斷裂線 的英文怎麼說

中文拼音 [duànlièxiàn]
斷裂線 英文
breaking down line
  • : Ⅰ動詞1 (分成段) break; snap 2 (斷絕;隔斷) break off; cut off; stop 3 (戒除) give up; abstai...
  • : 裂動詞[方言] (東西的兩部分向兩旁分開) open
  • : 名詞1 (用絲、棉、金屬等製成的細長的東西) thread; string; wire 2 [數學] (一個點任意移動所構成的...
  • 斷裂 : break; disrupt; flying off; fracture; fragmentation; out break; rift;crack;bursting;rupture;rendi...
  1. 187 there are various types of lines on the drawing such as : border lines, visible lines, invisible lines, break lines, phantom lines

    圖上有各種形式的條,諸如:邊框、實、虛、剖面、中心、引出、尺寸斷裂線、假想
  2. Test method for breaking strength of yarn in skein form

    絞紗形式下紗強度的試驗方法
  3. Variation ratio of dimensional after water rinse, ultimate strength, neps and pile, tearing resistance, bursting strength, joint strength, commissure ' s swerve strength, fabric shift ( slip ), ventilate degree, elasticity ( resilient rate / deformation rate ), anti - water permeability ( hydrostatic pressure ), extension and resilience, abrasive resistance, gets wet the nature, hydroscopicity, stock ' s transverse ductility, fire resistance, antistatic

    水洗尺寸變化率(縮水) ,強力,起毛起球,撕破強力,彈子頂破強力,脹破強度接縫強力,縫口脫開程度,紗滑移性能(滑脫) ,透氣量,彈性(回復率/變形率) ,抗滲水性(靜水壓) ,延伸及回復性,耐磨性,沾水性,吸水性,襪子橫向延伸,阻燃性能,抗靜電。
  4. On the basis of remote sensing technique ' s good characteristic with large - area, multi - time, multi - photograph variety, manifold abundant spectral information and high ground resolution, the fault tectonics frame, river geomorphy ( such as terrace, floodplain, shoal, etc ) and suspended load, etc. were explained after analyzed the fault tectonics, river geomorphy, characteristic in the tm image by gray bar statistics, primary component analyses, tm741 image integration, line convolve enhancement and model recognition etc. especially 9 piece of fault tectonics were explained in this thesis, in succession, the impacts of the factors severally were analyzed

    遙感技術具有大范圍、多時相、多片種、多層次、含有豐富的光譜信息及具有較高的地面解析度的特點。本文利用該技術,運用灰階統計特徵分析和主成分分析、 tm741多波段融合、性卷積增強、模型提取等一系列遙感解譯分析方法,分析了構造、河流地貌(階地、漫灘、沙洲)及懸浮物等在tm遙感圖象上的影像特徵,解譯出了安徽南部構造格架、河流地貌和懸浮物的分佈,並新解譯出了9條近東西向的
  5. In spermatogenous cell, we could find dilated cytolemma, dilated nuclear membrane and fused crista of mitochondria. most of the sperm ' s cellular membrane dissolved and broke down into pieces. the central granule and mitochondrion showed little dissolving

    久效磷可以使金魚精子細胞質膜溶解,出現間;有的精子頭部變形,頂部出現凹陷;少量精子頸部中心粒復合體溶解;精子頸部粒體有溶解現象,精子尾部的膜結構
  6. At low concentration of zn, the changes in ultrastructure were nuclei deformation, chloroplast swelling and disorder of thylakoid arrangement ; serious damages in ultrastructure caused by greater zn stress were indicated by scattered nucleoli, condensed chromatin, almost empty nuclei with nuclear membrane disrupted and nucleoplasm flowing into cytoplasm, swollen and partly dissolved cristae of mitochondria, disrupted and collapsed chloroplast envelopes, and some dissolved thylakoids that flew into cytoplasm

    超微結構的變化也呈現加重趨勢,低濃度處理的變化為細胞核變形、葉綠體膨脹、類囊體排列紊亂;嚴重的超微結構的損傷是核仁散開、染色質凝集,細胞核幾乎成為空核和核膜破,核質散出;粒體脊突膨脹和部分溶解;葉綠體膜、消失和部分類囊體溶解和散到細胞質中。
  7. Approach on break crossover point diastrophism direction of break coal intersecting line drawing in complex structure area

    復雜構造區煤交繪製法中交點錯動方向的探討
  8. Research about ctod and its components 8 ", " shows that the direction angle of ctod vector is identical with the fracture angle of void - mode fracture, which is obtained through experiments, and it is also identical with the result got by peak value line of stress triaxiality. besides, 8 i " was compare with vgc as criterion for initiation of void - mode fracture

    紋尖端張開位移ctod及其張開型分量~ 1和剪切型分量~ 11的分析表明,在試件發生韌窩型時,按照圓弧紋中ctod矢量的垂直方向預測的角與試驗測得的角符合較好,與三軸度脊預計的結果也比較一致。
  9. The pipe is complete enwrapped by cement after grouting, not loose and rupture when pulling wire

