源電極 的英文怎麼說

中文拼音 [yuándiàn]
源電極 英文
source electrode
  • : 名詞1. (水流起頭的地方) source (of a river); fountainhead 2. (來源) source; cause 3. (姓氏) a surname
  • : Ⅰ名詞1 (有電荷存在和電荷變化的現象) electricity 2 (電報) telegram; cable Ⅱ動詞1 (觸電) give...
  • : i 名詞1 (頂點; 盡頭) the utmost point; extreme 2 (地球的南北兩端; 磁體的兩端; 電源或電器上電流...
  • 電極 : electrode; pole
  1. Secondly, we make an in - depth study and analysis in allusion to the given oscillatory circuit - butler common base harmonic circuit. the detailed analysis of the dynatron which is the main noise source in the oscillatory circuit is also made, including how excitation affects the dynatron and crystal

    然後針對特定的振蕩路結構-串聯型巴特勒共基振蕩路-進行深入的研究和分析,並對主振路中主要的噪聲-三體進行的深入分析,包括激勵對三體及晶體的影響。
  2. The factors limiting the frequency band of the wide - band amplifier are introduced. through analyzing the effects of the intrinsic parameters and parasitical on the frequency characteristics, a method of improving fr of mosfet by using short channel device and making mosfet work at the saturation region through raising vgs is put forward ; the effects of different kinds of circuit configurations on the frequency characteristics and the junction voltage on the voltage pattern circuit, current pattern circuit and frequency characteristics are analyzed. according to the linear theory of transconductance which is applied in the bit circuit, the current pattern amplifier circuit, current transfer circuit and output circuit which consist of mosfet and the wide - band amplifier composed of them are put forward

    介紹了限制寬帶放大器頻帶寬度的因素,通過分析mosfet的本徵參數、寄生參數對頻率特性的影響,提出了採用短溝器件、使mosfet工作在飽和區、抬高柵壓等提高mosfet特徵頻率的方法;分析了不同路組態對放大器頻率特性的影響、節點壓對壓模路、流模路頻率特性的不同影響,根據應用於雙晶體管路的跨導線性原理,提出了採用mosfet構成的流模放大路、流傳輸路、輸出路以及由它們所組成的寬帶放大器,獲得了良好的頻率響應。
  3. First, passive resistance network was selected as direct current biasing network, which offered direct voltage for base through the resistance voltage divider composed of two resistances, among them the upper resistance connected from the dc to base, the lower resistance connected from the base to ground. the collector connected with dc directly

    直流偏置網路採用無阻網路,通過由兩個阻組成的阻分壓器為基提供直流壓,上偏阻從串聯到基,下偏阻從基到地,集直接加
  4. If we can find a way to artificially enhance the adsorption of activated carbon, its benefits on economy and environment will be considerable. it is the aim of this work to investigate electrosorption of chloroform in water on granular activated carbon. the potentials on working electrode are controlled by potentiostat and the concentration of chloroform is measured by headspace gas chromatography

    實驗用恆位儀作控制,調節工作位(相對于參比位)來控制加在活性炭上的場,用頂空進樣法測定水中氯仿的剩餘濃度,參照方法與依據都是國家標準方法或國外先進方法。
  5. Development of sunist electrode discharge power supply based on igbt

    的研究
  6. Although many achievements have been acquired in oled structure material, production technology, drive methods, oled technology is just at the beginning, oled has given an equal chance for every company and country, and it is very important for our country to develop displaying technology of our own. the research direction of oled is managing to improve the device lifetime, at the same time found a perfect production technological flow and the global standard production mode. it is still a arduous mission that we want to live up to a batch production of oled displays in the future some years. active matrix organic light emitting diode ( am - oled ) adopts a circuit structure based on matrix addressing, and its driving circuit includes pixel driving circuit and peripheral driving circuit

    在文中,首先,分析和研究了有oled的像素驅動路,闡述了amoled顯示屏及其周邊驅動路的結構和原理;其次,提出了qvga解析度的有oled顯示屏列數據引線的分塊( block )方法,確定屏上驅動路所需要的控制信號之間時序關系和幅值要求;最後,以fpga控制器的設計為核心,對外圍控制ic進行了具體設計,建立控制器路模塊模型和演算法流程,通過quartus軟體對其內部的各個路模塊進行綜合設計和模擬,得到了正確的模擬波形,完成了解析度為qvga ( 320 3 240 )的amoled專用驅動路的設計。
  7. The research and development of chemical power sources, zinc - based and nickel - zinc batteries was reviewed. the shape change, dendrite formation, corrosion and passivation of the rechargeable zinc electrode and the ways to solve the above problems were discussed as well

    本文全面概述了化學的發展,鋅基池的現狀以及鋅鎳池的發展狀況,分析了可充鋅存在的變形、枝晶、腐蝕與鈍化的原因及其解決途徑。
  8. The plug - in cards provide dual form - c relays, quad form - a, or either quad sinking or quad sourcing open collector logic outputs

