注井 的英文怎麼說

中文拼音 [zhùjǐng]
注井 英文
recharge well
  • : Ⅰ動詞1 (灌入) pour; irrigate 2 (集中) concentrate on; fix on; focus on 3 (用文字來解釋字句)...
  • : Ⅰ名詞1 (從地面往下鑿成的能取水的深洞) well 2 (形狀像井的東西) sth in the shape of a well 3 (...
  1. Oil / water two - phase flow is very common in oil production wells of affusion oil field and the measurement of oil / water two - phase flow is the key of the oil / water two - phase profiling technique

    水開發油田的油中普遍存在油水兩相流動,油水兩相流測量問題是油水兩相產出剖面技術的關鍵。
  2. In view of bearing capacity of the elastoplastic theory analysis, the author made a comparison between the achieved bearing capacity limit load pi / 4 of round base ( space problem ) and the limit load pi / 4 of bar groundwork foundation design ( plane problem ) from soil mechanics at home and abroad as well as foundation criterion, and explained why the value of formula in present design criterion from soil mechanics is inclined to be conservative. in the light of the author ' s many years experience of vibration test on the spot and the research work of relevant projects, the author worked over the dynamic pile testing of the bearing capacity of foundation and batholith, and gathered the parameter of dynamic analysis and testing. the author also talked over the difficult point of pile foundation design criteria in present batholith engineering world, i. e. the confirmation of batholith bearing capacity of pile end, from the following aspects : a ) confirmation of single axis counter - pressure strength of rock in house ; b ) f. e. m calculation of elastoplastic model ; c ) calculation of soil mechanics ; d ) deep well load test

    然後,對巖土工程領域至今尚未解決,甚至不為人意的考慮地基變形的地基承載力問題進行了實用化的探討,提出了考慮地基變形的地基承載力上程計算方法;對基於彈塑性理論分析的地基承載力國內尚未見報道的空間問題得到了圓形基礎(空間問題)的承載力界限荷載p _ ( 1 / 4 ) ,並與國內外土力學專著及地基基礎設計規范中的條形基礎(平面問題)的界限荷載p _ ( 1 / 4 ) ,進行了對比,從而定量上解釋了目前設計規范引用土力學承載力公式值偏於保守的這一情況;根據本文作者多年從事現場地基工程振動試驗及相關課題的研究工作,本文以截頭錐模型模擬地基,對地基(巖基)承載力的動測法進行了研究,為各類地基(包括巖基) ,匯總了動力分析和檢測川的參數:針對日前巖土工程界應用樁基設計規范中的難點? ?樁端巖基承載力的確定問題,從巖石室內單軸抗壓強度確定、基於彈塑性模型的有限單元法計算、土力學計算及深斤載荷試驗四方面進行了深入討論;本文作者根據多年現場載荷試驗的工程實踐,對深荷試驗裝置的核心部分? ?反力裝置,設計了側壁支撐反力加載系統,該加載系統具有實用、簡便、穩定及安個等優點。
  3. The practice of grout solidifying and caulking of the underground hydrology drill after water outburst

    下水文鉆孔涌水后漿固孔與堵水實踐
  4. The main shaft grouting technology in pengzhuang coal mine

    彭莊礦漿技術
  5. Based on the development feature analysis, this paper studies thoroughly the reservoir flood feature and remaining oil distribution through the microstructure, sendimentary phase, reservoir heterogeneity and well control, and proposes the comprehensive adjustment based on the injection and development well net structure and improvement the result of the research is obvious with the production degression rate from 9. 14 % of 1997 to present - 1. 46 %, and water rate from original 0. 33 % to present 0. 16 %. in summary, the research idea, method and new achievement of the thesis provide a scientific geological basis for the oilfield development improvement

    在對本區開發歷程和開采特徵分析的基礎上,從微構造、沉積微相、儲層非均質性、網控制等方面深入地分析了油藏水淹特徵及剩餘油分佈規律,提出了以完善網、調整采結構為目的的綜合調整措施,已見到了明顯的效果:油田遞減由1997年的9 . 14降至目前的- 1 . 46 ,綜合含水上升率由原來的0 . 33降至目前的0 . 16 。
  6. Technical standard of thermal packer and expansion joint

    蒸汽封隔器及下補償器技術條件
  7. Drop feed well type gas carburizing furnace

    式氣體滲碳爐
  8. Lines beginning with a hash mark are comments and should be ignored

    號( )開頭的行是釋,應該被忽略。
  9. Application of n maleic acid in blocking up water grouting

    漿材料在筒堵水中的應用
  10. Harness technology for karst water in ordovician limestone with underground grouting of hole

    下鉆孔漿治理奧灰水技術
  11. A lone yankees fan at the back of the scrum stated, " we didn ' t get daisuke matsuzaka, but we got igawa.

