最優條件 的英文怎麼說

中文拼音 [zuìyōutiáojiàn]
最優條件 英文
optimum conditions
  • 最 : 副詞（表示某種屬性超過所有同類的人或事物） most; best; worst; first; very; least; above all; -est
  • 條 : Ⅰ名詞1 （細長的樹枝） twig 2 （條子） slip; strip 3 （分項目的） item; article 4 （層次; 秩序; 條...
  • 件 : Ⅰ量詞（用於個體事物） piece; article; item Ⅱ名詞1. （指可以一一計算的事物） 2. （文件） letter; correspondence; paper; document
  • 最優 : optimal; optimum最優策略 optimal policy; optimal strategy; 最優設計 optimum design; 最優值 optima...
  • 條件 : 1. （客觀的因素） condition; term; factor 2. （提出的要求） requirement; prerequisite; qualification
  1. An investigation has been carried out of fed batch culture according to the optimum condition of batch culture

    以搖瓶培養最優條件為基礎，進行了搖瓶補料實驗。
  2. First the paper use the different four network operating condition as the primary given conditions and set the 330 / 220kv transformer tap changer position in the standard position, adding the paralleled capacitor bank sets one by one into the network to change the amount of the input reactive power, thus obtained four sets of the 330kv and 220kv bus voltage and the active and reactive power losses changing curves

    進而研究了在每一確定並聯補償電容器組投入量條件下，隨聯變調壓檔位變化而產生出的一組並聯補償量、母線電壓與損耗的變化曲線。進而選出了隴南電網在四種選定電網運行方式下、有功損耗最小條件下的最優綜合控制組合曲線。
  3. To investigate the influencing law of technical elements in enterprise production, based on certain assumptions, a three - element ( technology, labor and capital ) output function is defined ; through conceiving and solving an optimization model under the condition of invariable total production cost and maximum output, this paper deduces the optimal proportioning relationship between optimum technical growth rate and conventional production factors - labor and capital, further constructs the optimization model of technical growth rate under total production cost constraint, and design a genetic algorithms program to solve such model

    摘要為了考察企業生產中技術要素的作用、規律，在一定的假設條件下，對其技術要素下了定義，認為其產出函數包括技術、勞動及資本要素；通過構建與求解生產總成本，構建最大條件下的優化模型，推導出技術最優增長率與傳統生產要素勞動與資本的優化配比關系，進一步構造了企業在生產總成本約束下的技術增長率優化模型，並設計了遺傳演算法程序對模型進行求解。
  4. In the meanwhile, seeing that the parameters are restricted for many practical problems, the author also studies the problems of optimal conditional prediction in the model with respect to two classes of restriction of linear parameter equations. what is more, the optimal conditional linear and optimal conditional ^ - linear unbiased predictors are also obtained respectively, which extends the results given by the predecessors and enrich the theory of optimal prediction

    考慮到對于實際問題，模型參數一般是要受到一定的約束，因此作者也研究了兩類線性等式約束條件下的模型的最優預測問題，得到了模型的最優條件線性無偏預測和最優條件-線性無偏預測，從而成功地推廣了前人的結果，豐富了這方面的預測理論
  5. Query on sufficiency of pure exchange pareto optimum and improvement

    試疑純交換帕累托最優條件的充分性及其改進
  6. When optimized, the drug - loaded plga / pla nanoparticles contain as much as 2. 5 % haloperidol

    在最優條件下， plga / pla納米粒載藥量可高達2 . 5 %氟哌啶醇。
  7. The culture was shake - cultured at 30 for 40 hours in liquid medium ympd supplemented with 0. 5 % glycine

    獲得了灰色鏈黴菌原生質體形成和再生的最優條件，即用ympd培養基，加0
  8. In order to develop and utilize prickly ash seed, the extraction method and parameters of prickly ash seed oil were studied

    為了合理利用花椒籽資源，著重研究了提取花椒籽油最佳方法及最優條件。
  9. 2. fabricating uniphase fe _ 3o _ 4 film by dc magnetron sputtering, the influence of sputtering power, annealing temperature is discussed in detail and the optimum fabricating condition is found. 3. the influence of ta buffer introduced to fe _ 3o _ 4 film is investigated in detail

