渦流誤差 的英文怎麼說

中文拼音 [guōliúchā]
渦流誤差 英文
eddy error
  • : 渦名詞1. (漩渦) eddy; whirlpool; vortex 2. (酒窩) dimple
  • : Ⅰ動1 (液體移動; 流動) flow 2 (移動不定) drift; move; wander 3 (流傳; 傳播) spread 4 (向壞...
  • : Ⅰ名詞(錯誤) mistake; error Ⅱ動詞1 (弄錯) mistake; misunderstand 2 (耽誤) miss 3 (使受損害...
  • : 差Ⅰ名詞1 (不相同; 不相合) difference; dissimilarity 2 (差錯) mistake 3 [數學] (差數) differ...
  • 誤差 : error
  1. Measurement method of the error of signal amplitute for eddy current flaw detector

    探傷信號幅度測量方法
  2. We can use the mm5 model in definite time, definite area weather forecasting. we conclude that : : the moving route of this necw in its developing progress was direct - south along latitude, the cold air is rough, and just this made the rough vertical velocity ; the necw southern moving and conflicting with the west pacification sub - tropical high makes rough jet steam. the plenty south - west warm and wet air made by the jet stream gave the rainstorm demanded vapor ;. the rough vertical velocity by jet stream is a main reason in this rainstorm ; the mm5 model uses four - direction analysis data as its input, this avoids some errors occurred in observe and transfer, thus made the result more useful

    綜合分析認為: ( 1 ) 、這次冷在其發生發展過程中,其移動路徑是沿經圈直線南壓,攜帶的冷空氣勢力較強,形成槽后較強的垂直運動; ( 2 ) 、西太平洋副熱帶高壓偏北位置與東北冷南壓形成的急軸,把源源不斷的西南暖濕氣輸送到遼西地區,也就是急軸的左前方位置,為這次暴雨的產生提供了充足的水汽來源; ( 3 ) 、低空急不但為暴雨輸送水汽,其造成的較強的垂直環也是產生強降水的一個主要原因; ( 4 ) 、 mm5模式以四維同化資料作為初始場,最大限度地避免了觀測可能造成的積分不穩定,提高了模擬結果的參考價值。
  3. The errors in measuring system consisting of two sensors are examined, at the same time a method of eliminating the errors is introduced

    分析了所採用的電傳感器位移測量系統出現的來源,並提出了消除的方法。
  4. The paper researches the vortex moment caused by the shape and locality error of one hole in the sphere socket. by analyzing and comparing the result we can find the method to decrease the vortex moment

    本課題只研究球窩其中的一個節孔的形狀和位置所引起的力矩,通過分析比較計算結果,從而找到減小力矩的方法。
  5. In order to validate the correctness of the simulation, the flow velocity of x vector is measured to compare the flow field between the simulation and the experiment in wind tunnel. the results indicate that the flow field is improved and more stable than the original shield flow field. the tendency between the improved shield and the original shield from simulation is consistent with the tendency from experiments

    開口罩蓋場由於相對穩定,模擬和試驗的測點速平均相對為15 ,未開口罩蓋場中由於影響較大,平均相對為22 . 45 ;同時驗證了結構改進前後罩蓋場的模擬比較結果和試驗比較結果的趨勢是一致的。
  6. In this article we use a bp neural network to classify the eddy current signal and its result is also presented, which indicate that artificial neural network has vast potential in eddy current signal processing

    本文選用基於反向傳播( bp )演算法的神經網路對信號分類,並給出分類結果,表明了神經網路在材質檢測信號處理中應用的巨大潛力。
  7. In this subject, a new method and technique that applied the error separation theory to test of the surface flaw of axis - like parts using eddy current is proposed for the first time. based on this method, a mathematical model of extracting the surface flaw of axis - like parts is established. then " an automation system for the eddy current examination of the surface flaw of axletree " is designed

    本課題首次應用分離理論提出了對軸(孔)類工件表面缺陷進行無損檢測的新方法和新技術,建立了基於該方法的提取軸(孔)類工件表面缺陷的數學模型,並設計了「軸承滾子表面缺陷自動化檢測系統」 。
  8. The vortex moment of gas spherical bearing is caused by the uneven gas film between the sphere and the sphere socket. there are two reasons to produce the uneven film. the first one is the manufacture error

    靜壓氣浮球軸承的力矩主要是由於空氣軸承的球體和球窩之間的氣膜厚度不均所引起的,引起氣膜厚度不均的主要因素有兩個:一是由於球和球窩的加工,二是由於氣浮臺臺體變形引起的
  9. Some methods for overcoming these disadvantages are investigated as follows : first, using shield and magnetic circuit to shorten the sensor length and enhance the signal magnitude ; second, improving the data acquisition system to intensify the capability of fine defect detection ; at last, adopting digital signal processing technology such as homomorphic filter, wavelet transform and error correction to ensure detecting reliability

    本文結合有限元模擬和實驗方法,研究了改進遠場技術性能的幾種方法,即:採用電磁屏蔽、磁路進行傳感器優化設計以縮短探頭長度、增大信號強度;改進信號調理電路以提高細微缺陷檢出能力;利用同態濾波、小波變換以及修正等數字信號處理技術確保檢測結果的可靠性。
  10. The paper proves that in the 2d non - linear case, the coulomb gauge is been meet naturally. in the paper, the second - order isoparametric fem is adopted in the non - linear transient magnetic field simulating excited by current source and the results of transient field and static field solved by the second - order isoparametric and linear fem are compared and analyzed, besides, the effect of the eddy currents in the magnetic materials of the different conductivity is analyzed, it is obtained that the magnetic material of high magnetic conductivity and low loss should be chosen in designing of pma

    文中採用二次等參元有限元法推導出在電源激磁下的非線性瞬態磁場的計算方法和編制了相應的計算程序,並採用二次等參元有限元法和雙線性有限元法分別對瞬態場和靜態場進行了計算,並對計算結果進行了分析,此外,還對不同電導率的導磁材料中產生的影響進行了分析,得到結論設計永磁操動機構時,應選擇導磁性能好,損耗低的導磁材料。
  11. The assemble criterion of sensor for design was advanced. at last, a method of increasing signal - to - noise ratio and reducing flux lower limit value of vortex flowmeter was advanced. the experiment program was advanced

    針對旋進旋量計的理論分析所存在的問題,論文應用fluent軟體對該量計進行了直接場模擬研究,分析模擬的結果和,並提出了改善模擬精度的途徑。
  12. 5 ) the atmospheric noise of interferogram is a fractal process, whose spatial spectrum exhibits the characteristic - 8 / 3 powder law behavior associated with turbulence phenomena. the effects of this 1 / / process to insar dem were anylysised and the error power of noise and atmospheric term were estimated for weighted combination of multi - temporal insar data. the test results showed this data fusion process can improve the accuracy of insar dem

    引i 』涉圖的大氣噪聲為一分形過程,其空間譜表現為與現象有關的8 3冪函數特性, l人氣過程和噪聲對利用干涉數據提取的dem精度有很大影響,利用不同時相的dem ,在小波域中估計大氣和噪聲的功率,並在此基礎上對dem進行了權重融合,實驗結果證明,此數據融合方法可以很好的提高幹涉sar所提取的dem的精度。
分享友人