活性稀釋劑 的英文怎麼說

中文拼音 [huóxìngxīshìjì]
活性稀釋劑 英文
reactive diluent
  • 活 : Ⅰ動詞1 （生存; 有生命） live 2 [書面語]（救活） save （the life of a person）:活人無算 （of a goo...
  • 性 : Ⅰ名詞1 （性格） nature; character; disposition 2 （性能; 性質） property; quality 3 （性別） sex ...
  • 稀 : Ⅰ形容詞1 （事物出現得少） rare; scarce; uncommon 2 （事物之間距離遠; 空隙大） sparse; scattered 3...
  • 釋 : Ⅰ動詞1 （解釋） explain; elucidate 2 （消除） clear up; dispel 3 （放開; 放下） let go; be reliev...
  • 劑 : Ⅰ名詞1 （藥劑; 制劑） a pharmaceutical or other chemical preparation 2 （某些有化學作用的物品） a...
  • 活性 : [化學] activity; active; activated活性肥料 active fertilizer; 活性酵母 active dry yeast; 活性粘土...
  • 稀釋 : [化學] dilution; thinning; attenuation; deliquate; dilute稀釋處理化 dilution; 稀釋劑 diluent; att...
  1. It is a heavyweight detergent that contains active emulsifying agent and rust - curbing agent it can easily rid grease paraffin carbon spots dyestuff and mold spectacles of the mechanic equipment metal surface or any ornamental surface it can be easily used and has an obvious effect with respect to its economy and security it works better when diluted with warm water

    本品屬重量級除漬去油污劑，經含有強力滲透表面活性乳化劑和銹抑制劑，極易去除機械設備、金屬表面、任何裝飾表面、油脂、石蠟、碳跡、染料、霉斑等污物，使用方法簡單，清洗效果顯著，而且及其安全經濟，溫水稀釋效果更佳。
  2. Study on preparing an active diluent of epoxy resin from fusel oil

    雜醇油制備環氧樹脂活性稀釋劑的研究
  3. Standard test method for dilution ratio of active solvents in cellulose nitrate solutions

    硝酸纖維素溶液中活性溶劑稀釋比的標準試驗方法
  4. The assay system of the biological activity of lymphotoxin was established using l929 cell as the sensitive target, lt international standard as the positive control and crystal violet staining method to detect viable cell after treated with lt. the best relationship between dosage and effect could be got if the cell seeding density in cell plate was 1. 6 0. 1 104 the dosage of amd was lug / ml, and the starting concentration of dilution in the plate of lt standard was 10 iu / ml with two fold dilution. the credibility of the established system was detected with rhtnfp developed by r & d

    為確定經上述步驟純化后得到的目的蛋自lt 27的生物活性，本研究以l929細胞為靶細胞、淋巴毒素國際標準品為參照，採用結晶紫染色法檢測經淋巴毒素處理后存活的細胞，對淋巴毒素生物活性測定的細胞接種濃度、淋巴毒素標準品板上稀釋的起始濃度和梯度稀釋的倍數、放線菌素d的使用劑量等進行條件實驗后，建立了人淋巴毒素生物活性測定方法。
  5. In this paper, radiation curing and photo curing are compared. the fundamental process of electron beam ( eb ) curing is elaborated, and the features of eb cured composites are discussed. furthermore, the development of eb cured composites technology is summarized, which includes the selection of the resins suitable for eb curing, photoinitiators, active diluents and the curing mechanism. finally, a kind of low - energy eb curing technology is introduced and some innovative resins are exploited

    對輻射固化與光固化進行了比較，闡述了電子束輻射固化的基本過程，並對電子束固化復合材料的技術特點進行了概述.此外，還詳細總結了電子束固化復合材料技術的發展狀況，包括可電子束固化的樹脂體系，輻敏劑以及活性稀釋劑的選擇和應用，固化機理的研究.最後，還對復合材料的低能電子束固化技術以及新型樹脂體系的探索進行了總結
  6. Aerospace industry. paints and varnishes. determination of the phosphoric acid content of a reactive diluent

    航天航空工業.塗料和清漆.活性稀釋劑磷酸含量的測定
  7. The influences of various materials on the coatings properties are studied, such as epoxy resin, reactive diluter, pigments, and additives

