氣力分離器 的英文怎麼說

中文拼音 [fēn]
氣力分離器 英文
air separator
  • : Ⅰ名詞1 (氣體) gas 2 (空氣) air 3 (氣息) breath 4 (自然界冷熱陰晴等現象) weather 5 (氣味...
  • : Ⅰ名1 (力量; 能力) power; strength; ability; capacity 2 [物理學] (改變物體運動狀態的作用) forc...
  • : 分Ⅰ名詞1. (成分) component 2. (職責和權利的限度) what is within one's duty or rights Ⅱ同 「份」Ⅲ動詞[書面語] (料想) judge
  • : Ⅰ動詞1 (離開) leave; part from; be away from; separate 2 (背離) go against 3 (缺少) dispens...
  • : 名詞1. (器具) implement; utensil; ware 2. (器官) organ 3. (度量; 才能) capacity; talent 4. (姓氏) a surname
  • 氣力 : effort; energy; physical strength
  1. The influence of inflow velocity, the baffle body height and the clapboard position on the flow velocity, flow equilibrium between the two sides of the clapboard, particle distribution, rich / lean concentration ratio and flow resistance characteristic are studied numerically

    文章研究了來流速度,撞擊塊高度、隔板位置等因素對相速度場、隔板兩側配風均勻性、顆粒濃度、濃淡比和燃燒內阻特性的影響。
  2. General speaking, if it is the drying of the electuary and granular materials, which have relative large proportion, only the cyclone separator is needed

    一般來說,比重較大的物料只需選擇旋風。比重較輕的物料需配套布袋除塵,並備有送料裝置供選擇。
  3. Introduction to general ideas in air pollution control, air pollution effects, design of wall collection devices ( gravity settlers, centrifugal separators, electrostatic precipitators ), design of dividing collection devices ( surface filters, depth filters, scrubbers for particulate control ), design of controlling by concentration and recovery ( condensation, adsorption, absorption ), design of controlling by oxidation ( combustion, biological oxidation, biofiltration ) and the choosing of a control technology

    本課程介紹空污染防制概念,空污染之影響,壁式集塵設備之設計(重沉降室、、靜電集塵) ,隔集塵設備之設計(表面過濾、深層過濾、洗滌) ,以濃縮回收之控制設計(冷凝、吸附、吸收) ,以氧化之控制設計(燃燒、生物氧化、生物過濾) ,以及控制技術之選擇。
  4. Excessive pressure may develop in the tank because of plugged or pinched lines or from a plugged liquid vapor separator or charcoal canister.

    由於管路堵塞,壓癟或油和活性炭罐被堵塞,油箱里會產生過高的壓
  5. Equipped with electronic controller fini tronic and preset for remote control for two or more compressors. it offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging lashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure end indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制,有工作壓和油罐內壓指示,過濾阻塞報警,電機溫控,螺桿總成溫控,壓端空溫度指示,電機轉向檢查,維護周期油,油過濾,空過濾過濾,總運行時間和負載運行時間,記錄上五個報警故障等。
  6. It offers working pressure and oil mist separator tank inner pressure indication, separator filter clogging flashing alarm before overpressure e - stop, electric motor temperature control, maximum screw assembly temperature control, air temperature on pressure and indication, electric motor direction of rotation check, time to scheduled maintenance term, total operating hours and operating hours under load, alarm log of last five failure events

    並預設為丙臺以上空壓機聯機遠程控制可檢測包括操作壓罐內壓,電機溫度和轉向,螺桿總成溫度過濾堵塞報警等參數,並可顯示總運行時間和負載運行時間。
  7. Numerical simulation of reynolds stresses of gas - solid two - phase flows in an inertial separator

    慣性固兩相流雷諾應數值模擬
  8. Separation characteristics experimental study of gas - injected hydrocyclone

    攜式水旋流性能試驗
  9. In this paper, the cause of severe wear of a301 mechanical seal at the atmosphere end used in powered separator for polypropylene project was analyzed. then, the reform method to solve the problem was presented

    對聚丙烯裝置動a301機械密封大端嚴重磨損的原因進行了析,並對機封進行了改造,使問題得到解決。
  10. Air filtration portfolio, air filters, valve, oil mist machine, filter valve, oil mist separator, micro - mist separator, stability activated solenoid valve, pressure gauge, micro - valve and vacuum valves, links the release of the closure - pressure valves, and pipe connection, a one - way valve, t - shelves, shelves, brackets, diaphragm - type flow switches, blades type flow switches, further growth actuator, the valve lock, precision valve, pressure switches, mechanical pressure switches, pneumatic control ratio positioning devices, and electric - gas ratio positioning devices, and telecommunications - pressure converters, electro - pneumatic proportional valve, filter valve, shuttle valve, gas - electric relay and gas indicator, delay pneumatic valve and cylinder fcl, plumbing fcl, mufflers and exhaust cleaner, the excess flow valve with silencer, a one - way valve, rapid valve, rapid joints, rapid valve with fcl, rapid joint sub - cluster gas, micro joints, gas pipes, pipe from the devices, and helical coils, pipes, channels, scissors, multiple fastener, high - speed rotary joint, 10000 threaded joints, and insert the tube joints, rotary joints began, 68. 25 rapid joints and hoses, hose fittings and rapid non - electrostatic

