滑轉 的英文怎麼說

中文拼音 [gǔzhuǎn]
滑轉 英文
skid turn
  • 滑 : Ⅰ形容詞1 （光滑; 滑溜） slippery; smooth 2 （油滑; 狡詐） cunning; crafty; slippery Ⅱ動詞（貼著物...
  • 轉 : 轉構詞成分。
  1. Repair of the slip ring on the alternator rotor

    交流發電機轉子滑環的修復
  2. Djs use cross fader to achieve a seamless transfer of sounds

    音樂節目主持人用平滑轉換機來達成天衣無縫的聲音轉換效果。
  3. The degrees of crystallinity of pure ptfe under the different conditions of water cooling, air cooling and furnace - varying cooling were made comparison by xrd. the thermal stability of pure ptfe and solid lubricant was analyzed by dsc - tg ; the composition and valence state of elements in the surface of carbon fiber, solid lubricant before and after friction test and lubricant transfer film were characterized by xps ; the frictional property of solid lubricant was tested by pin and disk test rig. the frictional wear property of solid lubricant between embedded bearing sleeve and steel axle friction pair ring was tested by special simulate test machine, the hardness of solid lubricant was tested by pm ; the compression strength of solid lubricant was tested by material test machine

    用sem表徵原料微觀結構、摩擦表面及潤滑轉移膜表面形貌：用xrd進行原料物相分析，及比較水冷卻、空氣冷卻、隨爐冷卻三種工藝條件下的純聚四氟乙烯樹脂的結晶度；用dsc - tg分析純聚四氟乙烯樹脂及固體潤滑劑的熱穩定性；用xps表徵碳纖維表面、固體潤滑劑摩擦前後表面、潤滑轉移膜表面的元素組成、價態變化；用銷盤式摩擦磨損試驗機對固體潤滑劑進行摩擦性能測試；採用專用的臺架模擬試驗機對固體潤滑劑鑲嵌軸承套與鋼軸摩擦副間的摩擦磨損性能進行測定；用萊次偏光顯微鏡（ pm ）測試固體潤滑劑的硬度；用材料試驗機測試固體潤滑劑的抗壓強度等。
  4. The results indicated that the dimension, shape and purity of base material could meet the functional demand of solid lubricant ; the thermal decomposition temperature of ptfe resin exceeds 400 c, but organic and inorganic packing filler added in ptfe made the water absorption rate of composite material increased, melting temperature and decomposition temperature decreased, in the meanwhile oxidative decomposition reaction was accompanied ; polar groups such as c = o, c - o - c and so on in the carbon fiber surface is advantageous to increase compatibility with other components and interlayer shearing strength ; uniform design experimental method could help to find the relationship between formula and frictional property by relatively small tests. the developing trend of each formula ' s friction coefficient could be showed by fitting curve ; the friction coefficient with no copper powder or graphite in formula was relatively big. this fact showed that copper powder and graphite should be used cooperatively ; it was found that when the ratio of copper powder to graphite by weight is 15 : 60, 30 : 30 - 40 and 60 : 15 - 30 respectively, the friction coefficient was relatively small. the degree of crystallinity of pure ptfe reached maximum by air cooling and the abrasion loss also reached maximum among three ones ; at the same time, the abrasion loss of solid lubricant sample was also the biggest among three ones ; when solid lubricant matched with 45 # steel axle or gcrl5 steel axle, lubricant transfer film could be formed on metal surface, thus direct contact between the surface of metal friction pair rings was reduced. their working life was elongated extremely ; there was mainly much graphite, a little ptff, moo3, feso4, cus and so on in lubricant transfer film

    試驗結果表明：所選原料的尺寸、形狀及純度可滿足固體潤滑劑的性能要求；聚四氟乙烯樹脂熱分解溫度超過400 ，但在ptfe中加入無機填料會使復合材料吸水率提高，熔融溫度及分解溫度降低，且伴有氧化分解反應；碳纖維表面含有c = o及c - o - c等極性基團，有利於提高其與其它組分的相容性，提高層間剪切強度；均勻設計試驗方法能夠用較少的試驗次數找出配方與摩擦性能間的關系，擬合曲線基本能表示各配方的摩擦系數發展趨勢；配方中不加銅粉或不加石墨，其摩擦系數均較高，說明銅粉和石墨應該配合使用；當銅粉15份、石墨60份時，銅粉30份、石墨30 - 40份時，銅粉60 、石墨15 - 30份時，摩擦系數均具有較低值；純聚四氟乙烯樹脂在空氣冷卻時結晶度最大，磨損量也是三者中最大的；同時，固體潤滑劑試樣在空氣冷卻時的磨損量也是三者中最大的：不論是固體潤滑劑與45 #鋼軸配副或是固體潤滑劑鑲嵌入銅套后與gcr15鋼軸配副，在金屬表面均可形成潤滑轉移膜，從而減少金屬摩擦副表面間的直接接觸，大大延長其使用壽命;轉移膜中主要含有較多的石墨、少量聚四氟乙烯、 moo 。
  5. The slide rate of driving wheel of the tractor and the shift of land wheel of the seeder are closely related to the quality of seeding

    拖拉機驅動輪滑轉率和播種機地輪滑移率是與播種質量密切相關的內容。
  6. Based on the confirmation of driving force of lunar rover, we analyze the relationship between adhesion coefficient of road surface and wheel slip. in our research, several types of wheel force model are referenced among them, and we select the polynomial model with exponential function as the wheel force model of the lunar rover

