泵控制閥 的英文怎麼說

中文拼音 [bèngkòngzhìfá]
泵控制閥 英文
pump control valve
  • 泵 : 名詞（吸入和排出流體的機械） pump
  • 控 : 動詞1 （告發;控告） accuse; charge 2 （控制） control; dominate 3 （使容器口兒朝下 讓裏面的液體慢...
  • 制 : Ⅰ動詞1 （製造） make; manufacture 2 （擬訂; 規定） draw up; establish 3 （用強力約束; 限定; 管束...
  • 閥 : 名詞1 （指在某方面有支配勢力的人物或家族） established house or power group; a powerful person or...
  • 控制 : control; dominate; regulate; govern; manage; check; cybernate; manipulate; encraty; rule; rein; c...
  1. The acv 513 - 6 pump control valve starts in an open position during pump start - up, purging the deep well of air and debris to atmosphere

    6泵控制閥在泵啟動期間開始處于開啟的狀態，將深井中的氣體和碎片清除到大氣中。
  2. This paper supplied a new way through variable frequency variable speed ( vfvs ) to change its output flow rate and adding a constant - pressure - drop valve, which could solve the defects in hydraulic pressure servo control system, such as low efficiency in control system, short life, poor ability in resisting pollution, low efficiency in driving system and flow rate, pressure pulse. and this way was proved to be effective

    本論文針對傳統伺服控制系統效率不高、元件壽命短、抗污染能力差、驅動系統效率低、存在流量及壓力脈動等缺陷，利用先進的交流變頻調速技術改變液壓泵轉速的容積調速新方法，提出了在液壓系統中加一個定差減壓閥的新思路，較好地解決了液壓伺服系統存在的上述問題。
  3. This system has two modes : automatic, manual. under the automatic condition, when the system detect that there is fire happening, the system will turn off blower, switch on valve and pump, and extinguish the fire if no people deal with the fire in the set time after the audible and light. under the manual condition, the operator can extinguish fire in the appointed area by the button in the main controlling panel or the manual button box ( locale )

    在自動方案運行情況下，當系統檢測到有火災情況發生時，在發出聲、光報警后的一定時間，如果無人干預，則系統自動執行關閉風機、開閥、開泵，對火災區域進行水霧滅火；而在執行手動方案情況下，操作人員可以通過操作主控制屏上的按鈕或手動按鈕（現場）來對指定的區域進行噴灑滅火。
  4. Through consulting lots of relevant references, present research of direct drive volume control hydraulic servo system is summarized in this paper, the principle and character of this system are expatiated, the principle of vector control is introduced. at the same time, the mathematical model of ac asynchronous motor is set up based on the vector control theory. the mathematical models of both the pump controlled motor and pump controlled cylinder are set up and simulated in this paper

    在查閱大量國內外相關文獻的基礎上，本文綜述了國內外對該系統研究概況，闡述了該類系統原理和特點;闡述了矢量控制的基本原理，並基於這一原理建立交流異步電動機的數學模型;分別建立了泵控馬達系統和泵控缸系統的數學模型，並給出了模擬分析;設計了用於泵控馬達系統的集成閥塊，加工了密閉壓力油罐;針對現有直驅式電液伺服裝置所存在的問題，本文主要針對系統工作過程中所產生的噪音與爬行問題進行了一定的研究。
  5. The main products of our company : series of mining emulsion pump station, series of electric haulage shearer, sparying pump station, series of mining flame - proof vacuum / air electromagnetic starter, series of mining vacuum / air feeding switch, series of mining fame - proof and natural - safe. type ac soft starter, series of hydraulic stand valve and pipe system, high flow rate quick - moving valve, the new product nearing into market - the hydraulic support electric - control system, mining electric drill, hydraulic valve test table, electric performance test table

    公司主導產品為：系列電牽引採煤機、系列礦用乳化液泵站、噴霧泵站、礦用隔爆兼本質安全型交流軟起動器、系列礦用隔爆真空、空氣電磁起動器、系列礦用真空、空氣饋電開關、系列液壓支架閥類及管路系統、大流量快速移架閥、即將投入市場的新產品? ?液壓支架電液控制系統、煤電鉆系列、液壓閥試驗臺、電性能試驗臺等。
  6. Process water provides sealing and cooling water to the pump and automatic drain valves allow flushing of the gland seals

    工藝水對泵起密封和冷卻的作用，自動排水閥控制對氣封裝置的清洗。
  7. Apcv air pump control valve

    空氣泵控制閥
  8. The second chapter simply introduces the development of alternate asynchronous inverter technology and retrospects some types of energy - saving systems for hydraulic elevators. then the working principles of the project are discussed and analyzed at four different working status, i. e. light load upwards, heavy load upwards, light load downwards and heavy load downwards. and the chapter focus on the introduction of structure design of pump station, calculation and type selection of pump / motor reversible units, research on oil leakage principles of accumulator circuit, design of accumulator - pump / motor pressure - energy transformer and integrated valve blocks, etc. the last but not the least, the electrical wiring of vector inverter control cabin and design of computer control and data acquisition system are introduced

