正弦激波 的英文怎麼說

中文拼音 [zhēngxián]
正弦激波 英文
sinusoidal shock
  • : 正名詞(正月) the first month of the lunar year; the first moon
  • : Ⅰ動詞1 (水因受到阻礙或震蕩而向上涌) swash; surge; dash 2 (冷水突然刺激身體使得病) fall ill fr...
  • : Ⅰ名詞1 (波浪) wave 2 [物理學] (振動傳播的過程) wave 3 (意外變化) an unexpected turn of even...
  1. The experiment apparatus has been developed, which is based on software ( labview ) and hardware ( pci board ni 6024e ). the displacements and generative force at the tip of the ipmc actuators were measured with respect to the different voltages, frequents and various waveforms which include square, sinusoidal, and triangular wave

    實驗選取了不同電壓幅值,不同頻率的方、三角三種形作為電勵信號,利用高速攝像記錄ipmc的位移變形,並通過力傳感器實測了ipmc試樣末端的輸出力。
  2. Through the test of sine wave sweep, the character of response of aeolian sand due to motivation is gained

    利用掃頻試驗,得到風積沙對勵的響應特性。
  3. This paper include the following parts. firstly the sine exciting - voltage is guaranteed by direct digital synthesize technology ; secondly the digital output of cos ( 9 ) and sin ( 9 ) are generated by microcontroller ; thirdly the two voltage signals which are the product of the two former signals gained by the multiplying d / a converter, being filtered and amplified, have constant frequency, and one amplitude has sine function relationship of with the input angle, and the other amplitude has cosine function relationship of with the input angle ; finally the two signals are acquired and analyzed by relative instrument and software

    主要由以下幾部分組成:用數字頻率合成技術( dds )產生勵電壓信號u _ msin ( t ) ;用單片機產生幅度的數字量輸出sin ( )和cos ( ) ;用乘法型d a轉換器實現勵電壓和幅度的乘積,並通過濾器和功放后即得到頻率固定,幅值隨輸入角成變化的電壓信號;最後用數據採集卡採集輸出信號,顯示形並進行頻譜分析。
  4. Sine sweeping constant current exciting for geophone characteristic parameter measurement and identification

    地震檢器特性參數識別的一種新的掃頻恆流勵方法
  5. A study on the proposed scanlan linearity has discovered that if the self - excited loads and movement of the model and velocity constitute a linear relationship, and the model vibration accounts for a sine function of the frequency, the rate of the high - order harmonic waves should be quite small

    考查了scanlan的線性假定:如果自力與模型運動的位移、速度成線性關系,模型振動是某一頻率的函數,那麼相應的自力也應是這一頻率的函數,高次諧的分量應極小。
  6. Characteristic parameter measurement and identification of geophone by electric sine sweeping exciting

    掃頻電勵法測量與識別地震檢器特性參數
  7. The dynamic characteristics identification model of high - speed flexible rotor sys tem has been set up, the technology of steady state sine excitation and digital elliptic filter is used in order to identify the system parameter, and by constrasting the real measure to the theoretical computation, it proved that the method is accurater

    建立了高速柔性轉子系統特性參數識別模型,並採用穩態勵及數字橢圓濾器技術對系統參數進行識別,通過對實測和理論計算結果的比較,證明該方法有較高的精確性。
  8. Error evaluation formula of measuring harmonic distortional sine wave ' s amplitude with laser interferometer

    光干涉儀測量失真形位移誤差估計式
  9. The second part is a detector which is used to detect the distribution of voltage on the patient ' s brain surface from all different directions. the third is a mixed signal processor ( c8051f020 ) which is used to control the other parts of the system and display some necessary information and convert the voltage signals into digital signals, as well as transmit the acquired data to the computer. the fourth is computer with eit software which is used to analyze and process the received data and construct a picture for the brain edema and haematoma on screen

    32通道電阻抗斷層成像系統由4個部分組成:第一部分是恆流源,用來產生注入大腦的勵電流;第二部分是電位信號的提取與轉換,用來提取當勵電流注入時,在大腦表面形成的電位分佈信號;第三部分是數據採集與控制系統,用來控制勵電流的頻率,注入方向,注入強度,控制採集大腦表面的電位分佈信號,並且將這些採集的電位分佈數據傳到pc機;第四部分是計算機eit成像軟體,用來接收下位機的電位分佈數據,並且對這些數據進行分析計算,重建電阻抗圖像。
  10. The main original work includes : 1. the interaction between an integral pile and a uniform visco - elastic soil layer with viscous damping or hysteretic damping is theoretically studied, and the pile response to a harmonic load is obtained in a closed form and used to define complex stiffness at the pile head. semi - analytical solution of the velocity response in time domain subjected to a semi - sine wave exciting force is also given

    主要工作包括: 1 、在考慮樁周土三維動條件下,對滯回阻尼、粘性阻尼單層均質土中樁土縱向耦合振動問題進行了解析研究,分別得到樁頂位移、速度頻域響應以及復剛度的嚴格解析表達,以及半脈沖振力作用下樁頂時域響應半解析解。
  11. In order to measure magnetization characteristic with high accuracy we must keep the wave of magnetic induction is sine, so we must control the excitating voltage

