有效尺寸 的英文怎麼說

中文拼音 [yǒuxiàochǐcùn]
有效尺寸 英文
effective dimensions
  • : 有副詞[書面語] (表示整數之外再加零數): 30 有 5 thirty-five; 10 有 5年 fifteen years
  • : Ⅰ名詞(效果; 功用) effect; efficiency; result Ⅱ動詞1 (仿效) imitate; follow the example of 2 ...
  • : 尺名詞[音樂] (中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」) a note of the scale in ...
  • : Ⅰ量詞(長度單位) cun a unit of length (=1/3 decimetre)Ⅱ形容詞(極短或極小) very little; very ...
  • 有效 : effective; valid; efficacious
  1. But the whole effect is spoiled when i look at them - at tetralani, five feet ten in her stocking feet and weighing a hundred and ninety pounds, and at barillo, a scant five feet four, greasy - featured, with the chest of a squat, undersized blacksmith, and at the pair of them, attitudinizing, clasping their breasts, flinging their arms in the air like demented creatures in an asylum ; and when i am expected to accept all this as the faithful illusion of a love - scene between a slender and beautiful princess and a handsome, romantic, young prince - why, i can t accept it, that s all

    可是我一看見他們倆,整個果就破壞了。我看特綽蘭尼,兩條胖腿,身高五英十英,體重一百九十磅再看巴瑞羅,只可憐的五英四英,一張油光光的臉,一副鐵匠般的胸脯,卻矮墩墩,不夠。再看看這一對,裝腔作勢,抓著胸脯,像瘋人院的狂人那樣在空中揮舞著兩條胳膊,卻要我承認那是一個美麗窈窕的公主跟一個英俊瀟灑的年輕王子的戀愛場面嗨,我就是接受不了,只能接受不了。
  2. The gravity analysis is carried out especially for the synthetic fused silica and calcium fluoride used in 193nm lithographic objective as well as the optical elements with structural sizes of ( 200mm ~ ( 300mm. large numbers of analysis data for surface shape error are obtained by using algor finite element analysis software. then these data are plotted into curves and comparison analysis will be carried out, finally the measures and schemes for reducing gravity deformation are proposed

    因此,本論文重點對大口徑光學系統在高精度光學鏡頭裝校中,因重力變形進行了詳細的分析研究,特別針對193nm光刻物鏡系統所使用的材料sytheticfusedsilica和caleiumfluoride以及用到的結構200mm ~ 300mm光學零件進行了重力變形分析,使用algor限元分析軟體獲得了大量的面形誤差分析數據,然後將這些數據繪成曲線進行對比分析,最後提出了減小重力變形的措施與方案,並進行了實驗,驗證了分析結果是正確的,減小重力變形的方法是的。
  3. For increasing the effective material peak - value power ( empvp ), solving the contradiction between enhancing the pmsm ' s flux - weakening capability in the electromotor state and reducing the pmsm ' s connatural adjustment ratio in the dynamotor state and improving the efficiency of the pmsm, some solving method are taken as follows : the influence of length / diameter ratio to the empvp is analyzed, and the optimum size of length and diameter is chosen

    主要是從提高電機的材料峰值功率、解決pmsm提高電動機運行狀態時的弱磁擴速能力和減小發電機運行狀態時的電壓調整率之間的矛盾及提高電機的率著手,分析了長徑比、氣隙長度對材料峰值功率的影響,並確定了它們的最佳
  4. The near - stoichiometri litao3 has excellent speciality, such as high efficient conversion, tune conveniency, biger size and high damnify value etc. in this dissertation, the theory of quasi - phase - matched ( qpm ) technology and optical parametric oscillation ( opo ) was expatiated and studied first

    近化學計量比litao3 ( slt )晶體在做參量振蕩方面具轉換率高、調諧方便、大、損傷閾值高等非常好的特性。本文首先對準相位匹配技術和光學參量震蕩器的理論進行了闡述和分析。
  5. Because of the interaction of urushiol chains and cus, the transformation temperature tg of hybrid - epu / cus was higher than that of epu. heat stability and solvent resistance were also improved. the interaction and network of urushiol chains were efficiency to inhibit the dimension of cus nanoparticles

    漆酚鏈段與cus之間的作用,以及漆酚交聯網路的存在可阻止cus顆粒的增大,但漆酚交聯網路產生的空間位阻也在一定程度上降低了sz 」的擴散。
  6. By taking the miniature ceramic rod which is easily to machine high accuracy as sensitive structure, and by printing and polarizing six belt - shaped electrodes above it to constitute three pairs of electrodes, this paper designed package and the phase - sensitive detection circuit in the system so that it effectively reduced the sensitive structure size and improved its processing precision to realize the angular rate gyro microminiaturization

    首先採用易於加工成高精度的微型陶瓷棒作為敏感體,在其上印刷成六個帶狀電極並予以極化構成三副電極對,然後設計了封裝及相敏檢波電路,從而地減小了敏感結構的,提高了其加工精度,實現了角速率陀螺微型化。
  7. Developing the lithography process models to properly characterize critical dimension ( cd ) variations caused by proximity effects and distortions introduced by patterning tool, reticule, resist exposure, development and etching, they are beneficial to develop a yield - driven layout design tool, the engineers could use it to automate the tasks of advanced mask design, verification and inspection in deep sub - micron semiconductor manufacturing

