校正電路 的英文怎麼說

中文拼音 [jiàozhēngdiànlù]
校正電路 英文
calibrating circuit
  • 校 : 校名詞1. （學校） school 2. （校官） field officer3. （姓氏） a surname
  • 正 : 正名詞（正月） the first month of the lunar year; the first moon
  • 電 : Ⅰ名詞1 （有電荷存在和電荷變化的現象） electricity 2 （電報） telegram; cable Ⅱ動詞1 （觸電） give...
  • 路 : 1 （道路） road; way; path 2 （路程） journey; distance 3 （途徑; 門路） way; means 4 （條理） se...
  • 校正 : check; correction; adjust; revise; proofread and correct; rectify; calibrate; make true; master c...
  • 電路 : [訊] circuit （ckt）; electric circuit; electrocircuit電路板 circuit board; 電路保持 guard of a c...
  1. The new system consists of a single - chip computer system ( at89c51 + psd311 ) and alow power consumed analyzer by applying a new adc chip ads774, and a dead - time correcting circuit is designed to correct the collecting time

    本系統由單片微機系統（ at89c51 + psd311 ）組成多道緩存，由低功耗模數轉換器組成分析器，與微型計算機通過列印并行介面實現數據通訊，並含有死時間校正電路。
  2. In the hardware design, the paper completes modules ’ design like outside memory, patulous a / d, patulous d / a, rs232 communication, ecan communication, led control, keyboard control, distant control, emulation, reset, logic voltage switch, dsp supply power regulate and ac - dc power circuit, as well as room layout design like anterior panel, back panel etc. and dsp transfers data with peripheral equipments except outside memory using serial ports. besides, the whole circuit is configured in interrupt response. thus, it can meet system demand as well as take full advantage of tms320f2812 ’ s hardware resource. in the software design, the paper finishs programs like the interface programms intercommunicates with people, the distant control program, ad and da modules ’ control program, in addition, the paper select the velocity and acceleration state - feedback algorithm and is written in the program. the software design uses dsp integrate exploiting environment named ccs2. 2 of ti inc. as software instrument, and programs with the combination of c language and assembly language. moreover, in order to maintenance or modify the software expediently and shorten software ’ s exploitation time, the design adopt software modularization technique. finally, some air cylinder experiments are carried out to proved that the pneumatic controller is very practical

    在硬體設計中，本文完成了片外存儲器擴展、 a / d擴展、 d / a擴展、 rs232通信介面、 ecan通信總線介面、液晶顯示控制、鍵盤控制、遠程控制、模擬、復位、邏輯電平轉換、 dsp工作電源校正電路和ac - dc電源等模塊設計以及控制器前面板、後面板等的空間布局設計。其中dsp與除外部存儲器的外圍設備之間的數據傳送全部採用串口通信，同時系統電路配置成中斷響應方式，這樣既滿足了系統要求，又充分利用了tms320f2812的硬體資源。在軟體設計中，本文完成了人機界面功能模塊、遠程控制模塊、 ad擴展模塊、 da擴展模塊、速度和加速度狀態反饋的控制演算法的程序設計。
  3. This paper starts the research of the liquid floated pendulous accelerometer testing system according to the engineering. at first, this paper gives the brief introduction of the history and present status of accelerometer and its testing technology, the working principium and math model of the liquid floated pendu - lous accelerometer, and then, decides the binary width pulse force retrim loop as the design proposal of testing system, researches the transfer function of every part in the system emphasizly, analyses the stability of the whole accelerometer testing system from the angle of control theoretics by the open loop transfer function of system, and designed the correcting net, analyses the basal problems such as resolution, sampling restraint, precision and so on, designs the hardware testing circuits such as preamplification, band - pass filter, alternating amplifier, phase sensitive demodulatorn, pulse - width modulation, frequency scale circuit, moment current generator. finally, using the graphics program language labv - iew which is designed for testing field especially by ni accomplishes the solfware design of testing system, realized the testing functions

    首先對加速度計及其測試技術的發展歷史和現狀，液浮擺式加速度計的工作原理和數學模型等作了簡要的介紹，然後確定了以二元調寬脈沖再平衡測試迴路為設計方案，並從控制理論的角度進行了分析，著重研究了系統中各部分的傳遞函數，利用系統開環傳遞函數分析了系統的穩定性，同時設計了系統的校正網路;分析了二元調寬脈沖再平衡測試迴路的解析度、采樣約束以及測試精度等基本問題，並按照系統分析的結果設計了包括前置放大、帶通濾波、交流放大、相敏解調、脈寬調制、頻標電路以及力矩電流發生器等測試系統各部分硬體電路，驗證了電路的正確性，最後按照測試系統的要求，採用了美國ni公司專為測試領域所開發的虛擬儀器工具? ? labview作為測試軟體開發工具，利用該圖形化編程語言完成了測試系統軟體部分的設計，實現了測試功能。
  4. Autocorrect processing errors caused by network fluctuation using neural networks

    神經網路自動校正電網波動引起的加工誤差
  5. And at this foundation through the dispersed domine analyse the paper makes a great emphasis on the application of computer aided design and simulation, then designs a series of apfc design and simulation software. this paper takes out a set of designation and simulation on base of actual circuit. the reliable result, output voltage and inductance current which are got from this software are the same as the actual value

