正常放大率 的英文怎麼說

中文拼音 [zhēngchángfàng]
正常放大率 英文
normal magnification
  • : 正名詞(正月) the first month of the lunar year; the first moon
  • : releaseset freelet go
  • : 率名詞(比值) rate; ratio; proportion
  • 正常 : normal; regular; average
  • 放大 : amplify; magnify; boost; enlarge; blow up; gain; amplification; enhancement; multiplication; magn...
  1. Letter ratio : point biggest not lose the signal strength of the true voice with at the same time of the emanative noise strength opposite voice for of ratio, usually with meaning, letter comparing more bigly, turn on electricitying the road more small, quality more pure and unadulterated. want to choose the letter the ratio in the product of above. new of summer is with the series the product s letter ratio all in the above, have more professional of performance

    信噪比:指最不失真聲音的信號強度與同時發出的噪音強度之間的比,通以表示,信噪比越,功電路的相對噪聲就越小,音質就越純。要選信噪比在以上的產品。夏新和系列產品的信噪比都在以上,有更加專業的表現。
  2. In audio, a very low frequency oscillation often resulting from a positive feedback path in an amplifier system

    在音響設備中出現的振蕩頻極低的低頻振蕩,系統的反饋迴路引起。
  3. Eddy - current sensor conversion circuit consist amplification circuit, band - pass filter circuit, demodulation circuit, differentiation phase and data sampling circuit. these circuits are used to convert the test signal of eddy - current sensor to discrete signal tend to process. the microprocessor system that formed of dsp chip is used to data fitting of test system, data displaying and data communicating with personal computer, etc. the interference questions of hardware design and the measure of eliminating interference signal in the subject are introduced in the last of this chapter

    硬體電路的設計主要分三部分來實現:激勵源電路部分,由分頻電路和頻合成電路組成,產生頻穩定的激勵信號以確保檢測任務的進行;傳感器變換電路部分,由電路、濾波電路、檢波電路、鑒相電路和數據採集電路組成,主要將電渦流傳感器檢測線圈檢測到的信號變換成只含有被測信息的離散信號,易於后續電路處理;由dsp晶元構成的微處理系統,主要完成檢測系統的數據擬合、顯示及與主機通信等功能。
  4. Moreover, it has been pointed out that the hydrogen engine used in ? cylinder injection with high pressure can increase volumetric efficiency and compression ratio, - therefore, the performance indexes in this engine, such as output power, thermal efficiency, range of thickness of mixture with normal operation and nox emission, can be improved, and it is possible for the engine to realize rapid combustion of thin mixture, so abnormal combustion, such as backfire, pre ? ignition, can be controlled effectively

    指出了採用內部混合氣形成方式且高壓噴射的氫發動機,有利於提高充氣效和壓縮比,從而改善發動機的動力性和經濟性;有利於擴展發動機工作的濃度范圍;並且有利於實現稀薄混合氣快速燃燒,從而可以有效地抑制早燃、回火及爆燃等異燃燒和no _ x排量。試驗指出了發動機的點火時、噴射時及噴氫量對發動機的性能、異燃燒、 no _ x排量有很影響。
  5. In succession, the theory of chirped - pulse amplifier system is given in detail, firstly, studying from designing experimental light road and optical components to theoretical analysis, we par ' tly finished the system by ourselves. about ultr a - shoft pulse with a pulse - width of 9. 8f s and output power of 650mw and band - width of about l 20nm is output from oscillator source, secondiy, the stretching capacity of single grating four - pass stretcher is measured using abcd matrix combining collins function, and the effect of relativ e parameters to the streching ratio is also simulated. thirdly, a new type of disjunctional frequency moduiating function is provided according to the gain - narrowing and gain - saturation which are appeared in the co urse of amplification, under modulating the two effects are both controlled on some e xtent, fourthiy, the effect of ase that is often ignored by people is analyzed and the resolving methods are also given

    從光路、光學元件的自行設計到理論分析計算,初步建立了一臺實驗系統;採用abcd矩陣法結合collins公式計算了四通式單光柵展寬器的展寬量,並模擬了相關參數對展寬比的影響,對實驗具有指導意義;評價了再生器和多通器的優缺點,對過程中通忽略的自發輻射現象( ase )進行了分析,並提出了相應的解決方法;針對過程中出現的增益窄化和增益飽和現象,對輸入種子脈沖提出了一種新的分段頻調制函數,實現了對增益窄化效應和增益飽和效應的共同抑制;提出了系統的材料(包括介質和光路中的普通介質)是融合高階色散的來源。
  6. Results from hspice simulation and foundation show that the band - gap voltage reference of ic is 3. 126v, has a psrr of 65db, an accuracy of 23ppm / in [ 0, 70 ], and the band - pass filter has an gain of 73db, whose band - pass frequency is 0. 1hz ~ 10hz. comparator ’ s window is 700mv. time sequence and functions of digital circuits are normal