    過濾組合空過濾減壓閥油霧過濾減壓閥油霧微霧穩定啟動電磁閥壓表微型減壓閥減壓閥三通釋放式截流閥壓開關管接頭單向閥t型隔板隔板托架膜片型流量開關漿葉型流量開關增速繼動鎖定閥精密減壓閥壓開關機械式壓開關控比例定位電-比例定位電訊號-壓轉換電-比例閥過濾減壓閥梭動閥-電繼電源指示動延時閥缸限流管道限流消聲潔凈限流閥帶消聲單向止回閥快速排閥快速接頭快速排閥帶限流快速接頭集束微型接頭喉管喉管脫螺旋管排管管道剪刀多管扣件高速旋轉接頭萬用螺紋接頭插入式管接頭旋式緊鎖接頭難燃性快速接頭和軟管不帶靜電快速接頭和軟管
  11. The method of optimization is the complex method. the objective function is the opration expenses of the hydrogen system. there were six decisive variables : the pressure and temperature of the high - pressure separator of vrds, gas ration to the prism unit from vrds unit and ssot unit, the pressure of the high - pressure separator of ssot and the entrance pressure of the cycle hydrogen compressor

    優化問題以氫系統的運行費用函數作為目標函數,選擇了6個決策變量,別為: vrds高壓、溫度、 vrds和ssot裝置排入prism的氫量、 ssot高壓和循環氫壓縮機入口壓
  12. Selective absorption of electromagnetic wave. adw employing gases which do n ' t absorb the laser energy can form a gas urtain " whose pressure of the two sides is equal to the low pressure of laser cavity and the ambient circumstance pressure respectively so it can isolate the higher pressure ambient air from entrancing into the laser cavity and maintain the hel ' s running normally

    動窗口利用對激光輸出波長沒有任何吸收作用的特殊體作為窗口工作介質,並根據體動學部相關原理,能生成一個具有與激光腔低壓和環境大高壓相匹配的壓梯度、並把激光低壓工作介質和外界大相隔的「幕」 ,從而保證高能激光的正常工作。
  13. In modern aircraft design, there is an urgent requirement for accurate, efficient and easy - to - use numerical analysis tools. for this purpose, this thesis introduces recent progress in the generation and application of cartesian grid with tree data structure and adaptive refinement. coupled with hybrid grid techniques, euler and navier - stokes equations are solved

    本文針對現代飛行設計中對實用、高效、準確的析工具的迫切需求,基於叉樹數據結構,發展了一種自適應直角切割網格方法,採用混合網格技術,實現了對流場euler和navier - stokes方程的計算求解,進一步完成了復雜增升裝置繞流和外掛物投放非定常流場的數值模擬。
  14. Hydraulic power. gas - loaded accumulators with separator. selection of preferred hydraulic ports

    液壓動.帶的裝的蓄能.優先使用液壓埠的選擇
  15. In the modeling of dynamics of the vehicle, the forces and moments arise from both aerodynamic and propulsive sources, which are for these configurations hard to separate

    模型建立中,由於由推進系統以及空產生的矩很難,因此本文只是提出一個設計初級階段考慮飛行特性的解析表達式。
  16. Hydraulic fluid power - gas - loaded accumulators with separator - selection of preferred hydraulic ports

    液壓流體動.帶液蓄壓.優選液壓埠的選擇
  17. A mathematical model of flows in the substrate was established using the equivalent continuum approach, and multi - dimensional numerical simulation of the steady flows in the catalytic converters was performed. simulation results show that the separation and vortex, which cause the pressure loss and the velocity non - uniformity at the front of the first substrate, are generated near the wall of the conical pipe. in addition, the larger the inlet cones angle the more the pressure loss and maldistribution in converters, however, when the angle enlarges enough the pressure loss would be decrease

    結果顯示流在擴張圓錐管壁附近出現產生較強的擾動,造成局部流動損失和載體前流速度沿徑向佈不均勻;入口擴張管結構對催化的流動特性有很大影響,但並非擴張角越大,催化流速武漢理工大學碩士學位論文佈的不均勻性和壓損失也增大,而是存在著一個最佳角度,但當擴張角增大到一定程度以後,擴張角對流速佈和壓損失的影響變小。
  18. The body, also the ego, the different separate perceptual senses, the various yet separated vital forces, and the fifth being the ultimate consciousness as the indwelling monitor

    它們是:生命體,自我,各自不同的感知官,各自的生命量() ,還有作為內在的監控者的根本意識。
  19. According to the theory of boundary layer and the important of boundary - layer separation point detection of delta wing, the measuring principle and structure scheme of various system alternatives based on mems technology have been discussed, selecting the prototype of better workability. base on the master piece model of micro shear stress sensor

    首先,結合空學的邊界層原理,針對三角翼邊界層點檢測在實現主動動控制方面的重要性,討論了光學式、電容式和熱敏式微型剪應傳感的測量原理和結構方案,選取適合加工條件的微型剪應傳感樣件。
  20. In this thesis, the strongly swirling turbulent flow in gas - solid cyclone separators is simulated using the standard k - ? rng k - and reynolds stress equation models ( dsm ). it is demonstrated via comparison between the simulation results with experimental data that the dsm model is superior to the other models

    針對內部的這種復雜-固兩相湍流運動,本文採用了標準k -模型、 rngk -模型和雷諾應模型( ssg ) ,利用貼體網格技術,模擬計算了內部流動,並將計算結果與實驗數據進行析、比較。
分享友人