水量損失 的英文怎麼說

中文拼音 [shuǐliángsǔnshī]
水量損失 英文
water loss
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 損 : Ⅰ動詞1 （減少） decrease; lose 2 （損害） harm; damage 3 [方言] （用尖刻的話挖苦人） speak sarcas...
  • 水量 : water yield; the yield of water水量計[表] watermeter; 水量平衡 water balance; 水量收支 water budget
  • 損失 : 1. （失去） lose 2. （失去的東西） loss; wastage
  1. The effect of groyne length and layout on water surface is analyzed in the paper. based on the results of simulation and experiment, the local energy loss of the flow due to the groyne is studied. consequently the surface variation and height of damming are also analyzed

    論文分析了丁壩長度與布置對水面線的影響，根據流場、紊動場模擬結果和實驗結果研abstract究丁壩造成的水流局部能量損失，並對水面變化和丁壩奎水高度進行了分析。
  2. The soil salification is a serious problem for agriculture and environment. especially now with the development of industry, the situation of soil salification becomes more and more serious, and the quality of water is continuous worsened. research on the mechanism of salt tolerance especially in the important crops, such as wheat, is becoming more urgent than ever before

    土壤鹽漬化是影響農業生產和生態環境的嚴重問題，隨著工業污染加劇，灌溉用水的質量不斷下降和化肥使用不當等原因，次生鹽堿化土壤面積有不斷加劇的趨勢，給農業生產造成重大損失；黃矮病毒病是小麥等禾本科植物的重要病害之一，其傳毒介體蚜蟲更使植物產量損失巨大。
  3. The impacts of both the velocity head and momentum distribution in the t - junction of a tailrace surge tank on the critical stable sectional area of the tank were analyzed by using gardel ' s empirical equations for t - junction flow. based on thoma ' s theory, a formula of the critical stable sectional area is derived. 5

    基於gardel關於三通管水頭損失的經驗公式，研究分析了連接管處的速度水頭以及進出調壓室水體與尾水隧洞水體之間的動量交換，對有連接管的尾水調壓室穩定斷面積的影響，並在托馬（ thoma ）假定基礎上，推導出相應的調壓室穩定斷面的計算公式； 5
  4. But now it ' s urgent to adopt new methods for calculating the head loss of regional drainage due to some factors such as long length, large flow quantity and probable strong topographic change

    由於存在管線長、流量大以及區域地形變化幅度可能較大等因素，建設區域排水系統需要採用新的方法較為準確地計算水頭損失。
  5. The article takes a 600mw natural cycle drum boiler ( soot blow using steam ) as investigating object, establishes soot accumulation loss and soot blowing energy loss models for its water cooling wall, superheater, economizer and air preheater respectively, set up instructions for soot blower operating. simulating calculation results are compared with site data to verify usefulness of key models. the article introduced the operation optimizing design of soot blowers of yanzhou no2 power plant based on theoretical research

    本文以600mw汽包自然循環鍋爐（蒸汽吹灰）為具體分析對象，分別建立其水冷壁、過熱器、省煤器、空預器的積灰損失和各受熱面吹灰能量損失的模型，建立相應的吹灰器運行規則指導，對設計中的關鍵模型問題，通過模擬計算及與現場數據作比較的方法，驗證其可用程度。
  6. Roasted ground coffee. determination of moisture content. method by determination of loss in mass at 103 degrees celsius routine method

    焙烤的磨碎咖啡.水分的測定.在103溫度下質量損失的測定
  7. All bends should be smoothed out to minimize headloss and chance of siltation

    所有彎位均須平滑，以盡量減低水頭損失及造成淤積的機會。
  8. The tank shall be totally encased in a metal jacket and insulated with a non - cfc foam to reduce stand - by heat loss

    應該採用金屬外殼將熱水器內膽完全包裹起來，並配置非氯氟烴泡沫加以絕緣隔熱，以減少熱量損失。
  9. The centrifugal pump for oilfield waterflooding and oil transfer worked with low pump efficiency owing to unstable load and its energy loss is fairly large

    油田注水集輸系統離心泵由於載荷經常變化，大多不能在其額定工況點工作，泵效低，且需要用泵出口閥調節流量，產生一定的泵管壓差，造成較大的能量損失。
  10. The study result also shows that there is significant energy exchange between all the pipe sections connected to the same junction, therefore, those flow phenomenon can not be accurately reflected if neglecting or adopting the constant energy loss coefficients

    研究結果還表明，與同一結點相接的各管段間存在顯著的能量交換，因此，忽略或採用恆定不變的能量損失系數均不能正確地反映這些水流現象。
  11. We found out that the loss in weight was caused by excessive moisture

    我們發現重量損失由過多的水分引起。
  12. Test method for determination of moisture in plastics by loss in weight