    一位孤單的洋基迷在這名眾多人目的選手身後說:我們沒有得到松坂大輔,但是我們得到川慶。
  12. Is not dread of thirst when your well is full, the thirst that is unquenchable

    當你們的滿時,你仍害怕口渴,這渴豈不是永無止盡?
  13. Grouting and water sealing technology for mine shaft sinking through water flooded goaf

    筒過積水老空區的漿堵水技術
  14. Back grouting and water sealing technology for mine auxiliary shaft lining in shoushan no. 1 mine

    首山一礦副筒壁后漿堵水技術
  15. The western side hall, or holy kitchen ( shen chu ), is the place where sacrificial offering foods are made

    東、西亭專為方澤壇內澤渠水和為神廚供水。
  16. Recommended operational method for preventing of clay - swelling and fine - migration in acidizing of water injection well

    酸化中粘土防膨與微粒防運移工藝規范
  17. In this thesis hydraulic experimental studies and theoretical analyses on the vortex - flow drop shaft were conduced and the following results were accomplished : ( 1 ) in the model test some hydraulic characteristics including the shape of air core in the center of the drop shaft, the radial distribution of water flow velocity and the distribution of pressure on the wall of the drop shaft were measured under the condition of high water head above 250m and large discharge above 1400m3 / s. ( 2 ) a kind of computational method for the spiral water flow in the air core region of drop shaft was discussed and applied and the results agree the experimental data well. ( 3 ) the total ratio of energy dissipation in the drop shaft can reach 90 % and the energy dissipation in every region was discussed quantitatively

    本文通過試驗研究與理論分析對旋流式豎泄洪洞應用於高水頭、大泄流量情況時存在的一些水力學問題進行了研究和探討,取得以下主要成果:一、結合小灣工程導流洞改建,對高水頭( 252m ) 、大泄流量( 1400m ~ 3 s )條件下旋流式豎中的水流運動特徵進行了比較全面的測量,包括空腔形態、徑向流速分佈及壁壓強等;二、提出了豎空腔段螺旋水流水力計算方法,其計算結果與實測值吻合良好;三、利用試驗與計算結果,對旋流式豎的消能機理進行了探討,對豎各部分的消能能力有了總體認識;四、對豎下部消力的合理深進行了優化試驗研究,發現消力合理深度為0 . 9d左右;五、通過試驗研究,歸納出豎水流總摻氣量估算方法,為導流洞排氣方案的設計提供了參考依據;六、在高水頭、大流量條件下,豎空腔段下部流速很高,盡管水流螺旋運動引起的離心力可以確保壁壓強保持正壓,但空化數依然較低,因此豎的空化空蝕始終是工程界關的重大問題。
  18. The study gets the following conclusions : 1 ) inverted nine - spot pattern water flooding is used in the early stage of the development, while linear water flooding is used in the later stage ; 2 ) well array is parallel to the fracture trend ; 3 ) the well arrangement of barycentric position method is a suitable pattern adjustment method in the later period of the development in low permeable oil fields

    研究認為,一是油田開發初期采方式採用反九點法面積水,開發後期調整為線狀水方式;二是排方向與裂縫走向平行;三是「重心位置」布方式對低滲透油田開發後期是較為適合的網調整方式。
  19. Review is made on the results of two designs for the high pressure pregrouting at the stopes of the main shaft and the auxiliary shaft in an iron mine. one design took the geological characteristics as the basis and was strictly and scientifically made. with proper construction technical measures, it brough both good technical and economical effects to the grouting engineering. the another design was made in no consideration of practice. as a result, it brought avoidable losses to the engineering. its failure cause are analyzed

    評述某鐵礦主副工作面高壓預漿的兩種設計結果:一是以地質特點為依據,嚴格按科學設計,施工技術措施得當,給漿施工帶來了良好的技術經濟效益;二是未從實際出發進行設計,給工程造成不應有的損失,剖析其失敗原因。
  20. Tianjin fengdong heat treatment equipment co., ltd, sino - japanese joint venture, is a specialist firm to produce unicase series multi - purpose complete set, speria series pre - vacuum multi - purpose furnace complete set, uninite gas soft - nitriding furnace complete set, mesh - belt type continuous furnace, pit type bright annealing furnace and pit gas carbonitriding furnace complete set

    全套技術,生產滴式unicase系列密封箱式多用爐成套設備, speria bbh型預抽真空多用爐成套設備,氣體軟氮化爐成套設備,網帶式連續爐,式光亮退火爐及式氣體滲碳爐成套設備,並承接各種非標熱處理設備的設計和製造。
分享友人