    論文第二章首先簡單介紹了交流異步電動機變頻調速技術的發展概況，在回顧電梯液壓控制系統節能技術的基礎上，介紹了本課題研製的「採用蓄能器的液壓電梯變頻節能控制系統研究」的基本原理，分析了動力系統在電梯轎廂輕載上下行、重載上下行等四種典型工況下的基本工作狀態和工作方式；詳細地介紹了本課題節能系統液壓動力泵站的結構設計和參數設計，重點研究了液壓動力泵站的結構設計、液壓泵馬達可逆性問題及其選型設計計算、蓄能器迴路泄漏油損失機理的研究及其補償裝置的設計、蓄能器-泵馬達壓力能量轉換裝置的設計、多功能集成控制閥組的設計等內容；最後簡單介紹了本課題矢量控制變頻控制櫃的外部附件電氣接線、計算機控制及數據採集系統的硬體設計等內容。
  9. Diesel engine, main turbine, generator turbine, main boiler, diesel generators, deck crane, deck machineries, propeller, controllable pitch propeller, switchboard, engine control console, fire extinguishing system, inert gas system, aux. boiler, oil purifier, navigation equipment, life boat, anti rolling system, hatch cover, compressor, fin stabilizers, valves, anchor, chain and scaffolding, control system for lng carrier and various machinery for lng carrier

    主機柴油機，液化氣船主機透平鍋爐貨油泵，機艙泵，發電機，甲板吊機，甲板機械，螺施槳， cpp ，配電盤，主機遙控，消防沒備， igs ，輔鍋爐，分油機，航海儀器，救身艇，減搖裝置，艙口蓋，空壓機，減搖鰭，閥門，錨，錨鏈，船舶腳手架，液化氣船控制系統，液化氣船用各種沒備
  10. The technology used in the wisa family of products has many uses, from controlling pumps and valves to directing spot - welding robots

    應用於wisa產品家族的技術具有許多用途，從控制泵和閥門到指揮點焊機器人。
  11. The control precision of the slider with 2400mm effective stroke can reach 0. 05mm. the properties of the position control system are not exigent, only the dynamic non - overshooting and the stable - state - precision are considered. the system has given out satisfactory result when used in practical engineering, 0. 03mm position control precision has been achieved, on account of dead band, the performance of proportional valve is worse than that of servo valve, but some advantages of proportional valve has made it more fit for industrial control

    系統方案採用重復性能（反向回差）好的比例方向閥，使有效行程為2400mm的滑塊控制精度達到0 . 05mm ，位控系統快速性要求不高，主要考慮系統穩態重復精度，此方案在實際工程中已經取得了滿意的效果，位置控制精度達到0 . 03mm ，可以取代同類產品中日本川崎重工的泵控系統。
  12. The test platform adopts controlled system for silion controlled governing and electrohydraulic proportional relief valve loading to achieve the microcomputer controlled

    實驗臺採用可控硅直流電機控制轉速系統和電液比例溢流閥加載系統來實現被試泵的計算機控制。
  13. Each chemical has a station consisting of a feed pump, inductive flow meter and control valve. this ensures the reproducibility of chemical quantities

    每一種化學助劑都有一個工作站，包括有輸液泵、電感式流量計、以及控制閥，這就保證了助劑用量的再現性。
  14. Xd - jb1. 1style is non - automatic - controlled piston glue pump

    1型屬於它控式活塞膠水泵，它由電磁閥控制氣壓驅動的頻率。
  15. Xd - jb1. 2 style is non - automatic - controlled piston glue pump. frequency of pneumatic drive is controlled by solenoid valves. the attached heating device can adjust water temperature according to surrounding temperature

    2型屬於它控式活塞膠水泵，它由電磁閥控制氣壓驅動的頻率。膠水泵附有的加熱裝置，可按環境溫度調節膠水溫度。
  16. Reciprocating internal combustion engines. terms and definitions of engines components. part 2 : camshaft drive, valves and fuel pump drive and actuated mechanism

    往復式內燃機.發動機部件術語和定義.第2部分:凸輪軸控制閥門和燃料泵作動機構
  17. Principles and application of pump control valve with multiple functions in water hammer protection

    多功能水泵控制閥的水錘防護原理與應用
  18. The realizing methods for the algorithms are presented also. a hydraulic experiment system is established to simulate the different states of hydraulic system, with a pump, several valves, turbo - flowmeter, pressure gauge, and many hydraulic pipelines of different diameter

    利用液壓泵、各種控制閥門、標準表及不同管徑液壓管路構建了一個液壓實驗系統，可實時模擬武器裝備液壓系統的各種工作狀態，為超聲波的壓力、流量測量提供了一實驗平臺。
  19. In the light of significant energy losing during the hydraulic excavator working, a dynamic system was made up from the diesel engine, the variable pump, the control valve and the load to cut down the losing energy from a systematic approach based on the control characteristics of the system elements

    摘要針對液壓挖掘機在工作過程中存在的大量能量損失，根據泵的控制特性曲線，將發動機、變量泵、控制閥及負載作為一個動態系統來研究其節能問題。
  20. Swing check valves can be adversely affected by turbulence if placed too closely to other piping components such as pumps, control valves, meters, reducers, tees, elbows, etc

    如果過于靠近其它管道部件，如泵，控制閥，儀表，收縮管，三通，彎管，等等，旋啟式止回閥可能會被湍流反作用。
分享友人
分享到 Line

分享到臉書