樓板高度 的英文怎麼說

中文拼音 [lóubǎngāodù]
樓板高度 英文
finish floor level
  • 樓 : 1 （樓房） a storied building 2 （樓房的一層） floor; storey 3 （房屋或其他建築物上加蓋的一層房子...
  • 板 : Ⅰ名詞1 （片狀硬物體） board; plank; plate 2 （專指店鋪的門板） shutter 3 [音樂] （打拍子的樂器） ...
  • 高 : Ⅰ形容詞1 （從下向上距離大; 離地面遠） tall; high 2 （在一般標準或平均程度之上; 等級在上的） above...
  • 度 : 度動詞[書面語] （推測; 估計） surmise; estimate
  • 樓板 : [建築] floor; floorslab
  • 高度 : altitudeheightelevation
  1. Elastic theory and plastic theory are adopted in the analysis of the two section composite beam. elastic theory suggests, on the condition of the same steel beam section size, the composite beam for the floorslab is suited lower flanges convertion section stiffness cuts down by 75. 1 %, elastic limit bending resistant capability cuts down by 47. 9 %, than the composite beam for the floorslab is suited on the top flange. it s conversion section stiffness is lifted 8. 0 %, elastic limit bending resistant capability is lifted 0. 20 %, than the steel beam

    彈性理論分析的結果表明，在鋼梁截面大小相同的條件下，樓板位於鋼梁下翼緣的組合梁和樓板位於鋼樑上翼緣的組合梁相比，其換算截面剛度降低75 . 1 ，梁的彈性極限抗彎承載力降低47 . 9 ，樓板位於鋼梁下翼緣的組合梁和純鋼梁相比，其換算截面剛度提高8 . 0 ，梁的彈性極限抗彎承載力提高0 . 2 。
  2. Exceeding lower, the adjust floor height is about 35mm to 150mm, the building space can be economized

    超低安裝高度，地板調節高度范圍為35mm - 150mm ，節省樓層高度。
  3. In this paper, the author combines the theory analysis with the experiment research method, and discusses the seismic behaviours, 3d elaborate finite element analysis and simplified model analysis of a kind of multi - function tall building - " sub - shearwall supported by frame ", which is applied widely today. the main contents are as follows : in order to observe the failure process and the earthquake response of the complex structure, and to analysis the seismic behaviour of the structural system and structural members, a 1 / 20 cement mortor model of a complex tall - building which is about to be built was producted and the shaking table test of this model under 26 sorts of earthquake loads was made. using sap2000 finite element analysis program, a 3d analysis model was built in computer, and the elastic time - history analysis of the model was done

    本文採用理論分析和試驗研究相結合的方法，研究了目前應用較多的綜合性大廈? ?框支分區剪力墻高層商住樓的抗震性能及空間精細分析和簡化分析方法，主要內容為以下幾方面：對一擬建的復雜高層建築結構，採用1 20比例的空間整體模型，進行了26種工況下的模擬地震振動臺試驗，觀察了結構的破壞過程和地震反應，分析了結構及構件的抗震性能；建立了結構的精細空間模型，利用sap2000n大型有限元分析程序對結構進行了彈性時程分析；通過有限元分析與試驗結果的對比，對結構的抗震性能和抗震能力做出綜合評價，認為該結構由於轉換層上部去掉部分樓板，既可滿足建築設計的通風、採光等要求，又可達到協調結構轉換層上、下樓層抗側剛度的效果，是一種較理想的有多道抗震防線的結構型式。
  4. Standard specification for hot - rolled carbon, low - alloy, high - strength low - alloy, and alloy steel floor plates

    熱軋制碳素鋼低合金鋼高強度低合金鋼及合金鋼樓板的標準規范
  5. The second phase of this project, completed in 2005, was on a larger scale with 21 solar - powered water heaters installed on the roof of the university sports centre. the solar heating duct employed is different from the older type of solar - panels and is much more efficient. on sunny days the temperature of the water can reach 90 c ; following temperature adjustment, the water is provided to the sports centre and for showers in the kwok sports building

    第二期工程規模更大，有21套太陽能熱水器安裝在大學體育中心天臺，真空熱導管式太陽能熱水器有別于以往平板式太陽能熱水器，大大提高系統效能，在日照時份水溫可達攝氏90度，熱水經調溫后供體育中心及汾陽樓浴室淋浴之用。
  6. The research object in this text is the actual project - - the mansion of yatingyuan ( 40 layers above the ground, 125. 4 meter high ). the structure - design is by satwe and the analysis of the structure dynamic characteristic and earthquake response by sap2000, whose calculation models are set up according to the actual size of the structure. in satwe, the analysis model of beam and column is simulated by frame - element, slab is plane - element, shear - wall is wall - element and slab is infinitely rigid in the internal and zero in the external ; in sap2000, beam and column is frame - element, slab and shear - wall is shell - element and slab is elastic floor

    本文以實際工程項目? ?雅庭園商業中心大廈（地面以上40層，建築總高度為125 . 4米）為研究對象，結構設計採用satwe ，結構的動力特性和地震反應分析採用sap2000 。結構satwe和sap2000分析的計算模型均按結構的實際尺寸建立， satwe分析模型的樑柱採用桿元模擬，樓板用薄壁殼元模擬和剪力墻用墻元模擬，樓板平面內無限剛、平面外剛度為零； sap2000分析模型的樑柱採用桿元模擬，樓板和剪力墻用殼元模擬，樓板為彈性板。
  7. It ' s an ideal structural system and has multi - earthquake resistance ability because of a great deal of slabs removed in floors above the transfer - story amended the lateral stiffness of the stories near the transfer - story. based on the available references, the five - spring line element, the three - spring line element and the multiple vertical - line - element model are introduced to model special column, beam and shear - wall, the relevant stiffness matrixes are deduced and the restoring - force models are gaven to deep into the elasto - plastic seismic characteristics of the structure. acording to the results of shaking table test and elastic finite element analysis, a new making model melhod is presented in which uses the linear and the nonlinear element and the assumption that the floor is infinitely rigid in different areas

