水冷劑 的英文怎麼說
中文拼音 [shuǐlěngjì]
水冷劑
英文
water coolant-
The former is to gain refrigeration volume through the process of adsorbing adsorbate ( cryogen ) by adsorbents ; while in desiccant cooling, solid adsorbent is used to remove the moisture from the surrounding
吸附式製冷是利用固體吸附劑對吸附質（製冷劑）的吸附過程而獲得冷量的。吸附除濕製冷是用固體吸附劑將空氣中的水蒸汽部分除去，並與蒸發冷卻等技術結合，達到製冷效果的製冷方法。The dissertation shows how a series of well - performing composite adsorbents that prepared by author suitable for the features of adsorption refrigeration are gained by using water and ethanol as cryogen ( adsorbate ), which cause no harm to body and environment. the performance of the working pairs of water or ethanol with the composite adsorbents in the refrigeration through adsorption and desiccant cooling are thoroughly examined by experiments. the dissertation also examines, through energy analysis, the refrigeration efficiency and utilization ratio of the adsorption refrigeration, and analyzes the economic potential of the adsorption air - conditioning
以對人體無傷害、對環境無污染的水和乙醇作為吸附製冷工質，研製出適合於吸附製冷特點的性能優良的一系列復合吸附劑；對水或乙醇與自製復合吸附劑組成的製冷工質對的吸附式製冷和吸附除濕製冷的性能進行了深入的實驗研究；用有效能分析方法討論了吸附製冷循環的製冷效率和能量的利用率；對吸附式空調的經濟性進行了分析。In the experiment of searching the agent for removal of phaeocystis globosa, six organic biocides were studied on their effect of removal of phaeocystis globosa. then isothiazolone biocide, glutaric dialdehyde and benzalkonium bromide were selected to apply to remove p. globosa red tide. their minimum use levels are 1. omg / l, 1. 4mg / l, 0. 6mg / l respectively, and the efficiencies of removal are above 80 %
論文對有機除藻劑進行了篩選研究，對目前常用於工業循環冷卻水的6種有機殺生劑進行了試驗研究，發現異噻唑啉酮、戊二醛和新潔而滅對棕囊藻均具有良好的去除效果，它們使用的最低有效濃度分別是： 1 . 0mg l 、 1 . 4mg l 、 0 . 6mg l ，除藻率達80 。Test study on two biocides, namely quaternary ammonium salt and isothiazolinelcetone, commonly used in circulatory cooling water system has been carried out, obtaining the relationship among dosage, actuation time duration, and the killed persontage, and putting forward the principle and points needing attention for selecting the biocide
摘要對火電廠循環冷卻水系統常用的兩種殺菌劑季胺鹽及異噻唑啉酮進行了試驗研究，得出加藥量、作用時間與殺菌率的關系，並提出殺菌劑的選擇原則和注意事項。Hydrotropic solution of calcium chloride is the important cryogen for refrigerator and ice making. it is also a good anti - freeze agent and agglomerating agent in construction for concrete hardening and cold hardiness of sand mortar
氯化鈣水溶液是冷凍機用和製冰用的重要致冷劑，基建上能加速混凝土的硬化和增加建築砂漿的耐寒能力，是優良的建築防凍劑凝結劑。The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine
用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。The main content is : splitting tensile experiments were carried out about the standardized cube bonding specimens ( 150x 150x 150mm3 ) of the new - old concrete after high temperature. the temperature is divided into 9 groups from normal atmospheric temperature to 900, the cooling styles are natural cooling and spraying water cooling ; different interfacial treating methods : brushed with steel - wire brush, man - made chiseling ( not evenly ), man - made chiseling ( quite evenly ) ; different interfacial agents : no interfacial agent, neat cement paste, cement paste mixed with 10 % expanding agent
主要內容有：本文對75個高溫作用后的標準立方體新老混凝土粘結試件進行了劈拉試驗，溫度從常溫到900c分9個溫度段，降溫方式分自然冷卻和噴水冷卻兩種。著重考察了溫度、降溫方式、界面粗糙度及界面劑對新老混凝土粘結劈拉強度的影響規律，闡述了高溫后粘結強度下降的機理。Gas hydrate and multicomponent salt hydrate etc. are very important cool storage media for air - conditioning and refrigerator, and so on
製冷劑氣體水合物及多元水合鹽等是重要的蓄冷介質，可應用於空調、冰箱等蓄冷系統。The most common heat transfer fluid is water / propylene glycol, although other heat transfer fluids such as silicone oils, hydrocarbon oils, or refrigerants can be used
