浸液電極 的英文怎麼說

中文拼音 [jìndiàn]
浸液電極 英文
dipped electrode
  • : Ⅰ動詞1 (泡在液體里) soak; steep; immerse 2 (液體滲入) soak; saturate; steep Ⅱ副詞[書面語] (...
  • : 名詞(液體) liquid; fluid; juice
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電極 : electrode; pole
  1. First, a simple discussion for the mechanism about electrostatic atomization of the liquids has been given ; then the paper theoretically analyzed waving course, liquid drop producing course, and the liquid drop diffusing course in electrostatics atomization process., gave an analysis about the methods about carrying charges to the liquid drop, and analyzed that liquid with high electrical conductivity can be carried charges and atomized by electric field, while the isolated liquid with low electrical conductivity can be charged fully with the soakage electrode and inducing charge methods. at last the paper designed and configured the experimental equipment, conducted the atomization experiment to the three liquid medium - kerosene, emulsifier and alcohol under the same environment, handled the experimental results, then summarized the relationship between liquid electrostatic atomization effect and liquid surface tension, electronic conductivity and viscosity, along with the influence of voltage to electrostatic atomization and so on, found out the liquid atomization rule in high voltage electrostatic field

    首先,對體介質的靜霧化機理作了初步的探討,理論上分析了體霧化過程中射流區、波紋區、霧滴區和霧滴擴散區;然後對體荷方法進行了研究分析,對于高導率的體,場致荷和接觸荷可以使其霧化,而對于導率較低的絕緣體,需用和感應荷方法使其充分帶;最後,根據前面的研究分析,設計和組裝試驗裝置,在同一環境下對煤油、乳化劑、酒精三種不同體介質進行高壓靜霧化試驗,並對試驗結果進行分析處理,總結出體靜霧化與體表面張力、導率和粘度的關系及壓對體靜霧化的影響等,得出高壓靜場中體霧化的一般規律。
  2. Measurement in cobalt of ni - cd battery anode praegnating solution by air - c2h2 atomic absorption spectrometry

    2原子吸收光譜法測定鎘鎳池正中鈷含量
  3. The effect of composition of coating solution, dipping time and other technical parameters for preparation of sensors on sensing behaviour has also been described and discussed

    討論了溶組成,漬時間等元件制備工藝參數對響應特性的影響。發現結構對于元件響應特性有一定影響。
  4. A disposable battery consists of two electrodes, an anode and a cathode, bathed in an electrolyte solution

    拋棄式池有兩個,分別是陽和陰,都泡在解質溶中。
  5. ( 2 ) two methods including one - step and two - step methods were used to modify the platinum electrode. in the two - step method, the experiment conditions were confirmed, namely after modified by nafion film, the electrode was dipped in saturated solution of co ( salen ) for 24h. the electric current would decrease if the dipping time were too long

    2 .用兩科,方法對進行co ( salen ) / nafion修飾,即「一步法」和「兩步法」 ,對「兩步法」的實驗條件進行了選擇,即將表面先修飾好nafion膜后,再泡在co ( sa1en )飽和溶中24h即可,時間再長則峰流反而會減小。
分享友人