正向偏置 的英文怎麼說

中文拼音 [zhēngxiàngpiānzhì]
正向偏置 英文
forward bias
  • : 正名詞(正月) the first month of the lunar year; the first moon
  • : Ⅰ形容詞1 (不正; 歪斜) inclined to one side; slanting; leaning 2 (只側重一面) partial; prejudi...
  • : 動詞1. (擱; 放) place; put; lay 2. (設立; 布置) set up; establish; arrange; fix up 3. (購置) buy; purchase
  • 正向 : [電學] forward direction正向傳導 forward conduction
  1. At this stage sea - level westerlies are strong and zonal in character and they lie poleward of their normal position

    在這一階段海平面上西風氣流很強且屬緯性的,它較常位極地(北半球上北或南半球南) 。
  2. Special features for copying inputting originals auto paper select, auto scaling select, vertical horizontal independent anemographic magnification, final scale adjustment, copy density adjustment 7 degrees, scan start position adjustment, and copy position adjustment, top bottom bottom margin setting, mirror image, trimming, negative positive inversion, header, reference input, rotate image, sharpness, contrast, additional copy, scanning speed change

    自動用紙選擇,自動倍率選擇,縱或橫獨立縮放,倍率微調,復印濃度調整,掃描起始位選擇,復印位選擇,前後端空白選擇,消除框線,鏡像,負片反轉,頁眉,參照列印,畫面轉,明兩度,對比度,追加復印,掃描速度選擇,電子分頁可選配
  3. Pay attention to passing over the departure point correctly. the aircraft is to the left. left correction. adjust the airspace location

    注意確通過起點。飛機左。左修。調整空域位
  4. When it arrives at the predetermined destination, the robot controls multi - putting - ball mechanisms and puts the game - ball into the drum simultaneously. on the other side, on the basis of the theory and experiment, we subjoin a line - tracking device in the robot system, ensuring the correct moving of the robot along the white index line on the venue, in order to increase the accuracy of orientation. during the automatic moving, the robot measures the position on the venue by itself, moreover, judging its direction and automatic cut - away with the single - chip microcomputer. this system has been finished the experiment, and find credibility, be in point

    同時,為了保證機器人確地沿著比賽場地上的指示線行走,提高機器人定位的準確性,還從理論和實驗的角度,在機器人上增加了一套尋線系統,以便機器人在其自動行走的過程中,隨時檢測自身的位狀態,判斷離方,進行自動的糾。這一套尋線系統已完成了實驗,且比較可靠、適用。
  5. The bias magnetic field of the bias coil driven by bias current and small signal test current, results in the induced signal of the control coil. the terminal voltage of the control coil is detected by the test circuit. then the signal containing the information of rotor displacement is obtained, from which we can get the dc voltage signal proportional to the rotor displacement through half - wave rectification circuit and low pass circuit. this dc signal is put into a pid controller to get the control signal of the rotor displacement

    測試電路線圈輸入電流和小信號測試電流,兩者產生的磁場在控制線圈產生感應信號,檢測電路檢測控制線圈端電壓並提取含有轉子位移信息的電壓信號,該信號經半波整流電路和低通濾波電路后得到與轉子位移成比例的直流信號,再由pid控制器轉換為轉子位移的控制信號,最後控制信號輸入功放電路產生控制電流,實現閉環控制。
  6. However, the msw - based mo devices haven ’ t still been applied extensively up to now because of low bragg diffraction efficiency. the generation and propagation characteristics of magnetostatic forward volume waves ( msfvws ) under nonuniform bias magnetic field and the bragg diffraction efficiency of gows with the msfvws are theoretically studied in this paper

    本論文主要從理論上研究不均勻場中靜磁體波( msfvw )的激發與傳播特性,以及不均勻磁場在提高靜磁波對導波光的bragg衍射效率方面所起的作用。
  7. These topologies of inverters are composed of two bi - boost dc / dc converters, they are symmetry. so whole circuit turn into four - quadrant converters, we can control every power mosfet on or off. then we can get sine wave with direct current polarization at the left, at the same we also can get sine wave with direct current polarization phase contrast 180 compared of the left at the right

    這類逆變器由左右二個雙boostdc / dc變換器構成,左右二邊是對稱的,所以整個電路構成了一個四象限變換器,我們可以恰當控制各功率管的開、關,使左邊的兩象限dc / dc變換器輸出一個帶直流弦波,使右邊的兩象限dc / dc變換器輸出一個相差180度帶同樣直流弦波形,這樣,負載zl上的電壓是左、右兩個dc / dc變換器電壓的差動輸出,好可以消掉直流,最終在負載r1上得到的就是弦波。
  8. Numerical studies suggest that long scale and slow - changed oscillations in the zonal wind stress rebuild by pop anal ysis make the intention of el nino / la nina events deeply. it also enlarges their range. but, positive and negative anomaly center is toward west than actual conditions

