氣壓測試 的英文怎麼說

中文拼音 [qìyācèshì]
氣壓測試 英文
pneumatic test
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 壓 : 壓構詞成分。
  • 測 : 動詞1. （測量） survey; fathom; measure 2. （測度; 推測） conjecture; infer
  • 試 : 名詞（古代占卜用的器具） astrolabe
  • 氣壓 : [氣象學] pressure; atmospheric pressure; barometric pressure; gas pressure; air pressure
  • 測試 : test; testing; checkout; measurement
  1. This paper discusses the designing and making of the dynamic testing systems of engine electronic control system. base on the construction and operation principle of santana 2000gsi m3. 8. 2 engine electronic control systems, design and manufacture led circuit of dynamic testing and fault imitating electronic control unit. on the inspect board, design and equip with motronic 3. 8. 2 ecu i / o measuring joints, design and set up obd - ii diagnostic communication link, design and install fuel pressure inspecting meter. depend on the obd - ii diagnostic communication link and ecu i / o measuring joints, this dynamic testing system can inspect engine electronic fuel injection system, distributorless ignition system, idle speed control system and evaporative emission control system, and can inspect m3. 8. 2 sensors, ecu and actuators, and can interrogate fault memory and erase fault memory ; and can analyse data stream ; and can carry out fault imitating. besides, this paper analyses sensors and actuators typical fault w aves

    2電控單元電路連接器設計製成輸入輸出電子控制檢測端子，並在檢測面板上布置了obd -診斷插座和燃油壓力表。使該動態測試系統能實現對電噴發動機的燃油系統、直接點火系統、怠速控制系統和燃油蒸氣排放控制系統的動態檢測；並通過obd -診斷座、 ecu輸入輸出檢測端子和故障模擬處理單元實現對電噴發動機電控系統各傳感器、電控單元、執行器進行故障碼讀取與清除；動態數據讀取和波形測試和故障模擬等。此外，本論文還分析了傳感器和執行器典型故障波形。
  2. It's a bulb pressure tester for detecting battery leaks.

    這是檢測電瓶漏氣用的膠球壓力試驗器。
  3. Long - hole and geometrical proportion type of mixing unit is finally adapted in lpg supply system, and power and torque output of lpg engine are improved by increasing compression ratio, and ignition characteristic is tried to adjusted to satisfy engine performance. meantime emission performance and noise level of lpg engine at full - throttle and other various part - throttle operations are tested and compared with former gasoline engine. ( 3 ) it is verified by engine dyno tests that lpg engine has better synthesized performance at aspects of power and torque, fuel economy, as well as emission than former gasoline engine

    選擇了等比例長孔式混合器控制空燃比；通過提高壓縮比來彌補動力性的損失；以動力性為主控目標，對最大功率點、最大扭矩點、中等轉速、最低轉速點所對應的發動機轉速做了點火特性的調節；通過空燃比的合理控制，直接改善發動機的動力性、經濟和排放指標；作為對缸內燃燒過程的理論分析，進行了燃燒特性的實驗測試；對原汽油機和新開發的液化石油氣發動機，進行了外特性和部分負荷特性以及怠速的排放及噪聲對比性測試。
  4. Abnormal well head pressure of high productivity gas wells in luojiazhai

    羅家寨高產能氣井測試井口壓力異常分析
  5. The result is that this gas pool has simple structure, only forms a little nose - like structure at the district of fenghuangshan ; this pool belongs to delta front sub - facies sedimentary model, the underwater distributary channel and mouth bar is the better sedimentary microfacies ; the physical property of the reservoir is poor, the type of pore of the reservoir rock mostly are intergranular pore, intergranular solution hole and little are intercrystalline micropore ; the influential factors of pore structure and physical property are lithofacies, lithologic character and diagenesis ; the off - take potentia of all the testing well are deadly shortness, the wells have the worth of industrial recovery only under the condition of going through sand fracturing, and in the early of binging into production, the oil and sheath pressure drop rapidly, the production of the well drop rapidly

    研究認為該氣藏構造簡單，只在鳳凰山形成了一個小型的鼻狀構造；屬於三角洲前緣亞相沉積模式，水下分流河道和河口壩是有利的沉積微相；儲層物性差，儲層巖石的孔隙類型主要有粒間孔、粒間（內）溶孔及少量晶間微孔；影響蓬萊鎮組氣藏儲層孔隙結構及儲集性的因素有巖相、巖性條件及成巖作用；所有測試井自然產能都極低，必須經加砂壓裂后才有工業開采價值，且投產初期，油套壓下降較快，氣井產量下降迅速。
  6. Methods of testing plastics. other properties. determination of the gas transmission rate of films and thin sheets under atmospheric pressure manometric method

    塑料的試驗方法.第8部分:其他性能.試驗方法821a :在大氣壓力條件下薄片和薄膜透氣率的測定
  7. Measurement of airborne noise from hydraulic fluid power systems and components - method of test for pumps using a parallelepiped microphone array

    液壓動力系統和部件氣動噪聲測量.第6部分:平行六面體傳聲器陣列測試液壓泵噪聲
  8. Performance test code - compressors and exhausters

    性能測試規范.壓縮機及排氣機
  9. Performance test code on compressors and exhausters

    壓縮機和排氣器的性能測試規范
  10. Test method for performance of building airtightness by fan pressurization

