檢驗臺 的英文怎麼說

中文拼音 [jiǎnyàntái]
檢驗臺 英文
checkout stand
  • 檢 : Ⅰ動詞1 （查） check up; inspect; examine 2 （約束; 檢點） restrain oneself; be careful in one s c...
  • 驗 : 動詞1. （察看; 查考） examine; check; test 2. （產生預期的效果） prove effective; produce the expected result
  • 臺 : 臺名詞（指臺州） short for taizhou （in zhejiang province）
  • 檢驗 : checkout; test; examine; inspect; verify; survey; check;checking;testing;[英國]jerque（指檢查船舶...
  1. Rules for the inspection of bench lathe for export

    出口臺式車床檢驗規程
  2. Verification regulation of electrodynamic vibration generator system for testing

    電動式振動試驗臺檢定規程
  3. The auxiliary motor test - bed is one of the devices which can examinant and tests the auxiliary motor ' s general performances such as d. c engine, a. c engine and phase converter

    機車輔機試驗臺便是負責對直流電機、交流電機、劈相機等機車輔機綜合性能的試驗檢修測試的設備之一。
  4. Verification regulation of slip plate type automobile side slip tester ' s aligner

    滑板式汽車側滑檢驗臺檢定儀試行
  5. Roller opposite forces type automobile brake tester

    滾筒反力式汽車制動檢驗臺
  6. Verification regulation of roller type speedometer tester

    滾筒式車速表檢驗臺檢定規程
  7. Verification regulation of roller opposite forces type brake tester

    滾筒反力式制動檢驗臺檢定規程
  8. Verification regulation of roller type speedometer tester ' s aligner

    滾筒式車速表檢驗臺校準儀試行
  9. Verification regulation of slipe plate type automobile side slipe tester

    滑板式汽車側滑檢驗臺檢定規程
  10. Verification regulation of roller opposite force type tester ' s aligner

    滾筒反力式制動檢驗臺檢定儀試行
  11. Responsible for filling in the inspection sheet, record and table of contents

    負責填好送檢單，檢驗記錄和檢驗臺帳。
  12. Wafer inspection station

    矽片檢驗臺
  13. Note 4 : the defect which cannot be according to the position of the light source and the visual angle is acceptance

    如果不能被確認的缺陷是依照檢驗臺光源位置和人的視角判定則則判定結果仍是可被接受的
  14. Meanwhile, mabs - 3000 not only is the combination of the three different systems : roller braking test, vehicle axle weight and speed meter test, but also has more functions, less pollution, lower cost and a more efficient composite system

    該多功能abs檢驗臺在檢測汽車防抱死制動系統（ abs ）性能的同時還把汽車的速度表校驗、軸重檢測、制動性能檢測三個分離的試驗臺的功能合為一體，是一種集成度高、多功能的復合試驗臺。
  15. Stability test - unladen : the unladen truck should not slide down or turn over for 30 seconds when it was on the platform, which is rising in any single side in 30 degrees

    空車傾斜度檢定：將車輛放置於檢查臺上，拉緊手剎車，將檢驗臺單邊升起30度角並靜止30秒鐘，車輛不得滑動或翻落。
  16. Braking test - unladen : the unladen truck is requested not to move when it was with tightened hand brake on the plateform, which is in 35 degrees upward rising with any single side for 30 seconds

    空車剎車檢定：將車輛放置於檢查臺上，拉緊手剎車，將檢驗臺單邊升起35度角並靜止30秒鐘，車輛不得滑動。
  17. This thesis developed a multi - function abs ( antilock braking system ) testing system that performs complete abs functional tests. it can replace current road testing methods, which are labor intensive, uneconomical and imprecise

    本文研發了可以代替目前正在使用的復雜、勞動強度大、經濟性差，且不嚴謹的路試方法的汽車防抱死制動系統（ abs ）性能的多功能檢驗臺計算機測控系統。
  18. Braking test - laden : the laden truck is requested not to move when it was with tightened hand brake on the plateform, which is in a slope of 35 degrees upward rising with any single side for 30 seconds

    負荷剎車檢定：將車輛放置於檢查臺上，拉緊手剎車，將檢驗臺單邊升起35度角並靜止30秒鐘，車輛不得滑動。
  19. Stability test - laden : the laden truck is requested not to move when it was with tightened hand brake on the plateform, which is in a slope of 30 degrees upward rising with any single side for 30 seconds

    負荷傾斜度檢定：將車輛放置於檢查臺上，拉緊手剎車，將檢驗臺單邊升起30度角並靜止30秒鐘，車輛不得滑動或翻落。
  20. Note 6 : the defect which cannot be confirmed according to the position of the light source and the visual angle is acceptance

    如果不能被確認的缺陷是依照檢驗臺光源位置和人的視角判定則判定結果仍是可被接受的
分享友人
分享到 Line

分享到臉書