    文章論述環氧樹脂、活性稀釋劑、填料、助劑等對塗料性能的影響。
  8. The concept on uv curable coatings were introduced in this article. influence of prepolymers, active dilutes and additives on adhesion and abrasion resistance for the coatings of handset were discusses

    摘要介紹了紫外光固化的概念，討論了預聚物、活性稀釋劑以及添加劑對紫外光固化手機塗料附著力和耐磨性的影響。
  9. In view of the poor adhesion of ultraviolet - curing paints to metal substrate, the effect of prepolymer, active diluent, adhesion accelerator, curing process and pretreatment on the adhesion of coating to metal substrate was studied

    針對紫外光固化塗料存在與金屬基體附著力差的問題，通過試驗研究了塗料組分與工藝過程如預聚體、活性稀釋劑、附著促進劑、固化工藝及預處理對塗膜在金屬基體上的附著力的影響。
  10. A lot of indoor and in - suti test to the properties of the chemical grouting material, especially the properties requested by actual engineering has proceeded. active - diluent of furfural - acetone, low poison hardener. surfactant and a series of formula have been selected by experiment. cw series material has low glue degree, time last of it harden can be adjust, surface tension and contact angle of the material is low

    對漿材性能特別是工程實際對漿材要求的性能進行了大量室內、現場試驗測試，選擇性能優良的糠醛?丙酮活性稀釋劑、低毒憎水性固化劑、表面活性劑及系列漿材配比， cw系漿液粘度、固化時間大范圍可調、表面張力及接觸角小、漿材固化及固結強度高，具有優良的浸潤性能和工藝性能。
  11. 2 resin with bad wetness systems, and non - thixotrpic grind materials. operate as following process : add the paint material and the solvent - add surface active agent if adopt - add the pigment stir, make it disperse or grind to the needed granularity

    2對于非觸變性研磨性磨料，潤濕性差的樹脂體系操作如下：加油漆和溶劑混合加入表面活化劑如果採用加入顏料攪拌分散或研磨分散到所需細度加預凝膠攪拌分散至所需細度稀釋至所需粘度。
  12. 1 resin with bad wetness systems such as epoxy resin, polyester, alkyd, acrylic resin, use compound with the surface active agent, and the thixotropic grind materials can be acceptable. operate as following process : add paint material all kind of resin and the solvent - add the organic bentonite pre - gel, stir enough - add the pigment, stir and disperse enough - dilute

    1潤濕性比較差的環氧，聚酯，短油酸樹脂，丙烯酸樹脂等與表面活化劑合用，且觸變性研磨料科被接受的情況下，按照以下步驟操作：加油漆和溶劑混合加入有機預凝膠充分攪拌分散加入顏料充分攪拌分散稀釋。
  13. 1 while use surface activator and disperse pigment, system can grow to be thixotrpic structure during stir. operate according to following steps : add the paint material and solvent then mix - add the organic bentonite powder, stir with 10 minutes - add the polar active agent, stir 5 - 10 minutes - add surface active agent - add the pigment, stir and disperse to the needed granularity - dilute to the needed viscosity

    當使用表面活化劑以及分散顏料和攪拌下可發展觸變體系時，操作如下：溶劑和展色劑混合加入有機膨潤土粉末混合10分鐘加入極性活化劑攪拌5 - 10分鐘加入顏料攪拌分散至所需細度稀釋至所需粘度。
  14. 2 resin with bad wetness systems such as epoxy resin, polyester, alkyd, acrylic resin, operate as the following process : add the solvent - add organic bentonite powder mix and stir 10 minutes, wet enough - add the polar active agent mix and stir 5 - 10 minutes, make it swell and disperse - add resin and stir - add the surface active agent - add pigment, stir and disperse to the needed granularity - dilute to the needed viscosity main points for use methods

    2當使用潤濕性差的樹脂系統環氧，聚酯，短油酸樹脂，丙烯酸樹脂操作如下：加入溶劑混合加入有機膨潤土粉末攪拌混合10分鐘，使其完全潤濕加入極性活化劑攪拌混合5 - 10分鐘，使其膨脹，分散加入樹脂混合攪拌加入表面活化劑攪拌分散至所需細度稀釋至所需粘度。
分享友人
分享到 Line

分享到臉書