注入速率 的英文怎麼說

中文拼音 [zhùrùsùlǜ]
注入速率 英文
injection flow rate
  • 注 : Ⅰ動詞1 （灌入） pour; irrigate 2 （集中） concentrate on; fix on; focus on 3 （用文字來解釋字句）...
  • 入 : Ⅰ動詞1 （進來或進去） enter 2 （參加） join; be admitted into; become a member of 3 （合乎） conf...
  • 速 : Ⅰ形容詞（迅速; 快） fast; rapid; quick; speedy Ⅱ名詞1 （速度） speed; velocity 2 （姓氏） a surna...
  • 率 : 率名詞（比值） rate; ratio; proportion
  • 注入 : pour into; empty into; inpouring; injection; infusion [拉丁語]; infunde [法國]; abouchement; influxion
  • 速率 : speed; rate; tempo
  1. Less reflective than ice, water absorbs more solar rays, speeding the thaw and channeling meltwater into seals ' breathing holes

    比冰的反射率小，海水吸收了更多的陽光，加速了融化並使融化后的淡水注入這些通氣孔。
  2. To research in the area of liquid helium cryopump used in nbi system is meaningful for obtaining better beam transportation efficiency. physical parameters and experience were obtained which is very useful in developing even larger cryopump

    開展中性束注入系統液氦低溫冷凝泵的相關研究，對獲得優良的束傳輸效率，具有積極的意義；並為以後開發更大抽速的低溫泵及相關應用積累了豐富的物理參數和經驗。
  3. In section one, we analyze the mechanism of lwi gain, and study the effects of the rabi frequency q of the driving field, the injection rates ratio rb / r ~, the exit rate r0, the decay rates ~ and rab between atomic levels, as well as 3 incoherent pump rate r on the gain without inversion, dispersion and population difference of the system. in section two, we discuss the effects of the detuning of the driving field and the probe field on the gain

    在第一節中分析了無粒子數反轉激光增益產生的機制、研究了驅動場的rabi頻率、粒子注入速率比值r _ b / r _ c 、粒子退出速率r _ o 、能級間的自發衰減速率r _ （ c - b ） 、 r _ （ a - b ）和非相干泵浦速率r對增益、色散和粒子數差的影響；第二節討論了驅動場和探測場的失諧對無粒子數反轉激光增益的影響。
  4. Liquid helium cryocondensation pump has great advantages in large pumping speed, working pressure range and high ultimate pressure, etc. it ' s more excellent than any other vacuum pump. it can meet the vacuum requirement of nbi and can improve the transportation efficiency. the development of neutral beam injection ( nbi ) system in the world, the structure of nbi system used on the ht - 7 device of asipp was introduced in the thesis

    液氦低溫冷凝泵是利用低溫面對氣體有強吸附能力的原理，實現抽氣的真空獲得設備，它具有抽速大、工作壓強范圍寬、極限真空度高等一系列優點，是普通真空設備無法比擬的，作為中性束注入系統的主抽泵，它能滿足中性束注入系統對大抽速的要求，提高中性束的傳輸效率。
  5. And the simulation on the nonlinear beam - wave interaction of two - cavity gyroklystron is made. the influences of the drift length and beam voltage and current and the velocity ratio of the electron beam and et al. on efficiency and gain are analyzed in detail

    並對34ghz兩腔迴旋速調管的注?波互摘要作用進行了大量的數值模擬研究，分析了漂移區長度、電壓、電流、速度lhq值、磁場k ， ； 、注入波功率等多種因素對互作用電子效率及增益的影響。
  6. In the short distance communication, with the advantageous qualities of low power consumption, high speed rate, high - capacity and multi - address access etc., the ultra - wideband communication arouses the people ' s widespread interest

    在短距離通信中，超寬帶通信以低功耗、高速率、高容量、多址接入等優點引起人們廣泛的關注。
  7. In chapter 2, we analyzed the effect of the driving field phase fluctuation on the gain and dispersion and population differences in an open v - type three - level non - inversion lasing system and then discussed the effects of the incoherent pumping rate, the ratio of the atomic injection rates, the atomic exit rate, the rabi frequency of the probe and driving fields and their corresponding detuning on the gain, dispersion and population differences of the system, and got some important conclusions different from those in closed or other open systems

    第二章討論了驅動場的相位漲落對開放的v型三能級無反轉激光系統的影響，根據解析解的數值計算結果討論了非相干泵浦速率、粒子注入速率之比、粒子退出速率、探測場和驅動場的rabi頻率和相應失諧對系統增益、色散和粒子數差的影響，得到了一些不同於封閉的v型系統及其他開放的無反轉激光系統的重要結論。
  8. In chapter 3, we studied the effect of gaussian transverse profile for the driving and laser fields on lasing without population inversion ( lwi ) in a closed v - type system and an open v - type system. moreover, we discussed also the effect of the unsaturated gain coefficient, the cavity - damping rate, the ratio of the atomic injection rates and atomic exit rate on the corresponding systems. in chapter 4, we mainly discussed the effect of doppler broadening on the gain, dispersion and the frequency up - conversion of the open v - type lwi system and compared the differences and the same between the open system and the corresponding closed system

