板條混凝土 的英文怎麼說

中文拼音 [bǎntiáohúnníng]
板條混凝土 英文
lath concrete
  • : Ⅰ名詞1 (片狀硬物體) board; plank; plate 2 (專指店鋪的門板) shutter 3 [音樂] (打拍子的樂器) ...
  • : Ⅰ名詞1 (細長的樹枝) twig 2 (條子) slip; strip 3 (分項目的) item; article 4 (層次; 秩序; 條...
  • : 混形容詞1. (渾濁) muddy; turbid2. (糊塗; 不明事理) foolish; stupid
  • : 動詞1. (凝結) congeal; curdle; coagulate 2. (注意力集中) fix
  • 板條 : [建築] lath; stave; blade; panel; slat; batten
  • 混凝土 : concrete; beton; jetereting混凝土壩 concrete dam; 混凝土板 concrete slab; 混凝土標號 concrete gra...
  1. The two specimens, which are designed as : main beam - pre - stress beam ? floor ? frame columniation assemble the space specimens. in order to checkout whether the code can be applied for the special structure systems, the structure of the specimens refer to the current gb50010 - 2002 concrete structure design code and gb50011 - 2001 seismic resistant code

    本文試件的各組成構件為:非預應力邊梁預應力梁框架柱組合空間試件,各組成構件的構造參照了現行《 gb50010 - 2002結構設計規范》及《 gb50011 - 2001抗震規范》的有關規定,以檢驗規范及設計例能否適用於該特殊結構形式。
  2. Abstract : duri ng concrete deep well constructi on , because of thediffi culti es i n engi neeri ng geographi cal conditi ons , the ordi nary bilateral hydrauli c sli di ng formwork technology can not be adopted. therefore , an unilateral sli di ng formwork technology lifted by chai n block method can beappli ed to advantage and better solved the proble m

    文摘:在深井施工中,由於受地理環境的限制,不能內外安裝模時,難以應用一般的液壓滑模施工技術,而採用單面模、鏈葫蘆提升滑模工藝,可較好地解決這一問題。
  3. Study on the characteristic of piezoceramic actuator is an important step in the studying of undamaged - inspection process based on piezoceramic actuator technology. this thesis firstly dwells on the sample model of piezoceramic actuator under the restriction of concrete. through theory and experimentation analysis, we arrives at a conclusion that the vibration behavior of piezoceramic actuator belongs to that of the thin plate

    本文著重研究了在約束件下壓電陶瓷片的樣本模型,在此基礎上通過理論探討和實驗現象分析,認為埋置於中的壓電陶瓷片是符合彈性力學中克希霍夫有關薄理論的假設,是屬于薄振動問題,並確定了其邊界約束件。
  4. It also analyzed the whole stress of the ribbed shell structure under the explosive load. the analytic result keeps well with that of the dynamic response of 6. 8kg tnt. it shows that this analytic method in this paper is feasible for the design and inspection of cave depot of single aircraft

    通過理論計算與6 . 8kgtnt裝藥爆炸時的動力響應實測比較,兩者數值吻合很好,表明本文計算分析方法是可行的。為鋼-拱型復合結構的設計與檢驗提供了理論基礎,為飛機單機掩蔽庫工程的設計檢驗提供了一可行的計算分析方法。
  5. This paper presents the experimental results of typical elements of field works such as reinforced concrete beams, fiber glass reinforced plastic honeycomb sandwich plates, flexible covers ; examines the interrelationship of the loads and deformation under the condition of large deformation ; obtains the laws governing the interaction of the medium and the structure ; solves the design and calculation problems related to shallow buried structures in soil

    本文在對大量試驗資料進行整理和作了大量分析計算的基礎上,選取了野戰工事中有代表性的構件即鋼筋梁,玻璃鋼蜂窩夾層梁式和帆布被復作為研究對象進行試驗研究。深刻地考察了大變形件下荷載和變形之間的內在關系,進而掌握了介質與結構相互作用的規律,較好地解決了中淺埋結構的設計計算問題。
  6. Steel tubes. welded tubes for heating panels encased in concrete. dimensions. technical delivery conditions

    鋼管.用包覆的加熱用焊接鋼管.尺寸.交貨技術
  7. Secondly, the basic methods for parameter identification and the identifiability of parameter identification are dissertated. through the example of the problem of heat emission in one - dimensional infinite slab, the identifiability of thermodynamic parameter of concrete is proved theoretically

    論述了參數辨識的基本方法和參數可辨識性的件,以一維無限大平的散熱問題為例,從理論上論證了熱力學參數可辨識性。
  8. Specification for concrete mixer liner