最普遍的載熱流體是水/丙二醇，盡管其他載熱流體像硅樹脂油，烴油或是製冷劑也有應用。Suitable for the domestic water, food processing water, cool the circulating water, the boiler supplies water, exceed the filtration in advance of the pure water, steam condensation water, build well liquid and water flooding in the oil field, chemical liquid medicine, electroplate the filtration that the liquid, much kinds of acid or alkaline solution, emulsifier wash helping, cleaning solution, medical products, ink and water treatment of the semiconductor, electron trade
水過濾器適用於生活用水食品加工用水冷卻循環水鍋爐供水超純水的預過濾蒸汽冷凝水油田修井液及注水化學藥液電鍍液多種酸性或堿性溶液乳化劑洗滌濟洗滌液醫藥製品墨水的過濾及半導體電子行業的水處理。H. t. fresh cooling system is filled cooling water of soften additive expansion chamber arrives at water level of being specified
3高溫淡水冷卻系統已注入軟化添加劑的冷卻水，膨脹水箱達到規定的水位高度。To the chill climate character on neimeng region, this paper selects the suitable cement content for decreasing temperature contraction cracking on road base through the test of cement stabilized sand - gravel material
本文針對內蒙地區寒冷的氣候特點，通過水泥穩定砂礫材料特性研究，確定了合適的水泥劑量，以減輕基層產生溫縮裂縫。This paper ’ s background is society need, and assimilates experience of former scholar to improve on a liquid self - circulating radiator for electronic component and develops a new form of more effective compound heat pipe radiator for electron component. at the same time, which is charged respectively by four natural working substance ? ? methanol, ethanol, acetone, water and a refrigeration ? ? r123
本文正是在這樣一個社會需求背景下，吸取前人工作經驗，改進原有電子器件液體自循環冷卻系統，並開發出一種更為有效的電子器件復合型熱管散熱裝置，分別使用了四種天然工質? ?甲醇、乙醇、丙酮、水和一種製冷劑? ? r123進行試驗。The results show that while the mass flow of refrigerant is 1. 85g / s, the inlet temperature of refrigerant is 18. 9, the evaporating pressure is 0. 62mpa, the mass flow of water is 31. 1g / s, and the inlet temperature of water is 36. 9, the refrigerant of miniature evaporator wholly vaporizes in the tube, and the heat transfer rate is 342w. it achieved the demand of design
經過實驗測試，當製冷劑質量流量為1 . 85g / s ，製冷劑入口溫度為18 . 9 ，蒸發壓力為0 . 62mpa ，水的質量流量為31 . 1g / s ，水的入口溫度為36 . 9 ，此時，螺旋管蒸發器內製冷劑完全蒸發，換熱量342w ，達到了微型蒸發器的預期設計要求。At the same time, experimental study on boiling heat transfer by changing mass flow of refrigerant, mass flow of water, and inlet temperature of water was also finished. and then the performance of miniature evaporator was estimated
本文完成了液單相、兩相熱平衡實驗和阻力特性實驗，研究了製冷劑在管內流動的壓降;同時進行了微型蒸發器流動沸騰實驗，通過改變製冷劑質量流量、水的質量流量、水的進口溫度等，實現了對微型蒸發器的性能評價。The results show that, when the compressor continuously runs, the stability of the test bed after using manual valve is better than that of using thermal valve, and it is little affected by the kinds of valves for adjusting cooling water ; and that, when the compressor intermittently runs, the operation stability would be obtained if pneumatic valve is used to adjust cooling water, especially at low speed
結果表明，壓縮機連續運行時，製冷劑採用手動閥調節后工況的穩定性明顯好於採用熱力膨脹閥時的情況，此時調節冷卻水量用的電動調節閥和氣動調節閥對工況穩定性影響相差無幾；間歇運行時，無論是熱力膨脹閥還是手動閥，即便壓縮機通電時間最長，仍達不到設定工況，特別是低速的斷續尤為明顯，而使用氣動閥就能很好地解決這一問題。Testing of cooling lubricants ; determination of corrosion preventing characteristics of cooling lubricants mixed with water ; herbert corrosion test
冷卻潤滑劑的檢驗.摻水冷卻潤滑劑防腐性能的測定.第1Testing of cooling lubricants ; determination of corrosion preventing characteristics of cooling lubricants mixed with water ; chip filter paper method
冷卻潤滑劑的檢驗.摻水冷卻的潤滑劑防腐性能的測定Investigation on characteristics of pressure drop for binary mixture in horizontal micro - fin tube
水平微翅管內二元混合製冷劑流動沸騰阻力特性研究In order to solve this problem, this paper analyzes the fault diagnosis method for chillers using wavelet packet analysis. this paper simulated 9 faults including decreasing of cooling water flow, decreasing of refrigerant and non - condense gas existed and so on. it also analyzed the fault diagnosis technology combined theory and experiments
本論文模擬了冷卻水量改變、有不凝性氣體、製冷劑流量減小等九個故障，並採用理論分析與實驗驗證相結合的方法對單螺桿式冷水機組的故障診斷技術進行了研究。分享友人