氣泡壓力法 的英文怎麼說

中文拼音 [qìpāoyālìfǎ]
氣泡壓力法 英文
bu le pre ure method
  • 氣 : Ⅰ名詞1 （氣體） gas 2 （空氣） air 3 （氣息） breath 4 （自然界冷熱陰晴等現象） weather 5 （氣味...
  • 泡 : 泡Ⅰ名詞1 （氣泡） bubble 2 （像泡一樣的東西） sth shaped like a bubble Ⅱ動詞1 （較長時間地放在液...
  • 壓 : 壓構詞成分。
  • 力 : Ⅰ名1 （力量; 能力） power; strength; ability; capacity 2 [物理學] （改變物體運動狀態的作用） forc...
  • 法 : Ⅰ名詞1 （由國家制定或認可的行為規則的總稱） law 2 （方法; 方式） way; method; mode; means 3 （標...
  • 氣泡 : air bubble; bubble; bubble cell; pin hole
  1. It is studied that the formation mechanism of taylor bubble and its control method in gas - liquid two - phase flow, which affects the pressure balance and mechanical driving efficiency in the flow of petroleum engineering. experiments show that the formation of taylor bubble in gas - liquid two - phase flow is due to the intensive congregation and amalgamation of small bubbles driven by void fraction waves and that the highly turbulent flow is able to restrain this formation. thus, the flow regime transition may be checked by increasing the flow turbulence and controlling the disturbed frequency

    對大管徑氣-液兩相流動中嚴重影響壓力平衡與機械驅動效率的段塞流生成機制和控制方法進行了研究，實驗證明段塞流的形成是由於空隙率波的大幅度增長使氣泡高度集中，並形成聚並所致。強湍流運動可以抑制taylor泡的形成。因此，通過強化湍流或控制擾動頻率可以對氣泡聚並起明顯的抑制作用。
  2. The result indicates that from the north to the south, from the east to the west, the seal ability of four caprocks is better and better, the good seal areas of caprock distributes in heiyupao sag and its south. based on the research of the seal mechanism of the faults, this paper researched the vertical seal of t1 and t2 fautlts in binbei region by means of the mudstone content in fault zone and the pressure of fault plane. the result indicates the good seal areas of t2 fault for gas and oil distribute in daqing - anda and their north of binbei region, the good seal areas of t | fault for gas and oil distribute in wuyuer and heiyupao sags of binbei region

    本文通過濱北地區青山口組和嫩一、二段蓋層宏觀發育和微觀封閉能力分析，利用模糊數學綜合評價方法對濱北地區青山口組和嫩一、二段泥巖蓋層的封蓋能力進行了評價，結果表明這四套蓋層封蓋能力從北向南，從東向西逐漸變好。好蓋層封蓋能力區主要分佈於黑魚泡凹陷及其以南地區。在斷層封閉機理研究的基礎上，利用斷層面壓力和斷面填充泥質含量研究了濱北地區t _ 2層和t _ 1層斷層封閉性，結果表明濱北地區t _ 2斷層好的封油氣區位於大慶?安達以北局部地區， t _ 1層斷層好的封油氣區位於烏裕爾、黑魚泡凹陷處。
  3. Dissolved air floatation is that air is dissolved under pressure is the liquid which is then released to atmospheric pressure in tube. as the microscopic air bubbles come out of solution in cell, they attach to the suspended solids in the surface in liquid, causing them to floatation th the surface, then solids are separated from liquid

    氣浮就是設法在待處理液體中通入或產生大量密集的帶有壓力的微細氣泡，在管道以常壓下釋放，使其在池內與雜質，絮粒互相粘附形成整體浮體，從而依靠浮力使其上浮至液面，從完成固液分離的方法
  4. Bubble pressure method

    氣泡壓力法
  5. Pressure fluctuation time series in gas - solid fluidized beds contain many dynamic information, such as particle characteristics, operating conditions, bubble behavior. in the paper, nonlinear analysis is adopted and implemented so as to understand the fluidization from a new viewpoint in depth

    氣固流化床壓力脈動時間序列包含了床層運動的許多動態行為信息，包括顆粒特性、操作條件，氣泡行為等，文中應用多種非線性方法來對其進行研究，以期能從新的角度來更深入地認識流態化規律。
  6. The foaming dth hammer is a new technology method and used as a drilling technique to deal with the special nature geography and complicate strata conditions which transforms the working medium of common dth hammer from the one fluid ( air ) to two - phase fluid compression foam, and uses the foam as motive medium to work

    摘要泡沫潛孔錘是將普通潛孔錘的工作介質從單一流體（空氣）變成兩相流體的壓縮泡沫，並以泡沫作為動力介質驅動潛孔錘工作的新型工藝方法。
  7. In this paper, according to the fluid dynamic theory, mathematical model of the pressure transients accompanying the growing and collapsing of gas bubbles and cavitation in low pressure hydraulic pipelines is given, based on the continuity equation and motion equation. the mathematical models of friction item, the growing and collapsing of gas bubbles and cavitation are also introduced

    本文通過流體力學分析方法，在連續性方程和運動方程基礎上，建立了低壓液壓管路中伴隨氣泡和氣穴產生的瞬態壓力脈動數學模型，給出了動態摩擦力數學模型及氣泡和氣穴產生及破滅數學模型。
  8. The finite difference method and matlab / simulink are used to simulate the pressure transients accompanying the growing and collapsing of gas bubbles and cavitation in low pressure hydraulic pipelines. a method using selector block in matlab simulink to solve the equations in spatial dimension is developed. the pressure transients under different conditions such as different initial flow rate, different viscosity and different initial gas bubble volume are simulated

    採用有限差分及matlab / simulink模擬方法，提出了採用simulink中selector模塊求解空間域上積分的方法，對低壓液壓管路有氣泡和氣穴產生的瞬態壓力脈動過程進行了時間域和空間域上的求解，對不同起始流量、不同液壓油粘度和不同初始氣泡量等條件下的瞬態壓力脈動過程進行了模擬研究。
分享友人
分享到 Line

分享到臉書