    為了能夠精確的測量磁化特性必須保證磁感應強度形為,因此必須對磁電壓形進行控制。
  12. For the first time, three types of sine structures for wavelength linear scale in grating spectrum instruments are described systematically. the tuning structures for wavelength linear scale in both littrow and littman set - up external - cavity laser diodes are designed

    ( 3 )首次系統地分析了光柵光譜儀器中的三類機構,分別設計了可實現長線性標度的littrow和littman外腔半導體光器調諧機構。
  13. Passive suspension, pid control semi - active suspension and neural network control semi - active suspension are researched by simulation. white noise, sine wave and sawtooth wave are used for excitation. the root mean square value of vehicle body acceleration, suspension displacement and vehicle wheel load are analyzed

    在模擬研究中,路面勵取為白噪聲、和鋸齒,懸架類型採用被動懸架、 pid控制半主動懸架、神經網路控制半主動懸架三種。
  14. This paper gave a general method to solve the accelerate damage boundary ( adb ) of the packaging system by finding the adb of two representative packaging systems under type wave. as for the displacement damage boundary ( ddb ) of the packaging system, this paper fist defined the dda of the bilinear packaging system under half - sine wave and other kind packaging systems by analysis. moreover, the course of solve this kind of problem by analysis was given

    論文研究了兩種典型脈沖勵下的非線性包裝系統的加速度損壞邊界及其影響因素,總結了求解加速度損壞邊界問題的一般思路;針對包裝系統的位移損壞邊界,文中首次運用解析法確定了半勵下雙線性包裝系統的位移損壞邊界,歸納了用解析法解決此類問題的一般過程,同時,本文還對此給出了應用更為廣泛的一種數值方法。
  15. In the area of elasto - plastic dynamic analysis of frame with friction energy dissipation, the design - oriented nonlinear seismic response time history analysis method for frame with friction energy dissipation has been set up. and the corresponding program idaff is developed using visual c + + language ; the analytic solution of a single - damped - story braced frame with friction energy dissipation under the sine wave excitation has been give ; besides these, a vibration reduction analysis of multi - story frame with friction energy dissipation has been given in the paper and some useful conclusions have been drawn

    在摩擦耗能框架結構彈塑性動力分析方面,本文建立了面向設計的摩擦耗能框架結構非線性地震反應時程分析方法,並利用vc + +編制了相應的程序idaff ;給出了帶有摩擦耗能器的有阻尼單層框架在勵下反應的解析解;同時本文從多自山度的角度出發對摩擦耗能框架的影響因素進行分析,得出相關的結論。
  16. Faced with the fact that there is a great deal of noise in detecting signal when using small amplitude lasting sine current on field, a developed lease minimum squares method is adopted, which makes the parameters of sine sequence with known frequency picked up on the real time. at the same time, original signal is processed by using wavelet theory, gaining true information which responses to the coating quality

    在小幅度恆電流勵檢測中,針對現場檢測信號含有大量噪聲這樣的情況,採用改進的最小二乘法,實現頻率已知的序列參數的實時提取;同時利用小理論對原始信號進行處理,得到反映塗層性能的真實信息。
  17. Experimental result shows that electrical - resistance strain gages can respond well in the frequency range of artificial excitation by impact hammer, at the same time, the experimental scheme brought forward in this paper makes the experimental setting simple and can be manipulated easily as well as can display the excitation and response expediently and synchronously on digital oscillograph. the impact hammer can implement half - sine load

    結果表明,電阻應變片在力錘勵頻段內可以有很好的響應,從而使實驗裝置簡單,方便操作和使用;同時實驗結果顯示出本文採用的實驗方案可以方便地將勵和響應同步地顯示在示器上,並且利用力錘可以實現規則的半加載。
  18. Then novel circuit structure and circuit topologies family of current source ac / ac converters with high frequency ac link, based on flyback converter, are proposed. the circuit structure which can transfer one unregulated sinusoidal voltage with high thd into another regulated constant frequency sinusoidal voltage with low thd, is constituted of input cycloconverter, high frequency storage transformer, output cycloconverter, input and output filter. the circuit topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits

    本文提出了基於反flyback變換器的電流源高頻交流環節ac ac變換器電路結構及其拓撲族,該電路結構由輸入周變換器、高頻儲能式變壓器、輸出周變換器以及輸入、輸出濾器構成,能夠將一種不穩定劣質的交流電變換成另一種同頻率穩定的優質交流電壓;該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式等四種電路。
  19. Pulse signal is connected by the customer. signal can be sine wave or square wave. modulation frequency can be to 1mhz few model can be to 10mhz ; inner modulation type no need signal from out side

    外調制式光器留有專用的信號介面,由用戶接入脈沖信號,信號可以是,也可以是方,調制頻率可到1mhz個別型號調制頻率可到10mhz 。
  20. After comparing three form ( rectangle, saw and sine wave ) of excitation force, the conclusion is drawed that the sine wave is much better than the other two waveforms. finally, multi - seedling virtual prototype is studied

    另外,對比分析三種形(矩形及鋸齒振力對振動系統的影響,發現採用振力對振動系統沖擊較小,應優先考慮使用。
分享友人