    通過重量損失測定塑料中水含量的試驗方法
  13. Ceramic grain filters ard made of refined pottery clays added with certain modifiers, and processed of grinding, mixing, shaping and high temperature sintering. they do not contain any substances that harmful to people or environment. they are hard and rough in surface, porous inside the structure, and have the advantages of high mechanical strength, large specific surface area and porosity. when used in water treatment, they behave a activated surface property, a great amount of pollutant entrapment, less water head loss in the filter bed, lower consumption of back - flush water, stable in chemical and gbiologic property, and long service life, ceramic grain filters is a new and efficient filter material to increase the water yield, upgrade the water quality, and save chemicals and energy

    陶粒濾料是以精製陶土為主要原料，摻加適量改性劑，經粉碎，混練，成型和高溫煅燒而製成的，不含任何對人體和環境有害的物質.其表面堅硬，粗糙，內部疏鬆，多孔，具有機械強度高，比表面積大，孔隙率大的特性.用於水處理中，具有表面性狀好，截污能力強，過濾水頭損失小，反沖洗耗水量低，化學穩定性和生物學穩定性好，使用壽命長的特點.陶粒濾料是一種能增加水產量，提高出水質量，節省藥劑和能耗的新型高效過濾材料
  14. The open angle, head loss and hydrodynamic pressure under the rated flow and several kinds of proportion are carefully observed in the model test, and these results are given for reference in engineering design

    階段模型試驗中詳細觀測了在額定流量下，不同比重拍門的開啟角度，水頭損失及門體動水壓力變化情況，以供工程設計應用參考。
  15. One side, groovy cast steel flap valves increase the head loss, waste electricity, the other side, when flap valves close, it always delay time because of it ' s low proportion. the bump load seriously threaten the safety of pumping station. through the research and development of flap valve used in the renovation practices in the design of air - filled floating flap valve in no. 1 chuhe pumping station of anhui province, the working characteristics and design methods of air - filled floating flap valve are studied in this paper

    但在拍門運行使用的同時，又時常暴露出一些缺陷，主要有：一是常規的鑄鐵或鑄鋼拍門加大了流道的水頭損失，特別是對于裝機容量較大的排澇泵站，其電能損耗相當可觀；二是拍門在自重下下落關閉時，往往由於過多考慮水頭損失導致浮重過小而延誤閉門時間，致使水體倒灌，再因緩沖裝置失靈導致閉門時門體對門框撞擊力很大，嚴重危及站身安全。
  16. Because the operation in water hydraulic valves is controlled by flow fluid and the pressure drop results from energy loss of flow fluid past valve channel, the flow state of fluid in valves becomes the most important factor for the operational property of valves

    由於水壓閥是通過控制流體流動來操作系統的，閥的壓降也來自於流體流經閥道時的能量損失，因此閥內的流體流動狀態就成為決定閥操作性能最為重要的因素。
  17. After simulating the model of water hydraulic valves, the velocity distribution, pressure distribution, energy distribution can be obtained and relations between the valve channel and the energy loss, the negative pressure distribution can be analyzed, which offers the theory foundation for designing water hydraulic valves with the high efficiency, low energy loss and low noise

    通過對水壓閥模型的cfd穩態和瞬態解析，可以得到水壓閥內流場的速度分佈、壓力分佈及能量分佈，據此定性分析流道結構（速度、壓力、流動的分離與再附壁，旋渦的產生與消失等）與能量損失、負壓分佈等的關系，從而為設計出高效率、低能耗、低噪聲的水壓閥提供理論依據。
  18. It is pointed out that passage hydraulic loss is related to the flow circulation, the influence of flow deviation on passage hydraulic loss and pump assembly efficiency is analyzed, the forming mechanism of flow deviation is investigated, and the method of eliminating flow deviation is put forward

    指出流道水力損失與水流環量有關，分析偏流對流道水力損失和泵裝置效率的影響，研究偏流形成機理，提出消除偏流的方法。
  19. The horizontal and vertical momentum loss caused by the shock of heavy rain in low - level wind shear of thunderstorms on the airframe and wing are analyzed, the water film thickness on the airframe and wings estimated, and the flight resistance resulted from raindrops - striking caused by the roughness of airplane when the heavy rain shocks the airplane is discussed

    摘要分析了雷暴低空風切變中大雨滴沖擊飛機的機身和機翼而引起的水平和垂直動量損失，估算了大雨累計在機身和機翼上的水膜厚度，並討論了因遇到大雨雨滴沖撞而粗糙化的機體所產生的阻力。
  20. Measures for controlling the water loss of the cooling tower

    防止冷卻塔水量損失的措施
分享友人
分享到 Line

分享到臉書