渦熱流通量 的英文怎麼說

中文拼音 [guōrèliútōngliáng]
渦熱流通量 英文
eddy heat flux
  • 渦 : 渦名詞1. （漩渦） eddy; whirlpool; vortex 2. （酒窩） dimple
  • 流 : Ⅰ動1 （液體移動; 流動） flow 2 （移動不定） drift; move; wander 3 （流傳; 傳播） spread 4 （向壞...
  • 通 : 通量詞（用於動作）
  • 量 : 量動1. （度量） measure 2. （估量） estimate; size up
  • 熱流 : 1 （激動振奮的感受） warm current 2 [氣象學] thermal current; [熱學] heat transmission; thermal f...
  • 通量 : [物理學] flux; shower
  1. Through the special studies on impacts to atomizing and humidifying effect from such factors as the firing pin type, centrifugal structure, higher spraying pressure, less aperture, initial water temperature and original state of the air, some conclusions are obtained, such as : the centrifugal nozzle with firing pin type, high pressure and little aperture has bigger air eddy and atomizing angle. the spaying liquid has high velocity. the droplet is small, and the heat and mass transfer velocity is high

    通過對撞針型結構、離心式結構、較高的噴水壓力、較小的噴嘴孔徑、噴水初溫及待加濕空氣初狀態對霧化加濕效果的作用原理的重點分析，得到：撞針型高壓小孔徑離心式噴嘴具有較大的空氣渦與霧化角，噴出的液體流速高、液滴小、水與空氣傳熱傳質速率高，撞針型結構提高了霧化加濕效率，高壓小孔徑的特點為霧化加濕提供了較大的能量，而噴水初溫的升高會減小水的粘性力和表面張力，從而優化加濕效果。
  2. Based on the exhaust heat data of the iurbine ( 6160a - 12 ) and the micro gas turbine produced in japan, parameters of test - bed such as deferent thermal flow temperature and pressure are defined by the calculation of design parameter in method of combined theory and experience data

    以柴油機（ 6160a - 12 ）和日本的微型燃氣渦輪機尾氣參數為設計基礎，通過理論和經驗數據相結合的方法進行設計參數計算，確定了模擬實驗臺熱流量、出口溫度及壓力等參數。
  3. On the basis of the reptured tube at the final superheater of no. 4 boiler in yangluo power plant, the " tee junction effect " of terminal header on flux distribution in superheater was analysed, a mathematical model was founded to calculate the tube temperature and evaluate the lifespan of superheater and some measures to prevent eddy current in the area near the tee junction were put forward

    摘要分析了進口等徑三通對過熱器管流量分配的影響，建立了過熱器壁溫計算模型，並以華能陽邏電廠4號爐高溫過熱器爆管為例，對渦流效應的大小進行了分析，提出了消除渦流效應的措施。
  4. A three - dimension baroclinic prognostic model on the o - coordinate is established based on pom to simulate the wintertime circulation and the eddies in the east china seas, considering the topography, inflow and outflow on the open boundary, yangtse runoff, heat flux and wind stress on the sea surface

    本文在pom模式基礎上，建立一個坐標系下的三維斜壓預報模式，考慮了海底地形、外來流、長江徑流、海面風應力、海面熱通量等多方面因素的影響，模擬結果較好地體現了冬季東中國海環流及渦旋的特徵。
分享友人
分享到 Line

分享到臉書