    用風扇加壓法測試建築物氣密性能的試驗方法
  11. So although there are better oiliness in peng ii, peng iii, peng iv gas pool and there are industrial off - take potentia after compressive fracture, this gas pool belongs to lower permeability, convention sand - density sand, little to middle throat - punctate pore, sealing elasticity gas drive, partly poor water drive, normal pressure, net gas, lithologic trap to nose - like structure - lithology compounding trap model

    所以，雖然新都氣田蓬萊鎮組蓬二、蓬三、蓬四段有良好的含油氣性，且經過測試均獲得工業產能。但總體上該氣藏隸屬低滲常規砂巖?緻密砂巖，小及中喉?細孔孔隙型，定容封閉彈性氣驅，部分弱水驅，常壓，干氣，巖性圈閉及鼻狀構造?巖性復合型圈閉氣藏類型。
  12. Aerostatic bearings have been applied widely on the ultra - precision in the aviation, aerospace and the main axes and the slide of the precision measuring instrument and inertial measuring apparatus because of high rotation accuracy, calm operation, low friction and long life - span etc. they can also be used in fields range from both high and low temperature to both high and low velocity, sometime even to environment full of radioelement

    氣體靜壓軸承回轉精度高、運轉平穩、摩擦小、使用壽命長，可以在極高和極低的溫度、超低到超高的速度下，以及輻射環境中工作，因此在航空、航天領域以及精密測量和慣性測試設備上得到廣泛應用。
  13. Energy consume, electric strength, insulation resistance, ground conductivity, leakage current, microwave leakage, power input, normal temperature, humidity treatment, glow wire, horizontal flame, vertical flame, tracking, ball pressure, rainproof, water splash, dustproof, salt fog, endurance, motor load test, cord flexing, cord pulling, pull & torque test, lamp replacement, construction check etc

    能耗、電氣強度、絕緣電阻、接地連續性、泄漏電流、微波泄漏、功率、溫升、濕熱試驗、灼熱絲、水平燃燒、垂直燃燒、漏電起痕、球壓試驗、防雨淋、防濺水、粉塵、鹽霧、耐久性（壽命）試驗、電機負載試驗、電源線彎折、電源線提拉、拉扭力測試、燈頭互換性、安全結構檢查等。
  14. The primary theory of absorption and desorption was also explained. the effects of primary process parameters, such as hydrogen pressure, time and temperature on the magnetic properties of ndfeb have been researched. the structure and magnetic properties have been analyzed by means of optical metallographic microscopy, scanning electronic microscopy, x - ray diffraction analysis, infrared oxygen detector and magnetic properties measurement

    本文設計了燒結ndfeb的氫爆制粉設備，對設備調試以及使用過程中出現的主要問題進行了簡要的說明，提出了一系列解決方法；闡述了吸氫、脫氫的基本原理；研究了氫氣壓力、通氫時間、氫爆溫度等基本工藝參數對磁性能的影響；利用金相顯微鏡和掃描電子顯微鏡， x射線衍射分析，紅外線測氧分析及綜合磁性測量儀等手段分析了材料的組織結構和磁性能。
  15. General technical specifications for high voltage test equipments part 6 : sf 6 gas leak detector

    高電壓測試設備通用技術條件.第6部分:六氟化硫氣體檢漏儀
  16. Aim at high pressure high temperature well practice engineering question in field development engineering, especially cnpc southwest oil gas branch gas recovery academy project ' s concretion demand, based upon in existence measuring and testing techniques foundation, the dissertation produce a sort of new optical fiber downhole high pressure high temperature test system, and finish downhole fibre optic pressure sensor ' s design

    本文針對油氣田開發工程中高溫高壓井的實際工程問題，特別是cnpc西南油氣田分公司采氣工程研究院科研項目的具體要求，在分析研究現代測試技術基礎上，提出一種新型的光纖式井下高溫高壓測試系統，並主要完成了井下光纖壓力傳感器的設計。
  17. Department perfect test, which can be made into various mechanical properties such as : tension tests, strength tests slide, terminal testing ; electrical performance test items include : insulation resistance testing, contact resistance testing, testing withstand voltage, high and low test, solderability test, durability testing, vibration - resistant testing, life test

    完善之測試部，能作各項機械性能測試如:拉力測試、插撥力測試、端子強度測試；電氣性能測試項目計有:絕緣電阻測試、接觸電阻測試、耐電壓測試、高低測試、可焊性測試、耐久性測試、耐振測試、壽命測試等
  18. To ascertain how to produce differential pressure reasonably during the course of high temperature and pressure gas well testing, we must consider synthetically the following situations : both liquid in well bore and solid phase particles of mud in strata can be carried out through airflow ; we must avoid sand production out of borehole walls and make the selected differential pressure meet the demands of the testing instrument capability ; the calculation of differential pressure when no sand comes out of strata covers the calculation of strength of rock of borehole walls and airflow velocity, etc

    摘要高溫高壓氣井測試中合理生產壓差的確定需要綜合考慮使氣流能夠在井筒中攜液、返排侵入地層中的泥漿固相顆粒、避免井壁出砂、滿足測試工具性能要求等；地層不出砂壓差計算還涉及到井壁巖石的強度計算、氣流流速計算等。
  19. The technique specification for high pressure well testing

    高壓油氣井測試工藝技術規程
  20. The design project base upon the dissertation should offering a sort of significant means for the future to special high pressure high temperature oil and gas well testing

    本論文所完成的設計將對今後特殊高溫高壓油氣井測試提供一種有意義的方法。
分享友人
分享到 Line

分享到臉書