    本文在對一系列apfc電路設計、模擬分析方法討論比較的基礎上，著重應用離散時域法進行了計算機輔助電路設計和模擬方法的應用探索，以此為基礎設計了pfcexpert功率因數校正電路設計、模擬軟體，針對實際電路給出了整個設計和模擬全過程，通過實驗驗證了該軟體所得到的精確穩態解、瞬態輸出電壓和電感電流，與實際電路輸出基本相同，所建立的電路模型重現了電路的運行過程，反映了電路的實際工作機理。
  6. Abstract : the author puts forward a constant - current control system of diode rectifier with saturable reactor in electrolytic aluminum. the working principle of saturable reactor is depicted. also analyzed are the system configuration and features of system correct circuit

    文摘:介紹了應用於電解鋁的加飽和電抗器的二極體整流器的恆流控制系統，簡述了飽和電抗器的工作原理，分述了系統構成和系統校正電路的特點。
  7. With an aim at this problem, this paper suggests the modulation scheme with dc bus voltage ripple by using the front - end active power factor correct circuit based on the analysis of necessary conditions of producing acoustic resonances

    針對這一現象，在分析產生聲諧振的必要條件的基礎上，重點提出了利用前級有源功率因數校正電路的直流母線脈動電壓的調制方案。
  8. Thus this thesis presents a method to estimate length and positive parameters of transmission line, and a method to estimate length, positive parameters and zero parameters of line at one time

    由此，本文提出了一種利用故障前的電氣量來校正線路正序參數和長度的方法，以及一種利用區內出現的缺相運行情況對線路正序、零序參數和長度同時進行校正的方法。
  9. In order to improve the circuit ' s input impedance, which is affected by insulating resistance of electrode leading wire, terminals and printed circuit board, electrode is connected to the meter through insulating wire of high impedance which is directly welded in the printed circuit board with insulating ring. the deviation of electrode is corrected by software and the algorithm is given

    使用高阻絕緣線連接電極，並將高阻絕緣線直接焊在加有絕緣環的印刷線路板上，從而消除電極引線、接線端子和印刷線路板漏電對放大電路輸入阻抗的影響；軟體校正電極偏差，並給出校準演算法。
  10. Contour correction circuit

    輪廓校正電路
  11. It consists of forward stage and backward stage, of which the forward stage is a single - phase boost power factor correction circuit using ic uc3854. the backward stage main circuit is a full - bridge converter using phase - shifting control soft - switching technique

    該開關電源分為前級和后級，前級為採用boost結構的單相有源功率因數校正電路，后級為採用移相控制軟開關技術的全橋變換器。
  12. The requirements are the following : ( 1 ) input voltage : 220 vac ; ( 2 ) output voltage : 48 vdc ; ( 3 ) output current : 20 adc ; ( 4 ) switching frequency : 80khz ; ( 5 ) operated frequency of apfc : 100khz the simulated software pspice 7. 1 realizes simulation research of the main circuit, and the simulated result of key waveforms in the main circuit is introduced

    設計指標為：輸入電壓為交流220v ，頻率為50hz ，輸出電壓和電流為48v ， 20a ，功率因數校正電路的工作頻率為100khz ，直流變換器電路的工作頻率為80khz 。利用模擬軟體pspice7 . 1對主電路進行了模擬研究，並介紹了主電路的幾個關鍵波形的模擬結果。
  13. Clolour correction circuit

    彩色校正電路
  14. Based on the detailed analysis of the principle of single - phase active pfc, the high power active pfc circuit is designed, and the method of designing boost inductor is also given in the paper. a high power phase - shifted - control soft - switching full - bridge converter is designed, and the condition of achieving zvs ( zero voltage switching ) is studied in detail

    論文在詳細分析和研究單相有源功率因數校正原理的基礎上，設計出大功率有源功率因數校正電路，並給出電路中升壓電感的設計方法；設計出了大功率移相控制全橋軟開關pwmdc dc變換器，詳細的研究了實現zvs的條件。
  15. Advanced non - linear adjustment circuit

    先進的非線性校正電路
  16. A design of switching power for novel power factor correction

    新型功率因素校正電路的開關電源設計方案
  17. Recently, internal and overseas investigators are developing single - stage pfc circuit, which has higher pf and lower price

    現在國內外正在開發研究單級功率因數校正電路，具有很高的功率因數，且成本低。
  18. A sort of spic ? pfc ( power factor corrector ) circuit also gradually become a major concern for research along with the concern of power harmonics pollution

    智能功率集成電路中的功率校正電路也隨著人們對電源諧波污染的關注而逐漸成為一個重要的研究對象。
  19. What more, this paper presents the theory of the power factor correction, and design the appropriated circuit with the chip of pfc - uc3854a / b

    本文簡單介紹了無源和有源功率因數校正的工作原理，並利用功率因數校正晶元uc3854a b製作了電子鎮流器的功率因數校正電路。
  20. The main job accomplished of this paper includes : according to the principle and the discussion of the single - phase active power correction, the pfc system, which adopts cuk power converter circuit and average current mode control scheme is indicated as the developing direction of pfc and regarded as the pfc system structure

    全文圍繞設計cuk型平均電流控制的功率因數校正電路展開，主要完成了以下工作：論文在分析有源功率因數校正器基本工作原理的基礎上，通過比較幾種不同拓撲的pfc變換器主電路和控制電路的優缺點，明確了本文所要研究的對象?平均電流型控制的cuk型pfc變換器。
分享友人
分享到 Line

分享到臉書