流通蒸汽 的英文怎麼說

中文拼音 [liútōngzhēngqì]
流通蒸汽 英文
flowing steam
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 通 : 通量詞（用於動作）
  • 蒸 : Ⅰ動詞1. （蒸發） evaporate2. （利用水蒸氣的熱力使食物熟或熱） steam Ⅱ名詞[中醫] （將藥物隔水蒸熟） steaming
  • 汽 : 名詞1. （由液體或某些固體變成的氣體） vapour2. （水蒸氣） steam
  • 流通 : circulate
  • 蒸汽 : vapour; reek; breath; steam蒸汽採暖 steam heating; 蒸汽錘 [機械工程] steam hammer; 蒸汽打樁鍾 ste...
  1. Bda is equipped with advanced facilities for international telecom, water, electricity, natural gas, steam, heat, and separate drainage systems for sewage and rainfall

    開發區建有高水平的國際通訊設施和水電天燃氣蒸汽熱源等管線站所及雨污分流的排水系統。
  2. The saturated densities, vapour pressures, and latent heats of vaporization for hfc working substances of refrigeration are calculated by using a set of general equations of thermophysical property of liquids

    摘要應用一套通用型流體熱物性方程對hfc類致冷工質的飽和密度、蒸汽壓和汽化潛熱進行計算。
  3. In order to improve the utilization efficiency of energy and equipment, a general steady simulation model of complex cross - feed multi - effect evaporation was established for the purpose of in - depth research on rule of multi - effect evaporation. in this model, the energy - saving measures, including extra steam being led off to preheat material liquid, the condensation water flash and solution flash, were adopted, and the solid separation was also considered in the process of evaporation

    為了提高多效蒸發系統能量與設備的利用效率以及深入研究多效蒸發過程的規律，建立了帶有冷凝水閃蒸、溶液閃蒸和引出額外蒸汽預熱原料液等節能措施並考慮蒸發過程有固相析出的復雜錯流多效蒸發穩態模擬通用模型。
  4. After researching the part thermal equipments and systems include heaters, steam leakage and receiving systems, low pressure drain system etc, and computing the efficiency of the systems, find out the better choice of the imported assemblies than the domestic assemblies in parameter and the disfigurements in design and making. based on the above, point out the measure to progress them. according to the analysis, we can get some measures to increase the economical level of the systems and save more energy

    對局部熱力設備及熱力系統進行分析研究，包括:加熱器設備、漏汽及回收系統、低加疏水系統、主、再熱蒸汽系統以及凝汽器等部位；並計算汽輪機本體高、中、低壓缸效率，藉此著重對汽輪機通流部分進行了剖析，找出國外進口機組動、靜葉柵、葉型的選擇比國產機組先進性以及國產機組在通流部分設計和製造中的諸多缺陷，並且指出了改進的方向，為機組提高熱經濟性、節能降耗奠定了理論基礎。
  5. Britain had many rivers, which were useful for transport but also for water and steam power. britain also had useful mineral resources

    英國許多河流不僅用於交通，還提供水力及蒸汽動力。英國還有可用的礦產資源。
  6. The steam path of the steam turbine through which steam flows consists of nozzles, and the moving blade, fixed blade and other auxiliary equipment

    汽輪機的通流部分即蒸汽流過並做功的部分，其中包括噴嘴，隔板以及動、靜葉片以及相應的汽封裝置。
  7. Through analyzing the effect of temperature and nitrogen on crude oil viscosity the influences of different nitrogen injection volume and injection modes on steam displacement are contrasted, the mechanism of nitrogen - assisted steam stimulation is clarified, which includes : heat carrying capacity is raised, the saturation of remaining oil is reduced after nitrogen - assisted injection is made ; crude oil flow is enhanced because of nitrogen compression and dispersion and the change of oil flow shape ; water back - production rate is improved by expanding the steam sweep volume and compensating in - situ energy ; steam distillation effect is enhanced

    通過分析溫度、氮氣對原油粘度的影響，對比不同注氮量、不同注入方式等對蒸汽驅油效果的影響，弄清了氮氣輔助蒸汽增產的機理主要表現在：氮氣輔助后增加攜熱能力，降低殘余油飽和度，氮氣的壓縮膨脹作用分散和改變了原油流動形態，增強了原油流動性；擴大蒸汽的波及體積，補充地層能量，提高回採水率，強化蒸汽蒸餾效應。
  8. In order to accurately calculate the available energy dissipation resulted from the steam flowing through a restrictive device, a new view point for measuring energy in steam piping network system has been put forward, i. e. a model for computing the available energy dissipation has been obtained through entropy equation in occurrence process of the resistance, which is deduced from steam condition equation of iapws - if97

    為了準確計算蒸汽流經阻力件產生的可用能損耗，提出了蒸汽管網系統能量計量的新觀點，即通過iapws - if97的蒸汽狀態方程，推導出阻力發生過程的熵方程，得到可用能損失計算模型。
  9. The second method is based on converting an interface estimated heat flux, which was obtained by using inverse heat conduction solution, to ammonia mass absorbed