    為進一步研究這種復雜高層建築結構的彈塑性性能，本文在國內外現有研究的基礎上，提出利用五彈簧桿元、三彈簧桿元及多豎線單元模型分別模擬空間柱、梁和剪力墻，推導了相應的剛度矩陣並給出了恢復力模型；結合試驗研究和精細有限元分析的結論，提出線性和非線性單元相結合，剛性樓板假定和彈性樓板相結合的建模方法，較好地解決了空間結構彈塑性分析中佔用計算機資源較多的問題；接力大型有限元分析程序? ? ansys ，在上述建模思路的指導下建立了結構的空間非線性分析模型，進行了空間三維彈塑性時程分析。
  8. Consequently, the precast components don ’ t need any interim falseworks to be supported in the mid - span as bottom forms when the laminated concrete lay is being placed. furthermore, to form two - way slabs, the transverse steels can be arranged through the rectangular cores in the ribs of the precast slabs as needed. it makes the construction of composite two - way slabs easier and more feasible, practical, and suitable to introduce and apply to the building construction on a large area

    由於預制構件具有剛度大和承載力高的特點，施工時以預制構件作為樓板底模無需設置跨中臨時支撐;同時還能通過預制構件板肋預留的長方形孔布置橫向受力鋼筋實現樓板的雙向配筋，使預應力雙向疊合樓板的施工簡單易行，更適合於大面積的推廣應用，具有較大的工程應用價值。
  9. In the elastic term, the two load - displacement curves slope are similar, the new structure s slope is more greatly. stiffness is better than the traditional structure. but the new joint s crack load is littleer

    在彈性階段兩者的荷載-位移曲線斜率相差不多，而且新的連接形式斜率還大一些，它的剛度較傳統連接形式要好，但新的連接形式樓板開裂荷載稍偏低，應採取加強措施來提高開裂荷載。
  10. The floor of the high - rise frame structures is very suppleness when the frame structures subjected to the vertical seismic actions, it is impossible to confirm that each member has the same displacement in the same floor, so it is impossible that the summation of axes stiffness of each vertical member represent the global vertical stiffness of the frame structure

    高層建築框架結構在豎向地震作用下，樓板在豎向剛度是很小的，一般不予考慮，認為相對無限柔性，而梁的剛度也是有限的，不可能保證各豎向構件在同一樓層豎向位移相同，因此不能簡單地用各豎向構件軸向剛度之和來代表結構的總豎向剛度。
  11. It was quite dark when prince andrey rode into brnn, and saw himself surrounded by high houses, lighted shops, the lighted windows of houses, and street lamps, handsome carriages noisily rolling over the pavement, and all that atmosphere of a great town full of life, which is so attractive to a soldier after camp. in spite of the rapid drive and sleepless night, prince andrey felt even more alert, as he drove up to the palace, than he had on the previous evening

    當安德烈公爵乘車駛入布呂恩的時候，天色已經黑了，他看見周圍有一棟棟高大的樓房，商店和住宅的窗戶里燈火通明，一排排路燈閃爍著耀眼的光輝，豪華的馬車沿著石板馬路駛行，發出轔轔的響聲，這正是熱熱鬧鬧的大城市的氣氛，對那個度過一段兵營生涯的軍人來說，這種氣氛真是十分誘人的。
  12. Trough comparing the analysis results of two kinds of calculation model, drawing the following conclusion : ( 1 ) this structure - design satisfies the standard ; ( 2 ) in analyzing the complicated high - rise building with transfer - floor, it is very necessary to adopt at least two three - dimension - space analysis procedures with different mechanic model and use the response - spectrum analysis and time - history analysis to analyze the structure earthquake response ; ( 3 ) the calculation model with elastic slab is better than the other with being infinitely rigid in the internal slab and zero in the external slab, which reflects the real load - function situation of the structure

    通過比較兩種分析軟體的計算結果，得出以下結論： （ 1 ）本結構設計滿足規范要求。 （ 2 ）比較satwe和sap2000分析結果可知，對于復雜的帶轉換層的超高層建築結構應採用至少兩個不同力學模型的三維空間分析軟體進行整體計算以及採用振型分解反應譜法和時程分析法進行地震反應分析是必要的。 （ 3 ）在sap2000分析中，將樓板模擬成彈性板，與satwe分析中的樓板平面內無限剛平面外剛度為零的模擬方式相比，這種模擬方式能更真實的反應結構的實際受力情況。
  13. Specializing in produce all of the temperature meters, humidity meters and design the industry equipment controllers soft and hardware. our company rely on abundant technique, advanced produce appliance and modern management mode, our products have good quality and function. the company has been iso9001 : 2000 quality systems grant can b015 - q5439r10, has international facture calculate appliances license cmc zhejiang province 02810232

    工廠佔地6000平方米，擁有兩幢四層大樓，生產場所10000平方米專業生產所有溫度濕度顯示及控制儀表，承接家電器控制板及工業設備控制板的軟硬體設計製作公司憑借雄厚的技術力量，先進的生產設備，現代化管理模式作保證，生產出的產品質量可靠，性價比高公司擁有iso9001 ： 2000 cnab015 - q : 15 03q5439r10國際質量體系認證及cmc浙制02810232計量許可證，並嚴格按照質量體系生產及服務。
分享友人
分享到 Line

分享到臉書