    插入式插件提供兩芯form - c繼器5a四芯form - a繼器3a或者陷流和流集開路邏輯輸出。
  9. It is believed that p - si tft will be the main type in the future panel display. among the process of manufacture p - si tft, the source and drain will have the superposition with grid for the reason of machine ’ s alignment error. the superposition will bring superposition capacitance and it will badly cut down the electric performance

    在制備多晶硅tft時,由於機器的套準誤差會在柵、漏之間產生重疊部分,這樣就造成了柵、柵漏之間的交疊容,交疊容的存在嚴重影響了多晶硅tft的性能,而利用自對準工藝制備的多晶硅tft則避免了交疊容的產生。
  10. As the experiment results show, multiple reasons led to the offset of oscillating frequency, including diode ’ s nonlinear characteristic, fluctuation of electrical source voltage, traction of load impedance, change of environmental temperature and humidity and the design of circuit

    實驗結果表明多種因素引起了振蕩頻率的偏移,包括二體的非線性、壓的波動、負載的牽引、環境溫度濕度變化以及路板設計方面的因素等。
  11. Total savings include lower power bills and a commensurate drop in green house gas emissions from coal - fired power stations, net savings on coke and coal usage and a longer electrode life span

    這項技術帶來的節約包括:更低的能賬單、減少等同於一個火力發站的溫室氣體排放量、煤炭使用量的直接減少和更長的使用壽命。
  12. Electrodes inside each end of the glass tube are connected to a high-voltage source.

    玻璃管兩端內側的與一個高壓相接。
  13. Standard test method for dielectric breakdown voltage of insulating oils of petroleum origin using vde electrodes

    用vde測量自石油的絕緣油介擊穿壓的標準試驗方法
  14. In order to eliminate the influences caused by temperature, electrode - polarization and autoeciousness - capacitance, the traditional instrument has added complicated circuits so that it cause such shortcomings as big error, time - retardation and a relatively small scope. through the problems caused by 2 - probe electrode and ac current source, a new measuring circuit based on the excitation of bi - directional voltage pulse and the sensor of 4 - probe electrode is proposed, using single - chip to achieve auto - temperature compensation

    作者在參閱國內外大量相關參考文獻的基礎上,從導測試技術的原理性研究出發,分析了採用交流激勵、兩為傳感器的傳統導測試系統所面臨的種種問題,提出並研製了一種基於雙性脈沖壓激勵、以四為探頭、運用單片機進行溫度自動補償的新型導率測量系統。
  15. By comparison of dielectric constant at low frequency with that at optical frequency, it proves that the dielectric polarization of a - c : f films mainly comes from the electron polarization

    根據低頻和光頻介常數的比較,發現- c : f薄膜的介化主要來化。
  16. Positive electrode and negative electrode that execute spanning crack prevention are simulated as the source point and merged point, so the temperature field owing to the concentration of current around the crack tip is educed at the moment when the current is switch on

    將實施跨越止裂時的正、負比擬為流場中的和匯,從而導出了在瞬間流作用下,裂紋尖端附近區域因繞流而形成的溫度場。
  17. So the peripheral parts are not need any more, which makes the unit simplified. the design of active electrodes, moving the amplifier to the front electrode, simplifies the central unit further

    同時有源電極的設計令放大路前移以及採用了其他微型元器件(穩壓晶元、平轉換器等)進一步使中心處理單元微型化。
  18. This paper describes a reconstructive algorithm which is based on network theory for electrical capacitance tomography technic. there are twelve electrodes in the system. the permittivity distribution of flow with two components within a pipeline is reconstructed. assume the permittivity distribution of the region to be reconstructed. then whole measured area is discretized into a network composed of capacitance. the measurement circuit which contains a pair of source electrode and detecting electrode is taken as a four - terminal network. the across admittance of the four - teminal network is proportional to the capacitance between the source electrode and the detecting electrode. modify the distribution of the permittivity according to the difference between the calculated capacitance and measured capacitance. the experimental results show that this algorithm is effective and can coverge

    本文描述了一種用於兩種成份的流體成像的12容層析成像新方法.該方法基於路的網路理論,首先對重建區域假定一個介率分佈,用容網路作為離散化模型,將每一個源電極和探測對組成的測量路看作一個四端網路,該四端網路的跨導與源電極和探測之間的容值是線性關系,這個容值和測量得到的容值之間存在誤差,根據這個誤差對修正介率分佈.通過對不同介質分佈作的模擬實驗結果,證實了該演算法是有效的,收斂的
  19. Research on the designing of active electrodes has not been carried out yet in china

    對于有源電極,目前在國內還沒有相關的研究。
  20. By designing of active electrodes, the quality of the signal is improved effectively

    本設計採用有源電極的設計方法有效地提高了信號的質量。
分享友人