泵水試驗 的英文怎麼說
中文拼音 [bèngshuǐshìyàn]
泵水試驗
英文
water test-
Study on the test system of a water hydraulic pump
純水液壓泵試驗系統研究The paper analyses the stress and relative motion of piston / cylinder and swash plate / slipper matching pairs in water hydraulic pisto n pump, based on which the proper experimental research method is determined
對水壓柱塞泵柱塞、滑靴摩擦副的受力和相對運動形式進行了分析,確定了摩擦副合理的試驗研究方法。Aim of this study was to meet the need for development of tribological parts in pumps. at room temperature tribological properties of different sliding pairs of silicon carbide and alumina - based ceramics were tested using a laboratory tribometer in the ring - on - plate geometry under reciprocating sliding linear contact in different media, such as distilled water, aggressive media and air
本文針對目前泵用摩擦零部件材料發展的需要,在實驗室摩擦磨損試驗機上研究了按環/塊線接觸方式作往復運動條件下的碳化硅和氧化鋁基陶瓷材料摩擦副在水、化學腐蝕性介質作潤滑劑和無潤滑時室溫下的摩擦磨損特性。By the scale of 1 : 35 flood - relief model test, combined the structures built and the pump entrance will be built of baishan dam, to decide the overall arrangement of the water cushion
通過1 : 35比尺的整體泄洪模型試驗,結合白山已建的建築物及籌建的白山大泵進水口,選定水墊塘的總體布置方案。Using the perturbation transfer matrix method as well as the tested data in the laboratory, the 1st and 2nd order perturbed identification of dynamic parameters of the rotor of a boiler pump is made
摘要利用攝動傳遞矩陣法,結合實驗室的試驗,對某電站鍋爐給水泵轉子的動力學參數進行了一階和二階攝動識別。In addition, cavitation is a difficult problem in hydraulic machinery. on the basis of a great deal of literature review, the author is also involved in the design of cavitation test facility
另外,汽蝕一直是水力機械的難點問題,在閱讀大量相關資料的基礎上,積極參與設計了泥泵汽蝕試驗裝置。Standard test method analytical procedure for determining the efficiency of a production well in a confined aquifer from a constant rate pumping test
通過一連續比率的泵試驗對限制性含水層內生產井效率測定的標準試驗方法The flow regime, sediment deposition and the loss of head of two head tanks of the sewage pumping station with different dimensions are studied by using a hydraulic model test method
摘要採用水力模擬的方法對兩個不同結構尺寸的污水泵站高位井的水流流態、泥沙淤積及水頭損失等進行了模型試驗。Pumps - rotodynamic pumps - circulation pumps having a rated power input not exceeding 200 w for heating installations and domestic hot water installations - noise test code vibro - acoustics for measuring structure and fluid - borne noise
泵.旋轉動力泵.家用熱水置裝和供熱裝置用的額定功率輸入不超過200w的循環泵.測量結構和流體導聲的噪音試驗編碼聲振搗Methods for model tests of hydraulic turbine and reversible pump - turbine
水輪機及雙向泵水渦輪的模型試驗方法Water - turbine pump - part 2 : test methods
水輪泵第2部分:試驗方法Testing methods of water - turbine pump
水輪泵試驗方法With piv technology, the flow field was measured to judge the performance of pump sump. by analyzing the pictures of velocity, streamline, turbulent kinetic energy and vorticity, we found that the turbulence was bigger while the ratio of the runoff increased. and the vortices always appeared in the field where the runoff was small
通過piv試驗,測量了封閉式水泵吸水室內部的流場,以研究該水泵吸水室的性能; ( 2 )通過分析流速圖、流線圖、湍動能圖和渦量圖,發現了流量比越大,湍動越大,漩渦總是出現在流量較小的一側。Centrifugal, mixed flow and axial pumps - code for hydraulic performance tests - precision class
離心泵混流泵和軸流泵水力性能試驗規范精密級Based on many references form civil and abroad, the author mainly studies the measurment theory and method for flux, raising height, axial power and rotational velocity. avoiding many complicated and intermediate courses for power wastage analysis, introduces the electric measurement and using efficiency curve of motor in measureing axial power, and satisfies the automatization of the device. the paper also provides a new method, inductive winding, in measuring rotational velocity of electromotor, supplys limitations of other method in measuring rotational velocity of electromotor in water, and meet practical needs in developing diving electric pump for corporation
作者在參閱大量國內外有關文獻,著重探討了水泵流量、揚程、軸功率、轉速的測試原理和測試方法,提出了採用電測法並結合電機效率特性曲線測量水泵軸功率,從而避免了損耗分析法中大量復雜的中間過程,滿足了試驗裝置的自動化測量要求;採用漏磁感應線圈法測量電機轉速,彌補了其它轉速測量方法對水下電機測試的局限性,適應了萊恩公司開發潛水電泵的實際需要。Performance tests in site for the large boiler feedwater pump
大型鍋爐給水泵性能現場試驗方法Performance test and analysis of boiler feed water pumps before and after overhaul
給水泵大修前後性能試驗及分析Hydrometric determinations - pumping tests for water wells - considerations and guidelines for design, performance and use
液體比重的測定.水井的泵送試驗.設計性能和使用的考慮和指南Pliers and nippers - multiple slip joint pliers - dimensions and test values
夾扭鉗和剪切鉗.水泵鉗.尺寸和試驗值Testing equipment and testing method for centrifugal pump was introduced, and experimental steady - state hydraulic performance during changing outletangle was obtained through changing outlet angle and the result was discussed at the end
摘要介紹了離心泵性能試驗的試驗裝置和試驗方法,通過對一臺離心泵的試驗,給出了水泵在改變其葉輪出口角時各參數的穩態性能曲線,並對其進行了分析。分享友人