板的尺寸 的英文怎麼說

中文拼音 [bǎndechǐcùn]
板的尺寸 英文
board dimensions
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 的 : 4次方是 The fourth power of 2 is direction
  • 尺 : 尺名詞[音樂] （中國民族音樂音階上的一級 樂譜上用做記音符號 參看「工尺」） a note of the scale in ...
  • 寸 : Ⅰ量詞（長度單位） cun a unit of length （=1/3 decimetre）Ⅱ形容詞（極短或極小） very little; very ...
  1. Specification for dimensions of conduit dies, diestocks and guides

    導管模板牙架與導架的尺寸規范
  2. The method can be applied when the size of hull grillage beam and exciting frequencies cannot be easily changed

    該法適用於船體板架尺寸、激勵頻率不易改變的調頻情況。
  3. Moulded rubber top - pieces for shoe heels ; dimensions for nailhole patterns

    鞋跟用的模製橡膠頂層件.釘孔樣板的尺寸
  4. 3. when the number of the nodal circles and the design frequency are given, the stepped circular plate satisfying the requirement can be designed

    在給出設計頻率和節圓數目的條件下，可以根據節圓處振幅為零可以設計出任一個節圓的階梯板的尺寸參數。
  5. Packaging - unit packaging - dimensions and requirements for pegboard display

    包裝.單件包裝.標記板顯示的尺寸和要求
  6. Packaging - unit packaging - dimensions and requirements for pegboard display ; german version en 13010 : 2003

    包裝.單元包裝.硬質纖維板顯示的尺寸和要求
  7. Deliberate, heavy, slow-moving, he measured the wood.

    他的動作不慌不忙，沉著，緩慢，他量了木板的尺寸。
  8. Tank size, supports, acid concentrations, charging schedule, plate alignment, etc. are the same as described.

    槽的尺寸，支架，酸的濃度，充電時間，極板的排列等與所描述的一樣。
  9. Resilient floor coverings - determination of the dimensional stability of linoleum tiles caused by changes in atmospheric humidity ; german version en 669 : 1997

    彈性鋪地材料.通過改變空氣濕度測定油氈板的尺寸變化
  10. The dimensions and shape of the board can be altered depending upon the preferences as well as the height and weight of the rider

    根據沖浪者的個人喜好、身高和體重的不同，板的尺寸和形狀可以自行調整。
  11. Pressed metal plate size and allow deviation, surface quality, quality coating should comply with the design requirements and norms

    壓型金屬板的尺寸及允許偏差、表面質量、塗層質量等應符合設計要求和規范的規定。
  12. Please adise the box sizes and dimensions you will use and also the number of boxes of each part that will fit onto a standard pallet ( please adise the standard pallet dimensions also )

    請告知包裝盒的尺寸及每一標準棧板上可堆放的箱數（另請告知標準棧板的尺寸） 。
  13. Please advise the box sizes and dimensions you will use and also the number of boxes of each part that will fit onto a standard pallet ( please advise the standard pallet dimensions also )

    請告知包裝盒的尺寸及每一標準棧板上可堆放的箱數（另請告知標準棧板的尺寸） 。
  14. Pressed metal plates the size of deviation should be allowed to meet norms. pressure produced by the metal plates to allow the construction site with a standard deviation requirements

    壓型金屬板的尺寸允許偏差應符合規范的規定。壓型金屬板施工現場製作的允許偏差符合規范的規定。
  15. By reducing bromine content and adding aluminum hydroxide in the surface of substrate for the printed circuit board, comparative tracking index ( cti ) of the substrate is improved significantly, meanwhile the size stability, heat resistance, the glass transition temperature of the substrate are improved too

    摘要通過降低印製電路板的基板表層的嗅含量並加入氫氧化鋁，顯著提高了基板的相比漏電起痕指數（ cti ） ，並同時提高了基板的尺寸穩定性、耐熱性、玻璃化溫度。
  16. Manually operated draughting machines. part 3 : dimensions of scale rule chuck plates

    手工操作繪圖機.第3部分:繪圖尺夾板的尺寸
  17. Study of practical formula about strength and rigidity of 6 - point - supported - glass using the super sap fea software to solve different calculation models - which have different parameters, such as a / b, a / c and so on, this paper achieves a series maximum deflection coefficients and maximum stress coefficients, then form calculation formulas of maximum deflection and maximum stress under the load of wind

    6點支承玻璃強度剛度實用的計算公式研究採用supersap有限元分析，求出不同的計算模型（玻璃板的尺寸參量a b ， a c不同） ，得出一系列最大撓度系數和最大應力系數，形成6點支承玻璃在風載荷作用下的最大撓度計算公式和最大應力的計算公式。
  18. It has been demonstrated that it is the microgel that guaranteed the homogeneous of the structure of the composite, the size and the morphology of the composite particles. the surface structure of the micro - particles can be adjusted by changing the preparing conditions. the composites may adopt hollow sphere structure, and the inner may lack of cds due to precipitation was started from the outer part of the microgels

    實驗結果表明：高分子微凝膠的三維網路結構和所採用的制備方法確保了有機-無機復合材料復合的均勻性；微凝膠的模板作用使得復合材料呈球狀結構，微球的大小決定於模板的尺寸；微球的微納米結構可因微球的制備條件的不同（例如，改變連續相類型）而不同。
  19. Technical product documentation - sizes and layout of drawing sheets

    技術產品文獻.制圖紙板的尺寸和布局
  20. Antenna parameters studies are presented and practical design considerations for achieving high gain and wide bandwidth are given. in chapter 4, a novel pifa with high radiation efficiency is designed for a tri - band mobile handset application

    天線印刷線路板的尺寸等參數對天線諧振頻率和帶寬的影響在本章中詳細研究，一個詳細的實際設計例子也在本章中介紹，測試結果表明天線獲得了較高的增益和較寬的帶寬。
分享友人
分享到 Line

分享到臉書