    外壁環狀波紋,灌漿后可完全包裹在水泥中,拉時不會松動或現象。
  10. Based on 3 - d seismic well and logging data, mainly by means of advanced seismic theories of reservoirs prediction and other corelational multidisciplinary, an extensive and indepth studying on the tight sandstone reservoir with fracture of the second part of the xujiahe formation in west sichuan depression has been carried out. a series of theoretical viewpoints and research fruition are concluded as follows :. 1 on the basis of analysis of the regional and local structure characteristics and evolution, a conclusion comes in to being : inchoate and nowadays structure traps and the match model between structure and fracturation system are the main factors in controlling the formation of effective traps

    本文綜合利用三維地震、鉆井、巖心、測井資料,採用地震儲層預測方法為主的多學科綜合研究思路對川西坳陷上三疊統須家河組二段緻密縫性砂巖儲層進行了較為廣泛、深入的研究和探索,取得以下一系列理論認識和研究成果: 1 、通過區域及局部構造特徵及構造演化史分析,認為古今構造圈閉、構造與系統配置關系是控制有效圈閉形成的主要因素。
  11. The basis of linear fracture mechanics is the paper of griffith which was unrecognized for thirty years.

    力學的基礎是Griffith的論文,但這篇論文三十年來都沒有得到承認。
  12. Ultrastructurally, karyopyknosis and karyolysis occured in lymphocytes, and the mitochondria, rough endoplasmic reticulum of lymphocytes in the immune organs were damaged. the nucleus were deformity, the rmtochondrial and rough endoplasmic reticulum were swelling, and the ribosomes were shed in reticular cells of thymus in zinc - deficient ducklings

    超微結構顯示缺鋅組淋巴細胞核固縮或溶解,粒體、粗面內質網受損;胸腺網狀細胞核受損,粗面內質網擴張,粒體腫脹、嵴
  13. The methods - three dimension fabric - enforced laminates, and sparse fabric - enforced laminates, layer - enforced laminates ? to enhance the interlaminar toughness of fabric - reinforced laminates were discussed in this paper. the stitching method to enhance interlaminar toughness of stitched - laminates was mainly discussed in this paper based on our research and experiment. the middle - alkali glass fabric used as enforced - material with thickness of 0. 2mm, 3 section 600 deniner kevlar yarn is used as stitching thread in this research, which improved lock stitching way and different kinds of stitching mode were adopted

    以提高層合板復合材料的層間韌性(能量釋放率)為目標,採用中堿玻璃布為增強材料,對疊層后的玻璃布,採用凱芙拉縫合、改進的鎖型縫合方法、不同的縫合工藝進行了縫合;基體採用的是不飽和樹脂,固化劑為過氧化甲乙酮,促進劑為環烷酸鈷液;在室溫下採用真空輔助rtm ( resigntransfermolding )成型固化方法,製作了不同縫合工藝的玻璃布增強復合材料層合板。
  14. Thermal activation analysis of dynamic fracture of pipe line steel x

    70管鋼動態的熱激活實驗與分析
  15. The article is directed by the modern structural geology, seismic stratigraphy and petroleum geology. in the study of works, geology, seismic and logging data are used. with the computer ' s ( workstation ) help, adopted many methods which are the technology of balanced section, calculation of the structural movement rate, the renewal of the erosion thickness, renewal of the ancient thickness, the protraction of the cover history curve and the " pagoda " figure, and based on the previous research achievement, this article studies the characteristic of rupture and fold, the degree of structural movement and the fashion of structural movement and brings forward that ludong area has experienced three big phases of structural evolvement

    以現代構造地質學、地震地層學和石油地質學為指導,全面利用各種地質、物探、測井資料,藉助先進的計算機(工作站) ,採用多種方法(平衡剖面技術、構造活動速率計算、剝蝕厚度恢復、古厚度恢復、埋藏史曲製作、寶塔圖製作等) ,並結合前人的研究成果,研究了陸東地區和褶皺的特徵、構造運動的期次以及構造運動的方式,提出了陸東地區經歷了三個大的構造演化階段。
  16. Analysis on fracture of steel skein used for wire rope of bridge tie bar

    橋梁系桿鋼索中鋼絞情況剖析
  17. Image distortion wavy, broken or distorted lines or blurred with missing areas of vision

    影像變形變成波浪型出現斷裂線條變形或影像變得模糊兼部分地方有空缺現象
  18. Image distortion ( wavy, broken or distorted lines or blurred with missing areas of vision )

    影像變形(變成波浪型、出現條變形或影像變得模糊兼部分地方有空缺現象)
  19. After the paper sufficiently considered creation algorithmic of triangulated irregular network in time and space and analyzed three creation algorithms of tin - divide - conquer, triangulation growth, incremental insertion, the paper adopts to a new algorithm that takes advantages of divide - conquer and triangulation growth. it can create tin quickly. the paper also uses break lines, terrain feature lines, building borderlines to be restriction condition and creates triangulated irregular network based on restriction

    綜合考慮不規則三角網生成演算法的時間和空間性能,分析了常用的三種tin生成演算法:分割-歸並法、三角網生長法和逐點插入法,筆者採用分割-歸並法與三角網生長法相結合的演算法,快速生成了tin ,並以斷裂線、地性、建築物邊界為約束條件,最終生成具有約束的不規則三角網。
  20. Waved lines shouldn ' t to be exceed the outline lines of the broken part in the parts, must be drawn on the solid body in the parts

    用波浪作為斷裂線時,波浪不應超出機件上部分的輪廓,應畫在機件的實體上。
分享友人