斜坡穩定性安全系數函數表達式，然後根據極限分析理論的極小值原理，利用遺傳演算法，求出了邊坡穩定性安全系數極小值，並得到最危險滑動面的滑弧半徑和滑弧中心坐標。
  3. With the help of this program, this paper does research on the moved backwards of the slide surface, lengthening the anchor section, the soil nail ' s total force, gets conclusion about relations between the soil nail ' s length and the slope ' s grade, height, soil ' s mechanical parameter ; relations between soil nail ' s total force and coulomb soil pressure. with the help of the large multiuse finite element program ansys, this paper analyzes the soil nailing in one - step ' s slopes, in two - steps " slopes, puts the emphasis on the axis force ' s distributing along the soil nail at each rows, the effect of both the excavating mode and the original slope figure to the axis force of the soil nail, the one another effect between the upper - step slope and the nether - step slope in the soil nail ' s axis force, gets conclusion about the design of soil nail at the first low, different slope body is the same with different excavating mode, the original slope figure has more effect to some than others because of the slope body, the reasonably design of the step width in two - steps slopes, the two - steps excavating and retaining has more virtue than the one - step ' s. through soil pressure analysis this paper does research on the differences and the links between the coulomb soil pressure theory and the rankin ' s, the vertical pressure at the slope surface when the slope surface is inclined and the retaining wall is rough, the soil pressure ' s distributing behind the panel, gets conclusion about the effect of both the slope body inner stability and the slope surface local stability to the soil pressure

    通過分析比較，論證了對數螺旋線型比圓弧形作為邊坡的假設滑裂面具有較多的工程優點，並為此編制了一個採用極限平衡法分析土釘支護的fortran語言程序，以此作工具對滑裂面的后移、土釘錨固段的超長、土釘總力的大小等方面作了研究，得出了有關土釘的長度與邊坡的坡角、坡高、土體力學參數的關系、土釘總力與庫侖土壓力間的關系等結論；採用大型通用有限元數值分析程序ansys分別對採用土釘支護的一階邊坡、二階邊坡進行分析，重點是研究各排土釘的軸力分佈規律、開挖方式及原始邊坡形態對土釘的軸力的影響、上下階邊坡在土釘軸力方面的相互作用，得出了有關第一排土釘的設計問題、不同類型的土體應適用於特定的開挖方式、原始開挖出的邊坡形態對一些類型坡體的邊坡土釘支護有較大的影響而對另外一些影響不大、二階邊坡臺階寬度的合理確定、二階開挖及支護比一階時具有較多的工程優點等結論；通過土壓力分析對朗肯、庫侖兩種經典土壓力理論的區別與聯系、坡面傾斜及墻背有摩擦時的坡面豎向應力分佈、面板背土壓力的分佈形態作了研究，得出了邊坡支擋土壓力受坡體內部穩定與坡面局部穩定兩個方面的影響、土釘支護面板背土體中卸荷拱的存在對面板受力有利等結論。
  4. Secondly, considering the complexity of the analysis of inclined - loading pile, nonlinear finite element method is adopted to calculate the internal force and displacement of pile group under inclined loads, with the concept of equivalent width presented to simplify 3d problems into 2d problems. and a program is developed as well, which is able to consider the continuity, elastic - plasticity and layered characteristic of soil around the pile shaft. besides, the interactions among pile, base slab and soil are considered in this program and contact surface element is used to simulate slipping and crazing between pile and soil, or between base slab and soil under loads. then, the non - tension analysis is proposed, to reflect the low - tensile property of soil and concrete

    在此基礎上，針對傾斜荷載下群樁基礎分析中的復雜性，提出採用非線性有限元對傾斜荷載下群樁的內力及位移進行分析，應用樁的等效寬度概念將空間問題簡化為平面問題考慮，並開發出能考慮樁周土介質連續性、彈塑性、分層性等因素的傾斜荷載下群樁內力及位移分析的計算機程序，並在程序中考慮了樁、土、承臺的相互作用，提出了採用接觸面單元來考慮荷載作用下樁與土體及承臺與土體間的滑移、開裂；並在此基礎上，提出了傾斜荷載下群樁基礎的「無拉力」分析方法，可有效地反映土體及混凝土材料的低抗拉特性。
分享友人
分享到 Line

分享到臉書