    2 .研究以磁控反應濺射法制備單相成分的fe _ 3o _ 4薄膜時，濺射功率、晶化溫度對薄膜結構的影響，得到磁控反應濺射制備半金屬fe _ 3o _ 4的最優條件。
  10. Section 3 is devoted to the stablities for the perturbed generalized equations. with some constraint qualifications, the pseudo - lipschitz continuities for solution mappings of generalized equations at the solutions is obtained, which implicits the pseudo - upper - lipschitz continuity at the same points. in the last, we derive necessary optimal conditions for optimal problems with quasi - variational inequalities

    第三節主要是對廣義方程的擾動穩定性進行研究，得到了在假設條件下，廣義方程解映像的局部lipschitz連續性質，它隱含了廣義方程解映像是偽上lipschitz連續的；最後，我們得到了具擬變分不等式約束的優化問題解的必要最優條件
  11. Wavelet edge detection technology was applied to image segmentation of blasted muck - pile, in which quadric bspline wavelet and a method of adaptive thresholds edge detection for image based on wavelet transform were applied, and methods of expanding and deleting short chain were used to delete untrue edge better

    摘要把小波邊緣檢測技術應用於爆堆圖像分割處理中，採用基於最優條件下二次b樣條小波和自適應模極大值的圖像邊緣檢測演算法，綜合運用膨脹技術和短鏈刪除技術，很好的去除了偽邊緣。
  12. In the first section, we show the background of the problems that we study, which comes from applied science, and in the second section, we introduce the generalized differential caculus for multi - mappings or nonsmooth mappings in finite demensional spaces, which is dued to s. b

    Mordukhovich關于集值映像或非光滑映像的廣義微積分理論導出這類優化問題解的必要最優條件第一節說明我們研究的問題產生的背景，它來自於應用學科的某些問題；在第二節里，我們將介紹s
  13. 2. the optimize of the oligonucleotide probes preparation the optimal condition is to resuspend the probes in ph = 9, 0. 1 m carbonate buffer to 100 m. 3

    2 .寡核昔酸探針制備條件的優化以ph二9 ， 0 . im的碳酸鹽緩沖液，重懸為100林m探針為最優條件。
  14. Pareto optimum condition of the tourist market promotion and evaluation of implementation mode

    旅遊市場促銷的帕累托最優條件及實施模式評價
  15. The results show that the optimal processing of 6061 aluminum foams which have structural uniformity and controlled porosity is the foaming temperature 620 - 690, heating rate 45 / min - 60 / min and heat preservation time is 12 - 18min. according to pore size tih2 content is chosen. when pore size is big, tih2 content is high and heat preservation time is short, vice versa

    研究結果表明，對于實驗採用的6061鋁合金粉末材料來說，加熱發泡製備出孔隙結構均勻，孔隙率可控的泡沫鋁的最優條件是，加熱溫度為620 - 690 ，保溫時間為12 - 18min ，加熱速率為45 - 60 min ， tih _ 2含量可以根據所需孔徑的大小來確定。
  16. The method keeps away from the cause of misshapen mode in modifying at the incomplete mode space. third, an intelligent genetic algorithms based model parameter identification method is brought forward, which maps real parameters to the space spanned by structural stiff and mass matrix, and optimizes them under some constraints

    第三，提出了應用智能遺傳演算法識別模態參數的方法，將實際工程結構參數映射摘要至由結構剛度陣和質量陣張成的特徵空間，使其滿足某些最優條件以進行模態識別。
  17. Condition for efficiency in production

    生產的最優條件
  18. Condition for efficiency in exchange

    交換的最優條件
  19. Discussion on optimal condition in measuring rbc membrane elasticity with ektacytimetry

    對利用新型激光衍射法測量紅細胞膜剪切彈性模量最優條件的討論
  20. Choose an optimum condition on the basis of that to go on an amplification experiment whose product become the raw and processed materials with which the influence between the adding of dbs a as the second dopant and the conductivity of cp is studied

    根據正交試驗結果，選取一個最優條件並進行放大實驗。以該試驗產品為原料，研究了十二烷基苯磺酸二次摻雜對絲炭/聚苯胺導電材料導電性能的影響。
分享友人
分享到 Line

分享到臉書