混合冗餘 的英文怎麼說

中文拼音 [húngěrǒngyú]
混合冗餘 英文
hybrid redundancy
  • 混 : 混形容詞1. （渾濁） muddy; turbid2. （糊塗; 不明事理） foolish; stupid
  • 合 : 合量詞（容量單位） ge, a unit of dry measure for grain （=1 decilitre）
  • 冗 : [書面語]Ⅰ形容詞1. （多餘的） superfluous; redundant 2. （煩瑣） full of trivial detailsⅡ名詞（繁忙的事） business
  • 餘 : Ⅰ同「余」Ⅰ-Ⅳ1. Ⅱ名詞（姓氏） a surname
  • 混合 : （攙雜在一起） mix; blend; mingle; admix; mixture; mix up; interfusion; commixture; blending; cre...
  • 冗餘 : redundance; redundancy冗餘校驗 redundancy check; redundant check; 冗餘碼 redundant code; redundan...
  1. We investigated the architectures of three typical computer fault - tolerant systems such as triple modular admixture redundancy system, buildup dual computer comparing system and dual computer comparing system with hot standby, and descript them with the markov model. the reliability and safety model of these fault - tolerant systems are acquired through theoretical analyzing and calculating. with analyzing, we defined the systems " task interval available time section in reason, compared their reliability and safety and evaluated their reliabilities

    具體針對三模混合冗餘、增強型雙機比較及帶熱備份的雙機比較三種典型體系結構的計算機容錯系統進行了研究，統一用馬爾可夫模型進行描述，通過理論分析和計算，獲得各體系結構容錯系統的可靠度與安全度的數學模型；通過分析，合理定義了系統的任務工作期區間，並在此區間上比較分析了各體系結構容錯系統的可靠度與安全度情況，從而對各系統的可靠性指標進行了評價；根據上述三種系統的數學模型，在考慮系統故障覆蓋率與維修率兩個參數對系統可靠度與安全度影響的情況下，用matlab語言編制了計算機模擬程序。
  2. Then, based on real - time operation system ertos and architecture put forward above, a dual fault - tolerant system is realized. furthermore, this thesis discusses the theoretical foundation, model structure, composing form and evaluation in detail, investigates the architectures of three computer fault - tolerant systems, such as triple modular admixture redundancy system,

    此外，論文對計算機容錯系統的理論基礎、模型結構、組成方法以及評價過程作了詳細的論述，並具體針對三模混合冗餘、帶熱備份的雙機系統和本文設計的雙機容錯系統，用馬爾可夫模型進行描述和可靠度模擬。
  3. This dissertation summarizes the method to select parameters of chirp - subpulse stepped frequency signal, presents a method to resolve profile aliasing and redundance in chirp - subpulse stepped frequency signal by the target pick - up algorithm and selecting parameters

    文中總結了chirp子脈沖頻率步進信號參數選取的方法，提出了採用參數選取和目標抽取相結合的方法來解決chirp子脈沖頻率步進信號中距離像的混疊和冗餘問題。
  4. 5. lastly, we analyzed the redundancy design of the core layer and the distributing layer of industrial ethernet and provided the schemes of redundancy design. at the same time, we discussed the pattern design of industrial ethernet, provided the ideal system design of industrial ethernet and pointed out the new direction - hybrid system of industrial ethernet in the future

    5 、分析了工業以太網的核心層和分佈層的冗餘設計，並給出各種冗餘設浙江人學碩士學位論文計方案；研究了工業以太網的系統設計，提出了理想的工業以太網解決方案，並指出未來一段時間內的發展方向? ?混合型系統。
分享友人
分享到 Line

分享到臉書