最短弧 的英文怎麼說
中文拼音 [zuìduǎnhú]
最短弧
英文
shortest arc-
Transitional feature of the arc and metal droplet in the welding process with steam shielded arc is investigated by means of analysing the waveforms of welding voltage and current under different welding regimes and it is found that there are two types of arc process behavor ? " arc starting - arc blowing out - short - circuiting " and " arc - starting - short - circuiting ". under the condition of constant diameter of welding wire and its feeding speed, the arc process behavor can be changed by adjusting the inductance of welding circuit as well as the voltage of power supply. if arc process behaves as alternative process of " arc starting - arc blowing out - short - circuiting " with minimum time duration of arc blowing out and maximum frequency of short - circuit transition, the welding process will be stable with less spatter and smooth weld bead
通過分析不同焊接規范下的焊接電壓和電流的波形.研究了水蒸氣保護下電弧及熔滴過渡的特點，發現其電弧過程行為有「燃弧?熄弧?短路」和「燃弧?短路」兩種形式.在焊絲直徑和送絲速度一定的情況下，通過調節焊接迴路中的電感量和電源電壓，可以改變電弧的過程行為形式.若電弧過程呈「燃弧?熄弧?短路」交替進行，並且熄弧時間最短時，短路過渡頻率最高，在這種情況下，飛濺小，焊道成型好，焊接過程穩定The off - line program system based on cad / cam for dispensing robot is designed on the computer. in the module of trajectory planning, preliminary discussion is done about the shortest loop path and an algorithm of solving this problem is provided ; in the module of back procedure, dda ( digital differential analyzer ) is adopted in line, circle and ellipse interpolation. at last the protocol transferring program data to robot from off - line system is analyzed
在離線編程的系統的設計中，實現了cad的建模、點膠軌跡的程序示教、工藝參數編輯、軌跡規劃、後置處理等功能，並在規劃模塊中針對平面內不規則排列點進行點膠的軌跡規劃進行了初步探討，採用圖論的方法，給出滿足實際要求且演算法復雜度較小的最短閉合迴路的程序演算法;在離線編程系統的後置處理模塊中，介紹了直線、圓弧、橢圓弧的dda插補方法以及脈沖分配不均勻的改進方法;最後對通信協議的制定進行了分析。It first shows the building of stochastic, time - dependent network model, the description of k expected shortest paths problem, the demonstration of travel time probability distributions for the arcs in transportation area, and the calculation of expected travel time on path
本文首先給出了隨機時間依賴網路模型（ stdn模型） 、 k期望最短路徑問題的形式化描述，並針對交通應用領域推導出弧耗費服從的概率密度函數，路徑期望值的計算方法。
分享友人