極化溶劑液體 的英文怎麼說
中文拼音 [jíhuàróngjìyètǐ]
極化溶劑液體
英文
polar solvent liquid- 極 : i 名詞1 （頂點; 盡頭） the utmost point; extreme 2 （地球的南北兩端; 磁體的兩端; 電源或電器上電流...
- 溶 : 動詞（溶化; 溶解） dissolve
- 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
- 液 : 名詞（液體） liquid; fluid; juice
- 體 : 體構詞成分。
- 極化 : [物理學] polarization; overpotential; overtension; polarity極化器 polarizer; 極化強度 intensity o...
- 溶劑 : dissolvant; solvent; resolvent; solventia; menstruum
- 液體 : liquid; liquor; fluid
-
A novel aqueous two - phase system can be formed by the mixtures of a polymer and cationicanionic surfactants. such a system can be used as a partitioning system of proteins. in this work, we investigated the formation, phase behavior and protein partitioning in aqueous two - phase systems formed by dodecyltriethylammonium bromide / sodium dodecylsulfate / peg and dodecyltriethylammonium bromide / sodium dodecylsulfate / dextran. the ligands with affinity were attached to the polymers and the affinity partitioning of proteins was investigated. it was shown that the surfactants and polymers are enriched in different phases of aqueous two - phase systems. phase separation are promoted by increasing temperature and adding inorganic salts. different proteins are partitioned in different phases. the selectivity of protein partitioning is increased by adding ligands with affinity
報道了由正負離子表面活性劑與高聚物混合溶液形成的一種可用於蛋白質的分離及分析的新型雙水相萃取體系.研究了正負離子表面活性劑（溴化十二烷基三乙銨/十二烷基硫酸鈉）分別與葡聚糖和聚乙二醇混合雙水相體系的形成規律、相行為及牛血清蛋白和溶菌酶在雙水相體系中的分配.通過在高聚物分子中接上親和配基，研究蛋白質在雙水相體系中的親和分配.結果表明，在該體系中，表面活性劑與高聚物分別富集於不同相中.升高溫度及加入無機鹽均可促進雙水相體系的形成，不同蛋白質可分配于不同的相中.親和配基的引入極大地增強了蛋白質分配的選擇性The optimum conditions for air electrode preparation were shown as follows : active carbon which was baked for 15 min in 900 as carrier for catalyst, bond is 60mass % polytetrafluoroethylene ( ptfe ) liquor, 20 % ptfe in waterproof layer, 10mass % pore - making in waterproof layer thickness of waterproof layer 0. 30mm, 10mass % ptfe in catalysis layer, nickel screen for current collector, compacting pressure 6mpa
確定製備空氣電極的最佳工藝條件為:催化劑載體的處理條件為在900下灼燒15min ，粘結劑為60mass % ptfe的水溶液。防水層中pefe含量為20mass % ，造孔劑含量為10mass % ，其厚度為0 . 3mm 。催化層中ptfe含量為10mass % 。The analytic results of the effects on the micromorphological structure of the film by the electrochemical condition ' s showed that the carbon is apt to improve the boundary combination between the scfs and the surface of the cathode and the seperation of the films, and that the micromorphological structure of the mpgcfs is greatly affected by the dring and the power voltage, which remarkably affluence ion move in swelling cathode film, and that higher temperature and concentration of cu2 + in the medium solution are also advanagable to the deposition of cu in scfs. the plot of deformation behavior of mpgcfs showed that the maximum strench ratio decreases and the brittleness increases due to the existence of the metal phase, and that the strengh trend of the composite films is fistly up and down followed with the content of metal phase because of the change of the role of the metal phase from acting as the physical cross - linking to weakening the films due to destroying the whole structure of the polymer
另外它作為基體的另一個突出的優點是制備的溶脹復合膜（ scf ）中的溶劑與電解液中的溶劑相同都是水，克服了以前膜內外不同溶劑之間擴散的問題，結果使得電流最終趨於一種穩態，因此可以更好實現用電化學條件來控制mpgcf的形態結構；硬質石墨材料的多孔的結構和石墨本身的結構性能特點使得碳作為陰極材料時有利於溶漲復合膜（ scf ）與電極表面的結合以及膜的剝離，因此是作為陰極的理想材料；電化學條件中的乾燥程度和電壓能夠明顯的影響離子在膜內的遷移，從而對mpgcf的形態結構造成較大的影響；而提高反應溫度和增大電解液中銅離子的濃度也有利於銅在膜中的沉積生長。First, polymer - metal - solvent solution was prepared. secondly it was coated on the cathode surface. finally the electrochemical reduction was processed in a particular medium solution
首先制的聚合物?金屬?溶劑三元體系溶液，再將其均勻塗于陰極表面乾燥至一定的程度，最後放入電解質溶液中進行電化學還原。分享友人