    數值試驗的結果表明,由pop重建的緯風應力中緩慢變化的大尺度振蕩成分加深了elnino lanina事件的強度,加大了它們的空間分佈范圍,但負距平中心的位比觀測風應力模擬的情況西。
  9. The landing test included overhead approaches as well as straight in approaches from normal, high, low, and laterally offset starts

    著陸測試包括:高空、低空、常狀態以及橫狀態的轉彎進場著陸和直接進場著陸。
  10. In this thesis two reverse - bias electrical stress methods were used to investigate the reliability of the devices. one is a typical of oc stress method with collector open and reverse - bias emitter - base junction. another one, a new technique, is fc stress method with forward - bias collector - base junction and reverse - bias emitter - base junction

    本論文採用兩種反電應力方法考察器件的可靠性,一種為傳統的oc應力(集電極開路,發射結反)方法,另一種為新的方法fc應力(集電結正向偏置,發射結反)方法。
  11. The electrical current can be supplied without any affection to the transistor ( for the use of el pixels and signal line ), which in the semiconductor equipment

    提供一種半導體裝,在負載( el像素及信號線)供給電流的晶體管中,可以不受差的影響供給確的電流。
  12. The game result is mainly determined by following factors, including the advantages of shareholders, their attitudes to risks and ability to bear risks, the concentration of internal shareholding structure, the restraint of property right, the external formal and informal institutional arrangements and the distribution conditions of enterprise financial governance

    其中不同的利益相關者擁有的優勢、利益相關者的風險好及承擔風險的能力、企業內部股權結構的集中程度及產權約束程度、企業外部式與非式制度安排和企業財務治理中財權配狀況是決定企業財務利益取這一博弈結果的主要因素。
  13. The usual method to broaden the bandwidth of the pin diode switch is combining the pin diodes with stub filters : when under reverse bias, the didoe is part of the filter, the transmission bandwidth is broadened ; when under forward bias, the structure of the filter is destroyed, signal is isolated

    Pin二極體開關展寬頻帶的方法一般是把pin二極體結合進短截線濾波器,使pin二極體在反時作為濾波器的組成部分,以展寬開關在傳輸狀態下的頻帶;當二極體正向偏置的時候,濾波器的結構被破壞,起到隔離的作用。
  14. Referring to three kinds of plan irregularity, structures individually with four kinds of irregularity as eccentricity in one direction, eccentricities in two directions, re - entrant corner irregularity and diaphragm discontinuity have been analyzed to investigate the relationship between torsion effects and parameters of above irregular structures. the parameters and the schemes for determining the scope of structures with different kind of irregularity considering seismic action in two directions simultaneously are proposed, some conclusions have been get as following : it is indicated by the analysis results that torsion effect has no dependency relation with eccentric torsional angel adopted in code for seismic design for buildings. it is suggested that the eccentric torsional angel should not be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricity in one direction due to irregular mass layout, the relative eccentricity can be take as the parameter of torsion effect of structures considering seismic action in two directions simultaneously ; for the structures with regular plan and elevation and with eccentricities in two directions due to irregular mass layout, the ratio of relative eccentricities in two directions and the angel of them can be take as the parameters of torsion effect of structures considering seismic action in two directions simultaneously ; it is indicated by the analysis results that the torsion effect has no dependency relation with re - entrant corner ratio adopted in code for seismic design for buildings as

    所取得的主要結論有:結構的扭轉效應與《抗震規范》所採用的扭轉不規則指標即心扭轉角之間的相關性較差,心扭轉角不宜作為判斷結構是否計及扭轉效應及需考慮雙水平地震作用的界定指標;對于樓層間均勻心的多層單心結構,建議採用相對心距作為需考慮雙水平地震作用的界定指標,並給出針對不同平面尺寸的界限相對心距;對于樓層間均勻心的多層雙心結構,建議採用兩個主軸方的相對心距及其夾角作為界定指標,結合單心結構的界定方案進行需考慮雙水平地震作用的結構范圍界定;凸凹不規則結構的扭轉效應與凸凹比例無相關關系, 《抗震規范》要求所有平面布不對稱的凸凹不規則結構計及扭轉效應的規定欠妥當,建議凸凹不規則界限值從30改為15 ,只要求分析採用空間模型比較合適; 《抗震規范》關于有效樓板寬度較小的結構需計及扭轉效應的規定很有必要,樓板局部不連續的結構需採用符合樓板實際剛度的計算模型予以分析,可使用相對心距(及其夾角)參照單(和雙心結構的界定方案,界定樓板局部不連續結構是否需要計入雙水平地震作用下的扭轉效應。
  15. In case of the longitudinal and lateral centerlines of the figure of the loaded car are asymmetric when freights are normally loaded, and considering the allowed shift in the longitudinal and lateral direction, the weight value and position of balances are deduced and an example is given

    摘要貨物常裝載時,外形輪廓關于負重車縱、橫中心線都不對稱的情況下,考慮到貨物的縱、橫移,對配重物的重量及位進行了推導,並舉了實例。
分享友人