    Hspice和foundation軟體模擬的結果顯示,帶隙基準電壓源為3 . 126v ,電源電壓抑制比為65db ,溫度系數為23ppm / ;帶通濾波部分增益為73db ,帶通頻為0 . 1hz ~ 10hz ;雙限電壓比較器窗口為700mv ,功能良好,數字電路時序確,功能
  7. ( 2 ) because of t he variability of rock subjected to outside action, three new conceptions : postive damage basic damage and negative damage, are suggested, which can deal with the condition that rock density became large. ( 3 ) the present damage variables based on ct number mostly include ct average number of the rock without damage, which is difficult to measure, so a new damage variable, which includes the average ct number is proposed, on the other hand, strain equal theory is generalized because the one put foreword by lemaitre is not good enough to use. ( 4 ) a axial damage constitutive equation is proposed and testified. ( 5 ) with the circle times, the damage propagation laws of two different rocks, subjected to circle of freezing and thawing, are studied, and in the analysis process, traditional analysis method including average ct number and is used, some important conclusions are reached : inner damage of soft rock containing a large mount of apertures is largely propagating with the time increasement of circle, however, at the preliminary time, the hard rock containing a small mount of aperture is a little propagating, at late time, the influence become large ; ( 6 ) zone separation and statistics frequency put forward is used to analysized the three different damage propagation in the open circumstance, when they are subjected to the different circle times of freezing and thawing, in which the temperature variability is linear, different freezing rate, and different freezing temperature, and no water is supplied during the test

    在研究過程中本文主要做了以下工作: ( 1 )針對巖石損傷變化較小時,運用ct均值和方差分析不方便的缺陷,本文提出運用對ct數范圍劃分區段的方法,根據各區段統計頻的變化規律來分析損傷擴展狀況; ( 2 )針對巖石受到外部作用的多變性,本文提出了基準損傷,損傷,負損傷的概念,在某種程度上考慮了巖石受到外部作用時的壓密情況; ( 3 )現有的基於ct數的損傷變量多需要用到巖石基體的ct均值,這實際上是很難觀測到的,因此本文建議了一個可運用巖石初始狀態ct均值的損傷變量,由於現有的勒邁特教授應變等價原理使用上的不便,本文在其基礎上進行了推廣; ( 4 )建議了一個可用巖石初始狀態ct數和彈性模量的單軸損傷本構方程,並用算例進行了驗證; ( 5 )對兩種不同巖石在開環境下受到凍融循環作用且融化過程中補水時,內部損傷隨凍融循環次數增加的擴展規律進行了探討,主要運用了規的ct均值和ct方差的分析方法進行分析,試驗發現:對于孔隙和含水較高,密度和強度較低的軟弱巖石,凍融循環次數對損傷結構的擴展有明顯的影響,而對于孔隙和含水較低,密度和強度較高的硬巖,凍融循環次數對其損傷結構擴展初期由於含水低的原因,影響不是太,而後期由於水補給后,含水較高的原因,凍融影響逐漸增; ( 6 )運用了本文提出的區段劃分和統計頻的方法,深入地分析了開環境下的線性溫度變化的凍融循環次數,凍結溫度,凍結速度不同巖石作用時,其內部損傷隨凍融循環次數,凍結速度和凍結溫度變化的擴展規律,需要指出的是除了在試驗前飽水外,凍融過程中沒有補水。
  8. But the power electronic devices in pwm power amplifier are working in the on - off state, easily producing the over - voltage and over - current phenomena. under tht condition the power electronic devices are bearing higher dv / dt, di / dt and more energy losses, influencing itself capability and life - span. at the same time, the dv / dt, di / dt also cause the severe electromagnetism disturbances, such as the disturbances in the photoelectric theodolite will make the other systems working improperly

    然而在pwm功器的主迴路中電力電子器件工作在開關狀態,易產生過壓、過流現象,器件承受較高dv dt 、 di dt並產生較的損耗,影響器件本身的性能和壽命,同時dv dt 、 di dt還會產生嚴重的電磁干擾,如在光學測量設備中,這種干擾將會影響其它系統運行。
分享友人