    圍繞月球車驅動力的確定，本文分析了路面附著系數與滑轉率的關系，以車輛動力學分析中常用的幾種車輪力模型為基礎，選擇了帶有指數函數的多項式模型作為分析月球車車輪附著力的模型。
  7. On the base of kinematics analysis and the relationship of adhesion coefficient of road surface and wheel slip. this paper give a simulation to a single wheel, to show the kinematics characteristics of the wheel in case of fixed torque and fixed wheel slip, and get a conclusion that wheel slip has great influence on kinematics characteristics of lunar rover

    在動力學模型的基礎上，根據滑轉率和附著系數的關系，本文對月球車進行了動力學模擬，展示固定轉矩和固定滑轉率兩種情況下的動力學特點，得出了滑轉率影響到車輛驅動性能的結論。
  8. The characters of bank - to - turn control technology determine that the btt missile ' s mathematical model having kinematical coupling, aero dynamical coupling, inertial coupling and control coupling. so the widely used stt missile ' s autopilot, which is designed to be three - channel independent ca n ' t meet the btt missile ' s control need

    Btt控制技術的控制特點決定了btt導彈的數學模型存在運動學耦合、氣動耦合、慣性耦合和控制耦合等多種耦合因素，因此目前側滑轉彎（ stt ）導彈廣泛採用的自動駕駛儀三通道獨立設計方法已不能滿足btt導彈控制系統的設計要求。
  9. From the point of view of having smooth torque and better emc for electric propulsion application, the current source supply is preferred

    從獲得平滑轉矩和良好的emc的觀點出發，船舶永磁推進電機採用電流源控制方式比較合適。
  10. The delta operator enables a smooth transition of the sampled data to their continuous - time counterparts as a unified method of the continuous - time system and discrete - time system

    Delta運算元作為連續系統和離散系統描述的統一方法，可以適當地改善這些缺陷，實現了從離散到連續的光滑轉變。
  11. On the base of stability analysis we get all the parameter used in wheel slip and velocity control and select a group of them work well. all of this can be

    本文在穩定性分析的基礎上得出控制滑轉率和速度的各類參數范圍，選出了有良好特性的控制參數，並進行了模擬驗證。
  12. Based on the further study of dynamic characteristic of the tractor - implement combination, according to the integrated control model, which including the flowing three parameters : the engine load rate, drive wheel slip and work resistance, and the three control strategies, which are : highest production efficiency control strategy, oil consume economic control strategy and give attention to the above control strategy, we can adopt different control strategies according to different purpose of the task. applying the theory of the hybrid dynamic system to this case, the three control strategies can be abstracted to three discrete matters, and then the exchange model of the discrete matters of the top layer ( which called manage layer ) of the tractor - implement combination and the function decision model, which based on the nerve network, can be established. through this way, the best ad aptive controlling of the tractor came true

    本文研究了拖拉機機組的綜合控制問題及其最佳匹配方法，在深入研究機組動態特性的基礎上，根據發動機負荷率、驅動輪滑轉率和作業阻力三參數的綜合綜合控制模型以及三種綜合控制策略（最高生產效率的控制策略、燃油經濟性的控制策略和兼顧最高生產效率及燃油經濟性的控制策略） ，針對不同的作業目的，採用不同的控制策略，應用混雜動態系統理論，把三種控制策略抽象為三種離散事件，建立了拖拉機機組上層（管理層）離散事件切換模型，並建立了基於神經網路的功能決策層模型，從而實現了拖拉機機組的整機最優控制。
  13. Acceleration scuff : friction marks that occur when the tires on the drive wheels of the vehicle are turning faster than they would normally turn, given the speed of the vehicle

    加速度滑轉：當車輪轉動速度大於車輪正常轉速時，驅動輪胎留在路面上的磨擦痕跡。
  14. On the base of thoroughly studying dynamic characteristic of tractor - implement combination, a control project of three parameters was put forward in the paper. the three parameters were engine load rate, drive wheel slip and work resistance. an integrated control model based on three parameters was established, which reflects colligated dynamic character of the unit

    拖拉機作業機組中，很多參數存在著耦合作用，給綜合控制帶來一定的難度，本文在深入研究機組動態特性的基礎上，提出了發動機負荷率、驅動輪滑轉率和作業阻力三參數的綜合控制方案，它反映了機組的綜合動態特徵，並建立了基於這三參數的綜合控制模型。
  15. Asr focuses on avoiding driven wheels " skidding to attain good directional stability and speedup capability through traction control in the course of vehicle acce leration or startup

    Asr著眼于在驅動過程中通過牽引力控制來防止驅動車輪發生滑轉，獲得良好的加速性能和行駛方向穩定性。
  16. Repellents used in vector insects control

    型帶有防滑轉控制
  17. This method can avoid tire slip effectively, and hence improve the driving stability of the vehicle

    該方法能夠有效防止輪胎滑轉，提高車輛行駛穩定性。
  18. Frontside 1 80 power slide. - that ' s it, t. a

    在場地前面有力的180度滑轉-就是這樣， ta
  19. - frontside 1 80 power slide. - that ' s it, t. a

    -在場地前面有力的180度滑轉-就是這樣， ta
  20. The condition regarding transformation from creep into intensive sliding of reservoir landslide has been elaborated taking the examples of landslide taken place in wayiong reservoir and jepachi reservoir into consideration, while the landslide of lijiaxia hydropower station has no such condition

    結合瓦依昂、界帕齊等水庫滑坡實例，論證水庫滑坡從蠕滑轉入劇滑的條件，而李家峽壩前滑坡則不具備這種條件。
分享友人
分享到 Line

分享到臉書