浸水角 的英文怎麼說

中文拼音 [jìnshuǐjiǎo]
浸水角 英文
angle of flooding
  • 浸 : Ⅰ動詞1 （泡在液體里） soak; steep; immerse 2 （液體滲入） soak; saturate; steep Ⅱ副詞[書面語] （...
  • 水 : 名詞1 （由兩個氫原子和一個氧原子結合而成的液體） water 2 （河流） river 3 （指江、河、湖、海、洋...
  • 角 : 角Ⅰ名詞1 （牛、羊、 鹿等頭上長出的堅硬的東西） horn 2 （古時軍中吹的樂器） bugle; horn 3 （形狀像...
  • 浸水 : flooding
  1. Din931 - 933 hex head bolt g8. 8 hot - dip galvanized

    熱浸沿水公制六角頭螺絲
  2. Din934 hex nuts g8. 8 hot - dip galvanized

    熱浸沿水公制拉力六角螺絲母
  3. By summarizing and analyzing the geological setting, uranium source, paleoclimate, hydrology, lithologic - lithofacies conditions in the region, it is indicated that the quantou formation in fanjiatun - jiutai area and the qingshankou formation in yangdachenzi area are potential metallogenic prospective areas for in - situ leachable sandstone type uranium deposit in the region, which develop braided channel or delta marginal sandstones, and possess favorable forming conditions of interlayer oxidation zone, and constituting supply - passage - discharge system of abundant uranium source

    綜合研究區域成礦地質背景、鈾源、古氣候、水文地質、巖性巖相條件，認為范家屯九臺一帶的泉頭組及楊大城子一帶的青山口組發育辮狀河或三角洲前緣砂體，構成了鈾源供應充足的補徑排系統，具有有利的層間氧化帶形成條件，是本區地浸砂巖型鈾礦的有利成礦遠景區帶。
  4. The hydrothermal breccia and karst in the beiya area are divided into 4 types and zones, including : sedimentary tuff and breccia induced by hydrothermal explosion and sedimentation on land surface ; hydrothermal sedimentary conglomerate and gas - explosive ejecting breccia related to sedimentation in and collapsing of some shallow karst caves ; netted hydotherma1 limcstone breccia and hydrothermal explosive breccia pipe related to hydrofracturing, corrosion and explosion in the hydrothermal channels ; and yellow granular limestone formed by simmering and alteration in the deep heated water reservoir

    北衙地區熱水角礫巖和熱水巖溶可分為4種類型和層次，即地表相爆發沉積作用形成的沉積凝灰角礫巖、熱水沉積鮞狀灰巖與鈣華膠結角礫巖；與近地表洞穴沉積和垮塌作用有關的熱水沉積礫巖和汽爆射流角礫巖；與熱水通道相蝕裂和爆破角礫化作用有關的網路狀灰巖角礫巖筒和熱水隱爆角礫巖筒；深部相熱水浸煮蝕變灰巖。
  5. For bacterial leaf spots, the classical symptoms are circular, angular, watersoaked areas on the leaves.

    細菌性葉斑病的典型癥狀是葉子上出現圓斑、角斑或水浸狀葉面。
  6. They then undergo a full body exfoliation and a soak in a 300 - jet spa tub before being sprayed down with a high - pressure hose used for lymphatic drainage, the newspaper said

    報紙報導，顧客先接受全身去角質，浸泡在有300噴射管的水療池內，再用具淋巴排毒效果的高壓水管噴?全身。
  7. Conclusion cck contained in the treated chicken calamus easily undergoes hydrolysis to release mainly some peptides which do not induce obvious toxic effects, suggesting the safe potential applications of cck conduit as a tissue - engineering biometerial

    結論雞羽根角蛋白管可被水解，釋放一些肽類物質，其浸提液對皮膚無致敏作用，皮內刺激反應弱，不引起全身急性毒性癥狀，無細胞毒性。
  8. In the macroscopical field : ( 1 ) the relationship between the moisture and the speed of average collapse was attained, that is, the speed of average collapse will increase with increasing of the moisture at first, but it will decrease when the value get to certain max with increasing of the moisture ; ( 2 ) the model of relationship between the pressure and the speed of average collapse was established on the basis of experiment. the conclusion of that the speed of average collapse bouncing increase with increasing of the pressure was attained and the relationship between stress and distortion was established ; ( 3 ) the method of synthetical evaluation for collapsibility loess under the effect of time, pressure and moisture was offered

    在宏觀角度上： （ 1 ）以遼寧阜新地區黃土試樣的固結試驗數據為分析對象，得到了黃土濕陷速率與含水量的關系曲線呈單峰狀態的結論，即黃土濕陷速率在土體浸水初期會隨著含水量的增加而增大，但當含水量超過某一數值趨于飽和含水量時，黃土濕陷速率卻隨著含水量的增加而減小； （ 2 ）立了黃土濕陷速率與壓力之間關系的數學模型，得出了黃土濕陷速率隨壓力的增大而呈階越增長的結論以及阜新地區濕陷性黃土的本構關系； （ 3 ）提供了在時間、含水量及壓力等因素共同作用下，對黃土濕陷性進行綜合評價的方法。
  9. A lot of indoor and in - suti test to the properties of the chemical grouting material, especially the properties requested by actual engineering has proceeded. active - diluent of furfural - acetone, low poison hardener. surfactant and a series of formula have been selected by experiment. cw series material has low glue degree, time last of it harden can be adjust, surface tension and contact angle of the material is low

    對漿材性能特別是工程實際對漿材要求的性能進行了大量室內、現場試驗測試，選擇性能優良的糠醛?丙酮活性稀釋劑、低毒憎水性固化劑、表面活性劑及系列漿材配比， cw系漿液粘度、固化時間大范圍可調、表面張力及接觸角小、漿材固化及固結強度高，具有優良的浸潤性能和工藝性能。
  10. Detailed predictions on the fluid flow in mold and in cavity of nozzle working end were obtained at different side - hole angle and submerged depth of nozzles, and then the flux variation of liquid steel passing through central hole of the three - hole nozzle and the fluctuation of liquid steel in mold were inspected based on above predictions

    針對3孔浸入式水口不同側孔傾角和浸入深度，數值模擬對結晶器內鋼水流動做出了較為詳細的預報，研究工作就此分別考察了水口中心孔流量變化和鋼水液面波動幅度。
分享友人
分享到 Line

分享到臉書