    建立準確描述由於掩模製造工藝、光刻膠曝光、顯影、蝕刻所引起的光學鄰近應和畸變所導致的關鍵變化的光刻工藝模型,助於開發由成品率驅動的版圖設計工具,自動地實現深亞微米下半導體製造中先進的掩模設計、驗證和檢查等任務。
  8. The following results were found, i. e., the water ratio affects obviously the acoustic wave velocity of rock sample ; the wave velocity is higher in saturated rock samples than in unsaturated ones ; and it decreases gradually with the strain of samples during uniaxial compression ; and also with the lengthening holding time at 160 ; when heating the samples the acoustic wave velocity increases slightly in initial stage and comes to the peak value at 60, then decreases gradually with increasing temperature ; meantime, there is a certain temperature effect on rock samples size

    實驗發現含水率對波速影響比較大,飽和巖樣的聲波傳播速度高於不飽和巖樣的聲波傳播速度;人工預制裂紋對聲波傳播速度影響不大;單軸壓縮條件下,聲波傳播速度隨應變增加逐漸降低;在同一溫度( 160 )下,波速隨保溫時間的增加而逐漸降低;在對巖樣逐漸加熱情況下,初始加熱階段波速略升高,當溫度達到60時,巖樣波速達到峰值,之後隨著溫度繼續升高其波速逐漸下降;波速隨溫度變化具一定的應。
  9. Others : the ge series machines are universal cnc lathes for different batch sizes and the most varied shapes of workpiece. they are flexible, highly effizient, accurate and economical

    Ge系列均系萬能數控車床。適合於不同及現狀各異的板材,工作范圍彈性大、率高、精度高而且經濟合算。每臺機器配備一套刀具架。
  10. A novel bi - directional dc / dc converter was introduced in the dissertation, which based on refer much converter data. the soft switching, phase - shifted pwm and bi - directional dc / dc converter hang together, depress circuit switch ullage and noise effectively, which provide condition to increase switch frequency, efficiency and reduce size and weight for the converter ; at the same, the converter have the virtue of structure compact, voltage and current stress small etc such as ordinary hard switch converter

    本文作者在查閱國內外大量雙向dc dc變換器資料的基礎上,採用一種新型雙向dc dc變換器的拓撲結構,把軟開關技術和移相控制pwm技術以及雙向dc dc變換器技術機結合在一起,地降低了電路的開關損耗和開關噪聲,為變換器裝置提高開關頻率、率以及降低及重量提供了良好的條件。
  11. The outer dimensions should be such that maximum utilization can be made of the available storage space.

    外壁的大小,應使的貯藏空間能達到最大限度的利用。
  12. A series of near roundness cds nanoparticles with a particle diameter of 3 ~ 6nm have been prepared by controlling the concentration and proportion of reactants and adopting sodium hexametaphosphate as stabilizing agent. the studies demonstrate that these particles present obvious quantum size effect and an appropriate excess of cd2 + ion and hexametaphosphoric acid group polysnion are helpful to the dispersion and flame capability ' s improvement of particles. another series of near roundness monodisperse au nanoparticles with a diameter of 12. 3nm was prepared via sodium citric acid deoxidizing auric chloride acid

    利用六偏磷酸鈉作為穩定劑,通過控制反應物的濃度及比例,制備了粒徑為3 6nm 、呈近似球形的cds納米顆粒,光譜測試結果表明,顆粒具明顯的量子應,適當過量的cd ~ ( 2 + )離子以及六偏磷酸根聚陰離子助於顆粒的分散並提高其發光性能;採用檸檬酸鈉還原氯金酸,制備了接近球形、平均粒徑約為12 . 3nm的單分散體系au納米顆粒;採用wessling的前驅聚合物法獲得導電聚合物ppv前驅體。
  13. Because of its resistance to electrochemical erosion, low manpower demand for application and minimal changes in geometrical dimensions of the member, the method has been found to be economical and efficient for application, based on the previous work, we designed and conducted experiments of 10 reinforced concrete ( rc ) slabs strengthened with the common carbon fiber reinforced plastic ( cfrp ) ; and investigated the effect, failure mechanism and theory

    由於具耐腐蝕、施工簡便快捷、幾乎不改變構件原等特點,得到廣泛的應用,具良好的經濟益。在前人的工作基礎上,我們設計、試驗了10採用碳纖維布加固的鋼筋混凝土單向板,探討了加固單向板的加固果和理論分析方法。
  14. The research work presented in this dissertation provides an efficient approach to analyze the dielectric objects and metal - nonmetal composite objects ’ transient electromagnetic scattering phenomena, as well as a solid foundation for the further development in this subject

    本文的工作為分析介質體、金屬非金屬組合目標時域電磁散射現象提供了的方法途徑,也為運用時域積分方程求解結構更為復雜、更為電大的金屬非金屬組合目標的研究打下了堅實的基礎。
  15. The diffraction efficiency changing with grating parameters, especially for the situation that gaussian beams diffracted by finite grating, is numerically studied. 3

    對單色平面波和高斯光束入射矩形光柵時的衍射率與光柵柵距、槽深、開口比和入射角等參數的關系進行了模擬計算。
  16. Cockpit installation. standard pilot. minimum useful dimensions

    駕駛艙設備.標準駕駛儀.最小有效尺寸
  17. Cockpit installation. standard pilot. maximum useful dimensions

    駕駛艙設備.標準駕駛儀.最大有效尺寸
  18. It possesses small - dimension effect, quantum dimensional effect and surface effect

    它具應、量子應和表面應。
  19. The nanometer particles are metastable materials that lie between macroscopical materials and atoms or molecules with the characteristics of little size effect, quantum measurement effect, surface effect and macroscopical quantum tunnel effect, etc., thus demonstrating some special properties

    納米粒子是介於宏觀物質與微觀原子或分子之間的過渡亞穩態物質,具應、量子應、表面應與宏觀量子隧道應等,從而表現出一些特殊的性質。
  20. Effective dimensions lwh

    有效尺寸lwh
分享友人