    發現： （ 1 ）在考慮doppler展寬的情況下，通過選取合適的實驗室條件（比如合適的原子環境溫度等）可得到合適doppler展寬值，從而使系統獲得最佳增益； （ 2 ）要想實現系統的頻率上轉換，同時又要獲得足夠強的無反轉激光增益，則系統頻率轉換比不能選取的太大； （ 3 ）對于開放系統，比較小的粒子注入速率比與退出速率對產生無反轉激光是有利碩士學位論文摘要的： （ 4 ）由於dopp1oy展寬的存在，當探測場與驅動場的傳播方向相反時，增益在探測場失諧的某一段區域產生振蕩，且振蕩的振幅、頻率失諧范圍的大小與dopper展寬的取值有關。
  9. In the specjappserver2004 benchmark, the size of the system is specified by the injection rate

    在specjappserver2004基準中，系統的大小是由注入速率（ injection rate ）指定的。
  10. The realization of high code rate property is also mentioned. in the end of this paper, the author lays the emphasis on the circuit realization of high - code - rate pcm transmitter with quasi two - point injection techniques

    本文的最後部分，作者重點對準兩點注入式高碼速率發射機（主要是調頻源）的電路實現作了詳盡的分析。
  11. The txrate parameter is the injection rate

    Txrate參數就是注入速率。
  12. An injection rate of 1 maps roughly to 13 concurrent clients

    如果注入速率為1 ，則對應著大約有13個並發客戶機。
  13. To load the database, we use the loaddb. bat script where the injection rate is passed in as a parameter

    為了裝載數據庫，我們使用loaddb . bat腳本，並在其中以參數的形式傳遞注入速率。
  14. For example, the commands below will delete the data in the database and load the database supporting an injection rate of 10

    例如，下面的命令將刪除數據庫中的數據，並裝載支持注入速率10的數據庫：
  15. The configuration supports an injection rate of 785, which translates to roughly 10, 000 concurrent users, and produced more than 1, 300 business transactions per second

    該配置支持785的注入速率，相當于大約10 ， 000個並發用戶，每秒鐘產生1 ， 300多條業務事務。
  16. During the setup in the previous sections, a database that is supporting a small number of users injection rate 2 has been created and the corresponding load has been applied to the system for functional testing purpose

    在前面幾節的安裝中，創建了一個只支持少量的用戶（注入速率為2 ）的數據庫，並對系統應用了相應的負載，以進行功能測試。
  17. Using commercial finite element software ansys, the numerical simulations of the forming processes of decorated rib and handle, which are key positions in the door outer are conducted and investigated the differences of vpf and tradition forming. by using numerical simulation that investigates the effects of viscous injection flow rate on plank ’ s vpf formability and based on those investigated four - aluminum alloy ’ s vpf. the die has been designed for the door outer ’ s viscous pressure forming

    首先採用商用有限元分析軟體ansys對車門成形中的關鍵部位裝飾筋和把手的成形進行了數值模擬，對比分析了粘性介質壓力成形與剛性模成形的特點;分析了粘性介質壓力成形過程中，粘性介質的注入速率對成形試件壁厚分佈的影響，在此基礎上對四種常用的6000系列鋁合金板材的粘性介質壓力成形進行了有限元數值模擬。
  18. 7. there obvious dependency relation between the unit - absorption rate and grout consumption, general there are bearing relation, but no obvious dependency relation between the index of the rock mass integrity and grout consumption

    7 、巖體單位吸水率與單位注入量之間普遍存在一定的相關關系，而巖體完勢性指數及巖體波速與單位注入量之間不存在相關關系。
  19. The 30mev linac can be used as energy recovery accelerator with photo - cathode rf - gun injector. and multi - cavities photo - cathode injector can not only improve the quality of output electron beam, but also decrease the effect of phase question in the energy recovery process

    當注入器束流電子能量接近10mev后，第一加速段與束線中產生的減速相位與加速相位的差是小的，對能量回收效率的影響可以忽略。
  20. In this work, based on the threshold condition of the fiber grating external cavity semiconductor laser ( fgesl ) which the phase of the fiber grating has been included, the effect of the temperature variation and the fg external cavity length on the lasing wavelength of the fgesl has been investigated theoretically. in addition, we have used the phase condition of fgesl to get the longitudinal mode distribution of fgesl, then the influence of the injected current on the output characteristics of fgesl has been studied

    基於此，本文中利用陽實際的反射相位分佈，計及半導體激光器（ ld ） 、外腔及光纖光柵（ fg ）三者的共同作用，根據fgesl滿足的閩值條件，從理論上研究了溫度及外腔長度的變化對fgesl激射波長的影響;根據fgesl中縱模所滿足的相位條件得到其縱模分佈后，利用fgesl滿足的多模速率方程，研究了ld的注入電流對fgesl輸出特性的影響。
分享友人
分享到 Line

分享到臉書