    攪拌機.攪拌機襯技術
  9. Hollow clay blocks for floors made with precast concrete beams

    用帶預制的陶空心磚
  10. Concrete hollow panels contained industrial fly ash and waste slags for partition wall in buildings

    工業灰渣空心隔墻
  11. Dtu 65. 8 - building works - execution of floor heating with hot water through synthetic pipes set in concrete - part 1 : technical specifications - part 2 : special clauses

    Dtu 65 - 8建築工程.中埋設地熱水供暖用人造管道的施工.第1部分:技術規范.第2部分:特殊
  12. Combined with a concrete face rock - fill dam in process, the simulation analysis on the face slab ' s temperature field and temperature stress is processed in connection with the condition of temperature sudden drop caused by daytime temperature differences and cold wave and so on during the construction period

    摘要結合某在建的堆石壩,針對施工期日溫差及發生寒潮等氣溫驟降情況,進行了氣溫驟降件下面溫度場及溫度應力的全過程模擬分析。
  13. Identification and study on the boundary conditions of concrete beams and slabs

    類構件邊界件識別與研究
  14. Experimental investigation on the effects of deck constraint on the mechanical properties of reinforced concrete arch bridges

    橋面約束件對鋼筋拱橋力學性能影響的試驗研究
  15. Standard guide to methods of evaluating moisture conditions of concrete floors to receive resilient floor coverings

    承納彈性地覆蓋物的潮氣件的評定方法標準指南
  16. So it is quite important for sfrc to be used in those essential parts, such as the vicinity of frame column or shear wall in basement. the sfrc greatly improves the punching shear carrying capacity in raft foundation, or reduces the thickness of raft foundation in the same load. this in turn offers convenience in construction, reduces hydration heat in concrete and saves investments

    因此,將鋼纖維用於特別需要的那些部位顯得尤為重要,比如用於筏形基礎的框架柱或剪力墻附近,大大提高基礎的抗沖切承載力,在荷載一定的件下可減小筏的厚度,將會給施工帶來方便,減少水化熱,節約建設投資。
  17. Nondestructive testing is a very important and difficult research lesson about the defect of concrete structures. this paper mainly measures the stress waves conveying in concrete structures and the depth of surface - opening cracks in concrete plates by using impact echo method after carefully reading a lot of articles about the state and the abroad of concrete nondestructive in the field and incorporating the special conditions on the laboratory

    結構物的缺陷的無損檢測是一個非常重要而又非常困難的研究課題,本論文在大量參閱了國內外關于結構物無損檢測的研究資料后,結合本實驗室的具體件,應用沖擊反射法集中對應力波在塊內傳播速度和結構物內部開口裂紋深度的測量等一系列問題展開了研究。
  18. In order to determine the relations between the four main bond - anchoring factors - concrete strength, concrete cover thickness, steel shape embedment length and the ratio of the transverse hoops - and the bond strength, and establish the bond - slip constitutive relations, 16 standard push - out test specimens were designed, and 4 comparison specimens were additionally designed to find the difference of the bond performance between the web, inside and outside of flanges the steel shape

    設計了16個型鋼標準推出試件,以考察強度、型鋼的保護層厚度、型鋼埋置長度及橫向配箍率四個主要錨固件與粘結強度的相互關系和型鋼粘結滑移本構關系;設計了4個對比試件,以考察型鋼翼緣內側、外側和腹粘結性能的區別。
  19. Nonlinear constitutive relations are discussed for analyzing the stress distribution, the appearance and development of the cracks, as well as the behavior of the boundary conditions of the two way slabs respectively. in the light of the experimental research on r. c. two way slabs under static loading, the behavior of yield line, the load deformation curves and the crack yield, plastic limit loads of slabs with different supporting conditions are studied

    根據反映雙向材料非勻質性的本構關系,分析了雙向在荷載作用下的變形、屈服、裂縫和破壞的形態特性,並對鋼筋雙向在不同支承件下的塑性極限荷載、正常使用撓度(曲線)和截面設計作了進一步研究。
  20. On the basis of the traditional elasticity theory, nonlinear theory, ultimate theory and theory of reinforced concrete slabs with simple - supported condition, this paper analyzes the whole process of reinforced concrete thin slabs in the loading test of distributing static load, on the objects of reinforced concrete thin slabs with complex geometry, complex boundary condition and distributing of reinforce bars. and then analyzes the load capacity under the effecting of static load

    本文在傳統的鋼筋彈性理論、非線性理論和極限理論以及在簡單支承件下的鋼筋理論的基礎上,以復雜幾何形狀、邊界件及配筋形式的鋼筋為研究對象,對其在靜力分配梁加載下的加荷試驗的全過程進行分析,並對其在靜荷作用下的受力性能進行分析。
分享友人