    將該熱流通量值除以理論上單位質量的氨蒸汽發生吸收反應所放出的熱量值，即可得到氨蒸汽的吸收量。
  10. In order to size a stop - check the technical information needed is saturated steam gage pressure in pounds per square inch and actual required steam volume flow in pounds per hour

    為了確定正確的截止止回閥的通徑，需要下列有關的技術參數，飽和蒸汽表壓（磅/平方英寸） ，和實際所需的正氣流量（磅/小時） 。
  11. Material balance and energy balance equations of complex multi - effect evaporation system were expressed in matrix equation, which has the advantages of clear structure and high modularization. by holding or omitting correlation block - matrix in matrix equation, matrix equation could be used to describe the difference of forward - feed, back - feed and cross - reed multi - evaporation system with or without solid separation, extra steam being led off to preheat material liquid, condensation water flash, or solution flash. the models include design and operation

    該模型利用矩陣方程具有結構清晰和高度模塊化的特點，將復雜多效蒸發系統的物料及熱量衡算方程組以矩陣形式表達，通過保留或舍棄矩陣中特定功能模塊，模型就能代表有或無固相析出、有或無引出額外蒸汽預熱原料液、有或無冷凝水閃蒸、有或無溶液閃蒸等不同情況以及各種情況任意組合的併流、逆流、錯流多效蒸發過程，從而實現模型的通用性。
  12. The intelligent instrument module achieves the functions of collecting and processing hot network stream parameters, and offers multiple communication interfaces ; the communication module provides three communication ways of internet > pstnnwireless station to realize the function of central collecting and managing steam flow information ; the monitoring management module, which adopts advanced programming languages, performs the functions of data collection, exchange, disposal, query and report print and so on

    智能儀表模塊完成對熱網蒸汽參數的採集和處理功能，並提供多種通信介面；通信模塊提供internet 、 pstn 、無線數傳電臺三種通信方式，實現了蒸汽流量信息的集中採集及管理；監測管理模塊通過高級語言編程完成了數據採集、交換、處理、查詢及報表列印等功能。
  13. The steam flows through two large diameter ducts （ 2000 ） to the condenser. steam enters from this distribution manifold into the finned tubes at the top of the primary condensing bundles

    蒸汽通過1個大孔徑管道（ 2000 ）分為兩個管道（ 1600 ）流入凝汽器。蒸汽通過配汽集管進入一次冷凝管束頂部的翅片管道。
  14. By raising the temperature of the cylinder walls in this way, the outward flow of heat is greatly reduced

    通過這樣來給氣缸壁升溫，蒸汽熱量的向外流失大幅減少。
  15. According to bernoulli theorem, kinetic energy and potential energy change due to the thermokinetic differences of steam and conden sation water, and action valve plate starts and stops to choke air and drain water

    圓盤式疏水閥是根據伯努力熱動力原理，利用蒸汽和凝結水通過閥孔時流速和何種產生變化的不同熱力學性質，驅動閥片開關閥門，從而達到阻汽排水。
  16. Combining the simplified momentum equation, energy equation and state equation of compressible sticky fluid, this paper establishes the numerical model to study the heat - transfer property of the substances in super - critical waterwall tubes with the newest international water and steam standard - iapws - 97

    本文採用最新的國際水與水蒸汽標準iapws - 97 ，通過聯立求解簡化的可壓縮黏性流體的動量方程、能量方程和水與水蒸汽的狀態方程，建立數值模型研究超臨界水冷壁管內工質的傳熱特性。
  17. In this paper, we applied the vapor - liquid - solid three - phase circulating fluidized bed evaporator to condense glucose solution considering its advantage. in the experiment, we changed the parameters such as evaporation temperature, difference in temperature of the fluid heating and heated, liquid flux, liquid thickness and the ratio of inert particles to analyze and study this kind of equipment ' s heat transfer properties in different operational conditions

    通過改變蒸發溫度、傳熱溫差、料液流量、料液濃度以及惰性粒子的體積分率等參數，研究了其在不同操作條件下的傳熱性能，並給出了汽-液-固三相循環流化床蒸發器沸騰傳熱的數學模型，模型預測值與實驗值吻合較好。
  18. As a general rule, an adequately sized globe valve ( i. e. with pipe velocity between 15 to 25 ft / sec for water and 200 to 300 ft / sec for steam ) should not be throttled down below 35 % of its maximum full open cv capacity ( approximately 20 % of full stroke )

    一般而言，通徑足夠大的截止閥（例如管道內水流速度在15至25英尺/秒之間，蒸汽流速在200至300英尺/秒之間） ，節流后的流量不應該小於完全開啟狀態流量（流量系數大約為全沖程的20 % ）的35 %以下。
  19. The water then passes through steam generators to deliver heat to the secondary circuit. the steam generator produces steam on the secondary side to drive the turbine and generator

    產生的熱能，然後流入蒸汽發生器，通過熱交換，在二迴路產生蒸汽，以推動渦輪發電機，把熱能轉化為電力。
分享友人
分享到 Line

分享到臉書