極譜測量 的英文怎麼說
中文拼音 [jípǔcèliáng]
極譜測量
英文
polarographic measurement- 極 : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
- 譜 : Ⅰ名詞[書面語]1 (按類別或系統編成的書或冊子等) table; chart; register 2 (指導練習的格式或圖形)...
- 測 : 動詞1. (測量) survey; fathom; measure 2. (測度; 推測) conjecture; infer
- 量 : 量動1. (度量) measure 2. (估量) estimate; size up
- 測量 : measure; survey; gauge; meter; measurement; measuring; surveying; mensuration; metering; gauging;...
-
The determination of trace chloropicrin in air by osciilopolarography
示波極譜法測定空氣中微量氯化苦Determination of molybdenum and tungsten content - sulfuric acid - phenylhydroxyacetic acid - cinchonine - potassium chlorate medium polarographic method
氯酸鉀底液極譜法連續測定鉬量和鎢量Silicate rocks. determination of molybdenum and tungsten content. sulfuric acid - phenylhydroxyacetic acid - cinchonine - potassium chlorate medium polarographic method
硅酸鹽巖石化學分析方法硫酸-苯羥乙酸-辛可寧-氯酸鉀底液極譜法連續測定鉬量和鎢量Methods for chemical analysis of copper ores lead ores and zinc ores. determination of tungsten content. catalytic polarographic method in sulfuric acid - phenylhydroxy acetic acid - cinchonine - potassium chlorate system
銅礦石鉛礦石和鋅礦石化學分析方法硫酸-苯羥乙酸-寧-氯酸鉀底液催化極譜法測定鎢量Single - scanning - polarographic determination of trace amounts of iodate
單掃描示波極譜測定豆類中的痕量鉬Polarograph quantitative detection limit
極譜儀定量檢測限The polarography method for the determination of nickel content
極譜法測定鎳量The oscilloscopic polarography method for the determination of tin content
示波極譜法測定錫量The oscilloscopic polarography method for the determination of lead content
示波極譜法測定鉛量The oscilloscopic polarography method for the determination of zinc content
示波極譜法測定鋅量Determination of trace selenium in spirulina by oscilloscope polarography
螺旋藻中痕量硒的示波極譜測定The sulfhydryl cotton fiber separation - oscillopolarographic method for the determination of tellurium content
示波極譜法測定碲量Determination of trace tin in canned fruits by single sweep polarography
單掃描極譜法測定罐裝水果中微量錫The entropy or number of states of system or subsystem are closely related to interaction of particles and energy level distribution, therefore, to study the temperature dependence of the specific heat may supply some important and useful microscopic information which may play an important role in understanding electronic structure, density of state, phonon spectrum etc. the specific heat measurements at low temperatures also play important roles in the finding of the third law of thermodynamics, the quantum theory of solid and bcs theory for superconducting etc. moreover, specific heat measurements help us to understand the different kinds of phase transitions ( such as : structural phase transition, magnetic phase transition, superconducting phase transition etc. ) and the scaling behavior near the critical point
系統、子系統的熵或微觀狀態數與微觀粒子間的相互作用及能級分佈密切相關,因此研究比熱與溫度的依賴關系能夠提供被測量系統許多極其有用的微觀信息,對理解固體的電子結構、電子態密度、聲子譜等起著十分重要的作用。低溫比熱的測量和研究對熱力學第三定律、固體量子理論和超導bcs等理論的建立起到了積極的推動作用。比熱研究還有助於認識各類相變如結構相變,磁性相變,超導相變等及臨界點附近的標度規律。Determination of the detection limit and decision threshold for ionizing radiation measurements - part 8 : fundamentals and application to unfolding of spectrometric measurements without the influence of sample treatment
電離輻射測量的探測極限和判斷閾值的測定.第8部分:基本原理和不受樣品處理影響的光譜測量演變的應用Polarographic determination of microamounts of cobalt and nickel in pure aluminum
純鋁中微量鈷鎳的極譜測定However, the calibration of detection efficiency in tgs is more difficult and complicated than that in the conventional method
Tgs測量與常規能譜測量不一樣的是:探測效率的刻度極為困難。After the si photodiode was calibrated by synchrotron radiation, we can get the quantum efficiency of 5 to 50 nm bandwidth which made a transfer standard to spectrum measurement system
Si光二極體用同步輻射標定后,得到了5 50nm波段的量子效率曲線,函蓋實際實驗使用的8 30nm波段,使光譜測量系統的標定有了一個傳遞標準。In order to explain the phenmena, two supposes of " hole " and " polar - group rupture " are proposed, according to the tests of ir, density, refractive index, conductor volume resistivity, the aging model of pmma is confirmed likely
通過其他實驗(如紅外光譜、測量密度、測量折射率、測量體積電阻率)的相互對比,基本上肯定了有機玻璃「極性基團斷裂」的熱老化模型。In third chapter, the article introduced every part of whole spectrum measurement system, such as lpp source, monochromator, detecting system, data acquisition system and vacuum system
第三章是對整個光譜測量系統進行介紹,了解建立起一套極紫外和軟x射線光譜測量系統所需要的部件和各部件的工作原理,並對現有的測量系統作了一些改進。分享友人